Geology ReportsSearch

USGS · 70013903

Instability model for recurring large and great earthquakes in southern California

Abstract

The locked section of the San Andreas fault in southern California has experienced a number of large and great earthquakes in the past, and thus is expected to have more in the future. To estimate the location, time, and slip of the next few earthquakes, an earthquake instability model is formulated. The model is similar to one recently developed for moderate earthquakes on the San Andreas fault near Parkfield, California. In both models, unstable faulting (the earthquake analog) is caused by failure of all or part of a patch of brittle, strain-softening fault zone. In the present model the patch extends downward from the ground surface to about 12 km depth, and extends 500 km along strike from Parkfield to the Salton Sea. The variation of patch strength along strike is adjusted by trial until the computed sequence of instabilities matches the sequence of large and great earthquakes since a.d. 1080 reported by Sieh and others. The last earthquake was the M=8.3 Ft. Tejon event in 1857. The resulting strength variation has five contiguous sections of alternately low and high strength. From north to south, the approximate locations of the sections are: (1) Parkfield to Bitterwater Valley, (2) Bitterwater Valley to Lake Hughes, (3) Lake Hughes to San Bernardino, (4) San Bernardino to Palm Springs, and (5) Palm Springs to the Salton Sea. Sections 1, 3, and 5 have strengths between 53 and 88 bars; sections 2 and 4 have strengths between 164 and 193 bars. Patch section ends and unstable rupture ends usually coincide, although one or more adjacent patch sections may fail unstably at once. The model predicts that the next sections of the fault to slip unstably will be 1, 3, and 5; the order and dates depend on the assumed length of an earthquake rupture in about 1700. ?? 1985 Birkha??user Verlag.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

W.D. Stuart. 1985. Instability model for recurring large and great earthquakes in southern California. https://doi.org/10.1007/bf00876385

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Introduction to “Global tsunami science: Past and future, Volume I”

Twenty-five papers on the study of tsunamis are included in Volume I of the PAGEOPH topical issue “Global Tsunami Science: Past and Future”. Six papers examine various aspects of tsunami probability and uncertainty analysis related to hazard assessment. Three papers relate to deterministic hazard and risk assessment. Five more papers present new methods for tsunami warning and detection. Six papers describe new methods for modeling tsunami hydrodynamics. Two papers investigate tsunamis generated by non-seismic sources: landslides and meteorological disturbances. The final three papers describe important case studies of recent and historical events. Collectively, this volume highlights contemporary trends in global tsunami research, both fundamental and applied toward hazard assessment and mitigation.

Pure and Applied Geophysics PAGEOPH

Implications of Coulomb plasticity for the velocity dependence of experimental faults

Simulated fault gouges often deform more stably than initially bare surfaces of the same composition. It is important to understand why the sliding stability is enhanced because the presence of gouge on natural faults may have the same effect as seen in experiments, and thus explain the absence of earthquakes at shallow depths. Gouge stabilization in experiments has been attributed to positive contributions to velocity dependence within gouge layers from either dilation (Maroneet al., 1990) or grain fracture (Biegelet al., 1989). In this study we test the hypothesis that some aspects of gouge and initially bare surface velocity dependence are identical by measuring the time-dependent constitutive parameter b. An important result follows however from stress analysis: if both sample configurations are frictional in the Mohr-Coulomb sense, each configuration is required to deform on planes of distinctly different orientation. The measured strength and velocity dependence will reflect this geometric difference. Our observed values of b for simulated granite and quartz gouge are two to two and a half times smaller than b for initially bare surfaces. This difference is completely accounted for if gouge is represented as a cohesionless-Coulomb plastic material. The analysis demonstrates the following points: 1) gouge deformation is fully consistent with Coulomb plasticity, 2) observed gouge velocity dependence is a function of observed strength and 3) the constitutive parameter b is the same for both bare surfaces and gouge. Furthermore, the results suggest that there is no time-dependent strengthening associated with stabilizing effects in gouge. These observations provide a framework for understanding how slip on initially bare surfaces and gouge deformation are related. ?? 1995 Birkha??user Verlag.

Pure and Applied Geophysics PAGEOPH

The effect of fault-bend folding on seismic velocity in the marginal ridge of accretionary prisms

Fluid venting in accretionary prisms, which feeds chemosynthetic biological communities, occurs mostly on the marginal thrust ridge. New seismic data for the marginal ridge of the Cascadia prism show significantly lower velocity than that in the adjacent oceanic basin and place important constraints on the interpretations of why fluid venting occurs mostly on the marginal ridge. We employed a finite-element method to analyze a typical fault-bend folding model to explain the phenomenon. The fault in the model is simulated by contact elements. The elements are characterized not only by finite sliding along a slide line, but also by elastoplastic deformation. We present the results of a stress analysis which show that the marginal ridge is under subhorizontal extension and the frontal thrust is under compression. This state of stress favors the growth of tensile cracks in the marginal ridge, facilitates fluid flow and reduces seismic velocities therein; on the other hand, it may close fluid pathways along the frontal thrust and divert fluid flow to the marginal ridge. ?? 1995 Birkha??user Verlag.

Pure and Applied Geophysics PAGEOPH