Geology Reports⌕ Search

USGS · 70011782

Measurements of storm-generated bottom stresses on the continental shelf

Abstract

Large values of bottom friction velocity, u *, and roughness length, z 0 , determined from burst-averaged speed data taken on the continental shelf in outer Norton Sound, Alaska, with the GEOPROBE tripod during a storm in September 1977 are correlated with extremely large values of near-bottom concentration of total suspended particulate matter (TSM). Combined wind-driven and tidal currents exceeding 30 cm/s at 1 m above the bottom and intense oscillatory bottom currents with maxima above 45 cm/s were associated with the largest measured values of TSM at 2 m above the sea floor. The values of u * and z 0 obtained from the ‘law of the wall’ velocity-depth relationship are diminished substantially throughout the storm period (average reduction of 44%) when the turbulence reducing effects of the vertical concentration gradient of TSM are considered. The form of the latter correction was adapted from Smith and McLean (1977 a ). Values of the mean u * computed from the theory of Grant and Madsen (1979), which predicts an enhanced shear stress due to nonlinear wave-current interactions, compare favorably with the u * values determined from the measured velocity profiles. The measured values of z 0 , however, are considerably larger than any of the estimates based on (1) the actual scales of the physical roughness elements; (2) the apparent roughness of Grant and Madsen (1979); or (3) the thickness of the bed-load layer as formulated by Smith and McLean (1977 a ).

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

D.A. Cacchione, D.E. Drake. 2012-09-20. Measurements of storm-generated bottom stresses on the continental shelf. https://doi.org/10.1029/jc087ic03p01952

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Hydrate formation on marine seep bubbles and the implications for water column methane dissolution

Methane released from seafloor seeps contributes to a number of benthic, water column, and atmospheric processes. At seafloor seeps within the methane hydrate stability zone, crystalline gas hydrate shells can form on methane bubbles while the bubbles are still in contact with the seafloor or as the bubbles begin ascending through the water column. These shells reduce methane dissolution rates, allowing hydrate-coated bubbles to deliver methane to shallower depths in the water column than hydrate-free bubbles. Here, we analyze seafloor videos from six deepwater seep sites associated with a diverse range of bubble-release processes involving hydrate formation. Bubbles that grow rapidly are often hydrate-free when released from the seafloor. As bubble growth slows and seafloor residence time increases, a hydrate coating can form on the bubble's gas-water interface, fully coating most bubbles within ∼10 s of the onset of hydrate formation at the seafloor. This finding agrees with water-column observations that most bubbles become hydrate-coated after their initial ∼150 cm of rise, which takes about 10 s. Whether a bubble is coated or not at the seafloor affects how much methane a bubble contains and how quickly that methane dissolves during the bubble's rise through the water column. A simplified model shows that, after rising 150 cm above the seafloor, a bubble that grew a hydrate shell before releasing from the seafloor will have ∼5% more methane than a bubble of initial equal volume that did not grow a hydrate shell after it traveled to the same height.

Journal of Geophysical Research - Oceans↗

Water-soluble material on aerosols collected within volcanic eruption clouds

In February and March of 1978, filter samplers mounted on an aircraft were used to collect the aerosol fraction of the eruption clouds from three active Guatemalan volcanoes (Fuego, Pacaya, and Santiaguito). The samples were collected on Teflon (Fluoropore) filters with a nominal pore diameter of 0.5μm. The mass of air sampled by the filters ranged from 0.15 to 6.6 kg. The particulate material collected consisted of fragments of angular silicate ash and droplets of what is interpreted as dilute H 2 SO 4 and HCl. After collection of the samples, each filter was rinsed with 60 ml of distilled-deionized water. Splits of each extract were centrifuged to remove particles greater than or equal to 0.1 μm in diameter, acidified, and analyzed for B, Ba, Be, Ca, Cd, Co, Cu, Fe, Li, Mg, Mn, Mo, Na, Pb, Si, Sr, V, and Zn by inductively coupled plasma—optical emission spectroscopy. Separate splits were analyzed for F and Cl by specific-ion-electrode methods and for U by a fission track technique. The elements dissolved in the aqueous extracts represent components of water-soluble material either formed directly in the eruption cloud or derived from interaction of ash particles and aerosol components of the plume. Calculations of enrichment factors, based upon concentration ratios, showed the elements most enriched in the extracts relative to bulk ash composition were Cd, Cu, V, F, Cl, Zn, and Pb. These elements represent a subset (with the addition of Cl and F) of elements previously reported enriched in atmospheric aerosols in remote regions as well as in volcanic areas. This suggests that some of the enriched elements were widely dispersed as volatile halides emitted from a volcanic source.

Journal of Geophysical Research - Oceans↗

Seasat synthetic aperture radar ( SAR) response to lowland vegetation types in eastern Maryland and Virginia

Examination of SEASAT SAR images of eastern Maryland and Virginia reveals botanical distinctions between vegetated lowland areas and adjacent upland areas. Radar returns from the lowland areas can be either brighter or darker than returns from the upland forests. Scattering models and scatterometer measurements predict an increase of 6 dB in backscatter from vegetation over standing water. This agrees with the SCWigital number (DN) increase observed in the digital SEASAT data. The brightest areas in the Chickahominy, Virginia, drainage, containing P. virginica about 0.4 m high, contrast with the brightest areas in the Blackwater, Maryland, marshes, which contain mature loblolly pine in standing water. The darkest vegetated area in the Chickahominy drainage contains a forest of Nyssa aquatica (water tupelo) about 18 m high, while the darkest vegetated area in the Blackwater marshes contains the marsh plant Spartina alterniflora, 0.3 m high. The density, morphology, and relative geometry of the lowland vegetation with respect to standing water can all affect the strength of the return L band signal.

Journal of Geophysical Research - Oceans↗