Heavy metals and manganese oxides in the genesee watershed, New York state: Effects of geology and land use

P.R. Whitney

doi:10.1016/0375-6742(81)90106-0

Home/Archive/USGS

USGS · 70012040

Heavy metals and manganese oxides in the genesee watershed, New York state: Effects of geology and land use

P.R. Whitney

View original source ↗Export metadata ↓

Abstract

Manganese oxide coatings on gravels from 255 sites on tributary streams in the Genesee River Watershed were analyzed for Mn, Fe, Zn, Cd, Co, Ni, Pb, and Cu. The results were compared with data on bedrock geology, surficial geology and land use, using factor analysis and stepwise multiple regression. All metals except Pb show strong positive correlation with Mn. This association results from the well-known tendency of Mn oxide precipitates to adsorb and incorporate dissolved trace metals. Pb may be present in a separate phase on the gravel surfaces; alternatively Pb abundance may be so strongly influenced by environmental factors that the effect of varying abundance of the carrier phase becomes relatively unimportant. When the effects of varying Mn abundance are allowed for, Pb and to a lesser extent Zn and Cu abundances are seen to be related to commercial, industrial and residential land use. In addition to this pollution effect, all the trace metals, Cd and Ni most strongly, tend to be more abundant in oxide coatings from streams in the forested uplands in the southern part of the area. This probably reflects increased geochemical mobility of the metals in the more acid soils and groundwater of the southern region. A strong Zn anomaly is present in streams draining areas underlain by the Lockport Formation. Oxide coatings in these streams contain up to 5% Zn, originating from disseminated sphalerite in the Lockport and secondary Zn concentrations in the overlying muck soils. The same group of metals, plus calcium and loss on ignition, were determined in the silt and clay (minus 230 mesh) fraction of stream sediments from 129 of the same sites, using a hot nitric acid leach. The amounts of manganese in the sediments are low (average 1020 ppm) and manganese oxides are, at most, of relatively minor significance in the trace-metal geochemistry of these sediments. The bulk of the trace metals in sediment appears to be associated with iron oxides, clays and organic matter.

Explore related subjects

Journal of Geochemical Exploration Article

Source-reported bounding extent: 40.496103° to 45.01585° latitude; -79.761951° to -71.856214° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeX RIS

P.R. Whitney. 1981. Heavy metals and manganese oxides in the genesee watershed, New York state: Effects of geology and land use. https://doi.org/10.1016/0375-6742(81)90106-0

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS2026

Top-down targeted network analysis of critical mineral commodities applied to international geochemistry database

The global demand for critical mineral commodities is rapidly increasing, making domestic production an important factor in supporting the economy and national security. Large scale, publicly available geochemical databases allow for the application of data informatics methods to interrogate critical mineral commodities data for correlations in deposit formation and distribution, particularly for identifying enrichment of multiple critical mineral commodities at the same deposit. In this study, we applied network analysis to the Critical Minerals Mapping Initiative (CMMI) ore geochemistry (Critical Minerals in Ores, CMiO) database to identify the high concentration (defined as 10× bulk crustal abundance) co-occurrence of different critical mineral commodities across a mineral system hierarchy from deposit environments to individual deposits. Identifying patterns or unique outliers in enrichment in network communities will allow for the location of secondary critical mineral commodity resources from under-utilized deposits. We find trends in the enrichment of critical mineral commodities in network-communities between the elements praseodymium (Pr), neodymium (Nd), terbium (Tb), and dysprosium (Dy) across multiple CMiO database deposit environments and groups down to specific deposit types and sites. A separate trend in network community deposition is observed as well between iridium (Ir) and platinum (Pt) in deposit environments, groups, types, and sites. Network analysis focused on critical minerals in magmatic-hydrothermal deposits identified multiple deposit sites from different deposit types within the CMiO database with concentrations of Dy, Nd, Tb, Pr, Ir, and Pt that are at least ten times greater than the crustal average. This approach can be applied to any target element(s) or deposit(s) of interest, allowing broad investigation of co-enriched critical mineral commodities.

Journal of Geochemical Exploration↗

USGS2024

Hyperspectral (VNIR-SWIR) analysis of roll front uranium host rocks and industrial minerals from Karnes and Live Oak Counties, Texas Coastal Plain

VNIR-SWIR (400–2500 nm) reflectance measurements were made on the surfaces of various cores, cuttings and sample splits of sedimentary rocks from the Tertiary Jackson Group, and Catahoula, Oakville and Goliad Formations. These rocks vary in composition and texture from mudstone and claystone to sandstone and are known host rocks for roll front uranium occurrences in Karnes and Live Oak Counties, Texas. Spectral reflectance profiles, 569 in total, were reduced to 125 representative spectral signatures, which were analyzed using the U.S. Geological Survey's (USGS) Material Identification and Characterization Algorithm (MICA). MICA uses an automated continuum-removal procedure together with a least-squares linear regression to determine the fit of observed sample spectral absorption features to those of reference mineral standards in a spectral library. The reference minerals include various clay, mica, carbonate, ferric and ferrous iron minerals and their mixtures. In addition, absorption feature band-depth analysis was done to identify rock surfaces exhibiting absorption features related to uranium and zeolite minerals, which were not included in the command files used to execute MICA. Rocks from each of the four geologic units produced broadly similar spectral signatures as a result of comparable mineral compositions, but there were some notable differences. For example, Ca- and Na-montmorillonite was matched most frequently to the spectral absorption features in 2-μm (∼2000–2500 nm) wavelengths, while goethite occurred often at 1-μm (∼400–1000 nm) wavelengths. The latter is related to limonitic iron-staining in and around oxidized zones of the uranium roll front as described in previous papers. Rocks of the Jackson Group differed from those of the Catahoula, Oakville and Goliad units in that the former exhibited spectral features we interpret as being due to the presence of lignite-bearing mudstone layers. Goliad rocks exhibit spectral features related to dolomite, gypsum, anhydrite, and an unidentified green clay mineral that is possibly glauconite . Jackson Group rocks also exhibit weak but well-resolved absorption features at 964 and 1157 nm related to either or both zeolite minerals clinoptilolite and heulandite. These zeolite minerals and a few spectra exhibiting hydrous silica absorption features are indicative of alteration of volcanic glass in tuffaceous mudstone and claystone layers. A few sample spectra exhibited strong absorption features at around 1135 nm related to the uranium mineral coffinite. Both the 1135 nm coffinite and 1157 nm zeolite absorption features overlap somewhat, potentially making them difficult to distinguish without additional hyperspectral field, laboratory or remote sensing data. The results of this study were compared to mixtures of minerals described for ore, gangue and alteration minerals in deposit models for sandstone-hosted uranium, sedimentary bentonite and sedimentary zeolite. Use of these spectra can help facilitate mapping of both waste materials from the legacy mining of the above commodities, as well as future exploration and resource assessment activities.

Texas↗

USGS2024

Hyperspectral mapping of magmatic-hydrothermal sericite, Battle Mountain mining district, Nevada

We demonstrate the utility of multi-scale imaging spectroscopy data (hyperspectral data) to differentiate magmatic-hydrothermal sericite from other white micas based on grain size, in a case study of the Battle Mountain mining district in Humboldt and Lander Counties, Nevada. The Battle Mountain mining district contains porphyry, skarn, and distal disseminated deposits that formed in magmatic-hydrothermal systems, as well as sedimentary-rock hosted gold deposits of less certain origin. We generated spectral-based mineral maps of the Battle Mountain mining district to examine the spatial distribution of spectrally dominant minerals such as kaolinite, montmorillonite , and white micas (muscovite, sericite, and illite). We then used spectral-based mineral mapping to characterize the grain size and composition of white micas, enabling us to differentiate igneous muscovite from magmatic-hydrothermal sericite. By integrating our spectral-based maps with geologic mapping, airborne aeromagnetic data, and prior studies on mines and deposits in Battle Mountain, we determined that finer grained, higher Al sericite spatially correlated with the footprints of known magmatic-hydrothermal systems and is interpreted as forming from magmatic-hydrothermal alteration. Larger grained, lower Al muscovites are distal from known magmatic-hydrothermal systems and are interpreted as being igneous derived siliciclastic sediments that became constituents of the host sedimentary rocks. Techniques described in this contribution can be applied to any appropriate hyperspectral data, regardless of sensor type used to collect the data.

Nevada↗