Geology ReportsSearch

USGS · 70001684

History of the geomagnetic field

Abstract

Direct measurements of the direction and strength of the earth's magnetic field have provided a knowledge of the field's form and behavior during the last few hundreds of years. For older times, however, it has been necessary to measure the magnetism of certain rocks to learn what the geomagnetic field was like. For example, when a lava flow solidifies (at temperatures near 1000°C) and cools through the Curie point of the magnetic minerals contained in it (around 500°C) it acquires a remanent magnetism that is (1) very weak, (2) very stablel, (3) paralle to the direction of the ambient geomagnetic field, and (4) proportional in intensity to the ambient field. Separating, by various analytical means, this magnetization from other ``unwanted'' magnetizations has allowed paleomagnetists to study the historical and prehistorical behavior of the earth's field. It has been learned, for example, that the strength of the field was almost twice its present value 2000 years ago and that it has often completely reversed its polarity. Paleo‐magnetists have also confirmed that most oceans are, geologically speaking, relatively new features, and that the continents have markedly changed their positions over the surface of the earth.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Richard R. Doell. 1969. History of the geomagnetic field. https://doi.org/10.1063/1.1657800

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Clarification of the Hashin-Shtrikman bounds on the effective elastic moduli of polycrystals with hexagonal, trigonal, and tetragonal symmetries

Bounds on the effective elastic moduli of randomly oriented aggregates of hexagonal, trigonal, and tetragonal crystals are derived using the variational principles of Hashin and Shtrikman. The bounds are considerably narrower than the widely used Voigt and Reuss bounds. The Voigt-Reuss-Hill average lies within the Hashin-Shtrikman bounds in nearly all cases. Previous bounds of Peselnick and Meister are shown to be special cases of the present results.

Journal of Applied Physics

Theory of friction based on brittle fracture

A theory of friction is presented that may be more applicable to geologic materials than the classic Bowden and Tabor theory. In the model, surfaces touch at the peaks of asperities and sliding occurs when the asperities fail by brittle fracture. The coefficient of friction, μ, was calculated from the strength of asperities of certain ideal shapes; for cone‐shaped asperities, μ is about 0.1 and for wedge‐shaped asperities, μ is about 0.15. For actual situations which seem close to the ideal model, observed μ was found to be very close to 0.1, even for materials such as quartz and calcite with widely differing strengths. If surface forces are present, the theory predicts that μ should decrease with load and that it should be higher in a vacuum than in air. In the presence of a fluid film between sliding surfaces, μ should depend on the area of the surfaces in contact. Both effects are observed. The character of wear particles produced during sliding and the way in which μ depends on normal load, roughness, and environment lend further support to the model of friction presented here.

Journal of Applied Physics

Variational method of determining effective moduli of polycrystals with tetragonal symmetry

Variational principles have been applied to aggregates of randomly oriented pure‐phase polycrystals having tetragonal symmetry. The bounds of the effective elastic moduli obtained in this way show a substantial improvement over the bounds obtained by means of the Voigt and Reuss assumptions. The Hill average is found to be a good approximation in most cases when compared to the bounds found from the variational method. The new bounds reduce in their limits to the Voigt and Reuss values.

Journal of Applied Physics