Variation of depth to the brittle-ductile transition due to cooling of a midcrustal intrusion

M. E. Gettings

doi:10.1029/gl015i003p00213

Home/Archive/USGS

USGS · 70014764

Variation of depth to the brittle-ductile transition due to cooling of a midcrustal intrusion

M. E. Gettings

View original source ↗Export metadata ↓

Abstract

The depth to the brittle-ductile transition in the crust is often defined by the intersection of a shear resistance relation in the brittle upper crust that increases linearly with depth and a power law relation for ductile flow in the lower crust that depends strongly on temperature. Transient variation of this depth caused by a magmatic intrusion at a depth near the regional transition can be modeled by a heat conduction model for a rectangular parallelepiped superimposed on a linear geothermal gradient. When parameters appropriate for the southeastern United States are used, a moderate-sized intrusion is found to decrease the transition depth by as much as 7 km; significant variations last about 10 m.y. Since the base of the seismogenic zone is identified with the brittle-ductile transition and since significant depth variations provide loci for strain energy concentration, these results imply that intrusions of late Tertiary age or younger could be important sources of clustered seismicity.

Explore related subjects

Geophysical Research Letters Article

Keep this discovery

Explore connections, maps & timelines

BibTeX RIS

M. E. Gettings. 2012-12-07. Variation of depth to the brittle-ductile transition due to cooling of a midcrustal intrusion. https://doi.org/10.1029/gl015i003p00213

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS2026

Evolution of summit magma pressure during the 2018 caldera collapse at Kılauea volcano

We utilized geodetic data from the 16 May to 4 August 2018 caldera collapse sequence to refine the geometries and pressure evolution of two summit reservoirs at Kīlauea volcano: the shallower Halema‘uma‘u (HMM) and deeper South Caldera (SC) reservoirs. We modeled magma reservoirs as pressurized spheroidal cavities and constrained reservoir geometries with Global Positioning System (GPS) and Interferometric Synthetic Aperture Radar displacements. Inverting high-rate GPS and borehole tilt time series recovered time-dependent reservoir pressure changes and caldera ring fault shear stress. During the collapse sequence, the HMM reservoir accommodated episodic, co-collapse pressure increases of 1.9 MPa (median) and a net 5.8 MPa (median) decrease. Simultaneously, the SC reservoir underwent monotonic depressurization of 6.7 MPa (median). Negligible co-collapse pressure changes in the SC reservoir imply it was not exclusively supplying magma to the eruption vent. These results provide a coherent view of magma reservoir pressure evolution during the 2018 eruption.

Hawaii↗

USGS2026

EMIT reveals elevated calcite signatures in shorelines of Lake Powell and Lake Mead exposed by drought and Colorado River management

Nearly half of Earth’s seasonal freshwater storage variability occurs in human-managed reservoirs, resulting in large areas of reservoir-bed that are episodically inundated or subaerially exposed. Here we use hyperspectral data from NASA’s Earth Surface Mineral Dust Source Investigation (EMIT) mission to map calcite mineral assemblages across exposed surfaces in two large U.S. reservoirs, Lake Mead and Lake Powell. Results show distinct patterns in the occurrence of carbonate, clay, and mica minerals. Reservoir-deposited sediments exhibited significantly higher calcite proportions than adjacent, lithologically similar, non-inundated terrestrial surfaces. These differences likely reflect hydrologically-driven calcite precipitation, wherein warm, clear, productive reservoir waters drive calcium carbonate out of solution. We also detect reductions in calcite proportions in areas of the shoreline disturbed by human recreation. EMIT's imaging capabilities enable rapid, high-resolution mineralogical inventories across vast areas where field sampling is infeasible. We find EMIT is a scalable tool for monitoring geochemical changes associated with large water level fluctuations.

Arizona, Nevada, Utah↗

USGS2026

First application of a coastal-dune model (AeoLiS) to simulate fluvial-aeolian morphodynamics

Quantifying aeolian processes is important to decision-making in river management and for optimizing strategies for ecosystem conservation, natural resource management, and recreation. We applied the AeoLiS aeolian transport model, originally developed for coastal environments, to a dryland river corridor to evaluate its ability to simulate sediment dynamics in a fluvial-aeolian system. The model reproduced spatial and temporal patterns of geomorphic change at a Grand Canyon sandbar, including aeolian dune formation, observed in field data. The model effectively captured trends in observed sediment movement in the spring and summer months. Thus, despite assuming a single grain-size, static vegetation, and not directly accounting for variable sediment supply from fluvial sources, the model performs well at capturing aeolian processes in a complex fluvial-aeolian system. AeoLiS demonstrates strong potential for dryland river applications and management, due to its flexibility and compatibility with coupled modeling frameworks.

Arizona↗