Stress orientation determined from fault slip data in Hampel Wash area, Nevada, and its relation to contemporary regional stress field

V. A. Frizzell; M.L. Zoback

doi:10.1029/tc006i002p00089

Home/Archive/USGS

USGS · 70014752

Stress orientation determined from fault slip data in Hampel Wash area, Nevada, and its relation to contemporary regional stress field

V. A. Frizzell·M.L. Zoback

View original source ↗Export metadata ↓

Abstract

Fault-slip data were collected from an area of relatively young faulting in a seismically active part of the Nevada Test Site 12 km NW of Mercury, Nevada. The data come primarily from intensely faulted Miocene tuffaceous sedimentary rocks in Hampel Wash, which is bounded on the north by the Quaternary ENE trending Rock Valley fault and on the south by a parallel unnamed fault. Data from faults with known sense of displacement exhibit a bimodal distribution of slip angles (rakes). Faults exhibiting steep rakes (typically 75° to 90°) cluster about a N30°–35°E strike; most dip 65° to 80°. Faults having shallow rakes (generally less than 20°) exhibit a wide range of strikes (from N6°W to N80°E) and mostly dip between 80° and 90°. The predominant N30°–35°E strike of the steep-rake faults and the quasi-conjugate nature of a consistent subset of the shallowrake faults suggest a maximum horizontal stress orientation of about N30°–35°E and a least horizontal principal stress direction of N55°–60°W. Analysis of the data using a least squares iterative inversion to determine a mean deviatoric principal stress tensor indicates a normal-faulting stress regime (S 1 vertical) with principal stress axes in approximately horizontal and vertical directions (S 1 , trend = N 19°E and plunge = 82°N; S 2 , N30°E and 8°S; and S 3 , N60°W and 2°E). The maximum horizontal stress, S 2 , was found to be nearly intermediate in magnitude between S 1 and S 3 . The N60°W least horizontal principal stress orientation obtained from the fault-slip inversion agrees with our geometric analysis of the data and is consistent with a modern least horizontal principal stress orientation of N50°–70°W inferred from earthquake focal mechanisms, well bore breakouts, and hydraulic fracturing measurements in the vicinity of the Nevada Test Site. This solution fits all the data well, except for a subset of strike-slip faults that strike N30°–45°E, subparallel to the normal faults of the data set. Nearly pure dip-slip and pure strike-slip movement on similarly oriented faults, however, cannot be accommodated in a single stress regime. Superposed sets of striae observed on some faults suggest temporal rotations of the regional stress field or local rotations within the region of the fault zone.

Explore related subjects

Tectonics Article

Source-reported bounding extent: 35.934968337002616° to 37.34547735717791° latitude; -116.41380395515019° to -114.73066822180856° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeX RIS

V. A. Frizzell, M.L. Zoback. 2010-07-26. Stress orientation determined from fault slip data in Hampel Wash area, Nevada, and its relation to contemporary regional stress field. https://doi.org/10.1029/tc006i002p00089

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS2026

Ductile and brittle Rio Grande Rift deformation in Oligocene granite records a two-stage rift history in southern Colorado

The timing and nature of early deformation in the Rio Grande Rift remains poorly constrained. We present evidence for the earliest structural signature of rift extension in the Sangre de Cristo Range, southern Colorado, based on new geologic mapping, structural analysis, rock magnetic data, and thermochronology. These analyses focus on the ~30.0 Ma granite of Chokecherry Canyon, which hosts discrete low-angle mylonitic shear zones and a distributed, gently SW-dipping protomylonitic fabric. Incremental stretching axes, stretching lineations, and Kmax magnetic lineations plunge gently WSW. Quartz microstructures and crystallographic orientations indicate dominantly coaxial strain in the protomylonite and general shear in the discrete shear zones. Quartz c-axis opening-angle thermometry suggests deformation at ~420–540°C. Thermal modeling of ⁴⁰Ar/³⁹Ar K-feldspar data indicates rapid post magmatic cooling below the brittle–plastic transition, supporting shear-zone formation immediately after emplacement. Slow cooling from ~20–13 Ma was followed by renewed rapid cooling at ~13 Ma, interpreted as the onset of extensional exhumation along the Sangre de Cristo Fault System. These results show that extension in the northern Rio Grande Rift was active by ~30 Ma, earlier than previously recognized. We propose a two-stage model for northern Rio Grande Rift evolution: Stage I (30–23 Ma) records ENE–WSW extension localized in low-angle mylonitic shear zones associated with mid-crustal intrusions; Stage II (≤18 Ma) reflects brittle high-angle normal faulting, focused exhumation, and rift narrowing. Stage I magmatism and deformation along the western range front likely established crustal weaknesses that guided later fault development.

Colorado↗

USGS2026

Exhumation history of the Sangre de Cristo Range, Colorado, from mid- to low-temperature thermochronology: New insights into Laramide contraction and Oligocene–Miocene extension in the northern Rio Grande rift, USA

The Sangre de Cristo Range in southern Colorado records a complex tectonic history that includes Late Cretaceous–Eocene Laramide contraction and Oligocene–Quaternary Rio Grande rift extension. We present new thermochronologic data ( 40 Ar/ 39 Ar, fission-track, (U-Th)/He) and thermal history models that provide insight into this polyphase history and spatiotemporal patterns of extensional exhumation. Our data indicate that the Alvarado fault, which bounds the northeastern flank of the range, initiated as a NE-dipping reverse fault during the early stages of the Laramide orogeny and was subsequently reactivated as a normal fault in the early Miocene. The onset timing of rapid cooling associated with extensional exhumation systematically youngs southwestward across the range from 20–16 Ma along the northeastern flank, 18–14 Ma near the range crest, and 14–10 Ma along the southwestern flank. We attribute this exhumation pattern to earlier onset of normal slip on the Alvarado fault, with extension shifting to the SW-dipping Sangre de Cristo fault system along the southwestern flank of the range and adjacent San Luis Basin at 14–10 Ma. The southwestern flank of the range was exhumed from temperatures of ∼240 ± 25°C at the onset of Miocene rapid cooling, consistent with ∼7–9 km of displacement across the Sangre de Cristo fault system. Thermal history models indicate limited cooling between the Oligocene inception of rift extension and the Miocene onset of rapid cooling, suggesting that development of rift flank topography and adjacent extensional basins was primarily associated with Miocene normal faulting.

Colorado↗

USGS2026

The geologic history of the Chehalis Forearc Basin, Washington State, USA

The Chehalis basin is located between the Cascade arc and the Coast Range in southwest Washington State. It consists of sedimentary and volcanic rocks deposited throughout the Cenozoic and is underlain by the Siletzia terrane, a thick, large igneous province accreted in the Eocene. Here, we constrain evolution of the Chehalis basin depocenter using isochore maps derived from isostatic gravity anomalies, borehole data, and stratigraphy for several time periods: the Eocene (47.6–36.8 Ma), the Oligocene (36.8–20 Ma), and the Neogene (20–0 Ma). Our results suggest that local subsidence is driven by deformation on faults that bound and intersect the basin. We see northward depocenter migration, interpreted as a shift in deformation from the northwest striking Cedar Creek fault to the west striking Doty fault. We interpret these data in terms of the long-term north-south shortening and clockwise rotation of the Cascadia forearc. During the Eocene, the Cedar Creek fault was preferentially aligned with north-south shortening, but became less active when clockwise rotation brought the Doty fault into east-west alignment with the stress field. Sediment accumulation rates decreased from 196 m/Myr in the Paleogene (∼40–20 Ma) to 27 m/Myr in the Neogene (∼20–0 Ma) as Miocene uplift of the Coast Range limited accommodation space and shifted the depositional environment from marine to fluvial. Our results are consistent with the geologic evolution of the Portland and Tualatin basins to the south and reveal a depositional and structural history uniquely shaped by clockwise rotation of the Cascadia forearc.

Washington↗