Graphite sample preparation for AMS in a high pressure and temperature press

Meyer Rubin; Bjorn O. Mysen; Henry Polach

doi:10.1016/0168-583x(84)90525-1

Home/Archive/USGS

USGS · 70013867

Graphite sample preparation for AMS in a high pressure and temperature press

Meyer Rubin·Bjorn O. Mysen·Henry Polach

View original source ↗Export metadata ↓

Also available from

USGS — 70009968 ↗

Abstract

A high pressure-temperature press is used to make target material for accelerator mass spectrometry. Graphite was produced from typical **1**4C samples including oxalic acid and carbonates. Beam strength of **1**2C was generally adequate, but random radioactive contamination by **1**4C made age measurements impractical.

Explore related subjects

Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms Article

Keep this discovery

Explore connections, maps & timelines

BibTeX RIS

Meyer Rubin, Bjorn O. Mysen, Henry Polach. 1984. Graphite sample preparation for AMS in a high pressure and temperature press. https://doi.org/10.1016/0168-583x(84)90525-1

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS2025

Measurement of in situ-produced cosmogenic nuclides in fine-grained quartz from shale

In situ -produced 10 Be in quartz is widely used to constrain exposure ages and denudation rates, traditionally measured in sand-sized grains. Here we report a new method for isolating fine-grained quartz from shale and demonstrate its reliability for grain sizes down to single microns. Sequential dissolution tests and analyses of grain size separates show that meteoric 10 Be is eliminated and that recoil losses during cosmogenic nuclide production are balanced by implantation from other mineral grains. High-temperature combustion leads to diffusion of meteoric 10 Be into fine-grained quartz and must be used with caution.

Nuclear Instruments and Methods in Physics Researc↗

USGS2000

Use of chlorine-36 to determine regional-scale aquifer dispersivity, eastern Snake River Plain aquifer, Idaho/USA

Chlorine-36 (36Cl) derived from processed nuclear waste that was disposed at the US Department of Energy's Idaho National Engineering and Environmental Laboratory (INEEL) through a deep injection well in 1958, was detected 24-28 yr later in groundwater monitoring wells approximately 26 km downgradient from the source. Groundwater samples covering the period 1966-1995 were selected from the US Geological Survey's archived-sample library at the INEEL and analyzed for 36Cl by accelerator mass spectrometry (AMS). The smaller 36Cl peak concentrations in water from the far-field monitoring wells relative to the input suggest that aquifer dispersivity may be large. However, the sharpness of the 1958 disposal peak of 36Cl is matched by the measured 36Cl concentrations in water from these wells. This implies that a small aquifer dispersivity may be attributed to preferential groundwater flowpaths. Assuming that tracer arrival times at monitoring wells are controlled by preferential flow, a 1-D system-response model was used to estimate dispersivity by comparing the shape of predicted 36Cl-concentration curves to the shape of 36Cl-concentration curves measured in water from these observation wells. The comparisons suggest that a 1-D dispersivity of 5 m provides the best fit to the tracer data. Previous work using a 2-D equivalent porous-media model concluded that longitudinal dispersivity (equivalent to 1-D dispersivity in our model) was 90 m (Ackerman, 1991). A 90 m dispersivity value eliminates the 1958 disposal peak in our model output curves. The implications of the arrival of 36Cl at downgradient monitoring wells are important for three reasons: (1) the arrival times and associated 36Cl concentrations provide quantitative constraints on residence times, velocities, and dispersivities in the aquifer; (2) they help to refine our working hypotheses of groundwater flow in this aquifer and (3) they may suggest a means of estimating the distribution of preferential flowpaths in the aquifer. ?? 2000 Elsevier Science B.V. All rights reserved.

Nuclear Instruments and Methods in Physics Researc↗

USGS2000

Chlorine-36 and cesium-137 in ice-core samples from mid-latitude glacial sites in the Northern Hemisphere

Chlorine-36 (36Cl) concentrations, 36Cl/Cl ratios, and 36Cl fluxes in ice-core samples collected from the Upper Fremont Glacier (UFG) in the Wind River Mountain Range, Wyoming, United States and the Nangpai Gosum Glacier (NGG) in the Himalayan Mountains, Nepal, were determined and compared with published results from the Dye-3 ice-core drilling site on the Greenland Ice Sheet. Cesium-137 (137Cs) concentrations in the NGG also were determined. The background fluxes for 36Cl for each glacial site were similar: (1.6??0.3)??10-2 atoms/cm2 s for the UFG samples, (0.7??0.1)??10-2 atoms/cm2 s for the NGG samples, and (0.4??0.1)??10-2 atoms/cm2 s for the Dye-3 samples. The 36Cl fluxes in ice that was deposited as snow during peak atmospheric nuclear weapon test (1957-1958) were (33??1)??10-2 atoms/cm2 s for the UFG site, (291??3)??10-2 atoms/cm2 s for the NGG site, and (124??5)??10-2 atoms/ cm2 s for the Dye-3 site. A weapon test period 137Cs concentration of 0.79??0.05 Bq/kg in the NGG ice core also was detected in the same section of ice that contained the largest 36Cl concentration. ?? 2000 Elsevier Science B.V. All rights reserved.

Nuclear Instruments and Methods in Physics Researc↗