Rupture process of a multiple main shock sequence: analysis of teleseismic, local and field observations of the Tennant Creek, Australia, earthquakes of January 22, 1988

Abstract

On January 22, 1988, three large intraplate earthquakes (with M S 6.3, 6.4, and 6.7) occurred within a 12-hour period near Tennant Creek, Australia. These earthquakes, which occurred over a small interval of time and within a small volume of space, present a unique opportunity to study the rupture process of the class of intraplate earthquakes that occur as multiple main shocks. Broadband displacement and velocity records of body waves from teleseismically recorded data are analyzed to determine source mechanisms, depths, and complexity of rupture of each of the three main shocks. Hypocenters of an additional 150 foreshocks and aftershocks constrained by local arrival time data and field observations of surface rupture are used to complement the source characteristics of the main shocks in order to derive as complete a description of the rupture process as possible. The interpretation of the combined data sets suggests that the overall rupture process involved unusually complicated stress release. As locations of the main shock hypocenters progressively moved from west to east, we infer that the first and third main shocks, denoted as MS 1 and MS 3 , produced the southeast-northwest trending scarps observed at the western end (the Kunayungku fault) and at the eastern end (the east end of the Lake Surprise fault), respectively, of the rupture zone. The epicenter of the only immediate foreshock was located in the gap between these two fault scarps. MS 1 nucleated near this epicenter and ruptured upward and to the northwest from a depth of 6.5 km. MS 3 ruptured predominantly to the SE at a depth of 4.5 km. The second main shock, MS 2 , is inferred to have produced the deformation of the southwest trending central scarp segment (the western end of the Lake Surprise fault). From the sense of thrusting seen at the surface and from the distribution of aftershock hypocenters, the south dipping nodal planes derived from waveform modeling are identified as the fault planes for earthquakes MS1 and MS 3 . In contrast, the dip of the central fault scarp is reversed relative to the dips of the western and eastern fault scarps. The rupture process Of MS 2 turns out to be commensurately complex and sufficiently explains the geological complexity. MS 2 consisted of three subevents. The southeast dipping nodal plane of the first two subevents is coplanar with a southeast dipping plane implied by locations of aftershocks which did not break the surface. Choice of the north dipping plane as the rupture plane of the third subevent, consistent with the surface deformation and coplanar with a second plane delineated by aftershocks, would imply conjugate faulting. The majority of the aftershocks are concentrated near the edges of the fault planes, and there is an absence of activity in the center of the planes. The areas of absent activity may represent the failed asperities of the main shocks in which substantial stress relief occurred. The rupture process of each main shock is characterized by the rapid release of energy followed by a much slower release of moment and by aftershock zones whose dimensions exceed the inferred dimensions of the rupture. These characteristics suggest that substantial slow slip occurred on each of the three fault interfaces that was not accompanied by major energy release. The first main shock nucleated at the deepest part of its aftershock zone and ruptured upward. In contrast, MS 2 and MS 3 nucleated at depths that were one third to one half of the maximum depth of their aftershock zones. This variation of focal depth and the strong increase of moment and radiated energy with each main shock imply that lateral variations of strength were more important than vertical gradients of shear stress in controlling the progression of rupture.