Thermal regime of the State 2-14 well, Salton Sea Scientific Drilling Project

Abstract

Temperature logs were made repeatedly during breaks in drilling and both during and after flow tests in the Salton Sea Scientific Drilling Project well (State 2–14). The purpose of these logs was to assist in identifying zones of fluid loss or grain and to characterize reservoir temperatures. At the conclusion of the active phase of the project, a series of logs was begun in an attempt to establish the equilibrium temperature profile. Initially, we were able to log to depths below 3 km, but beginning in late May of 1986, it was impossible to log below about 1.8 km owing to casing failure. Our best estimates of formation temperature below 1.8 km are 305° ± 5°C at 1890 m and 355° ± 10°C at 3170 m. For the upper 1.8 km the latest temperature log (October 24, 1986), using a digital “slickline” (heat-shielded downhole recording) device, was within a few degrees Celsius of equilibrium, as confirmed by a more recent log (July 31, 1987) to a depth of ∼ 1 km. As in most other wells in the Salton Sea geothermal field, there is an impermeable, thermally conductive “cap” on the hydrothermal system; this cap extends to a depth of more than 900 m at the State 2–14 well. Thermal conductivities of 19 samples of drill cuttings from this interval were measured at room temperature. The conductivity values were corrected for in situ porosity as determined from geophysical logs and for the effects of elevated temperature. Thermal gradients decrease from about 250 mK m −1 (same as degrees Celsius per kilometer) in the upper few hundred meters to just below 200 mK m −1 near the base of the conductive cap. Using one interpretation, thermal conductivities increase with depth (mainly because of decreasing porosity), resulting in component heat flows that agree reasonably well with the mean of about 450 m W m −2 . This value agrees well with heat flow data from shallow wells within the Salton Sea geothermal field. A second interpretation, in which measured temperature coefficients of quartz- and carbonate-rich rocks are used to correct thermal conductivity, results in lower mean conductivities that are roughly constant with depth and, consequently, systematically decreasing heat flux averaging about 350 mW m −2 below 300 m. This interpretation is consistent with the inference (from fluid inclusion studies) that the rocks in this part of the field were once several tens of degrees Celsius hotter than they are now. The age of this possible disturbance is estimated at a few thousand years.