Geology Reports⌕ Search

Geology topics

Research about northern New Jersey

Source-linked reports with geographic coverage including northern New Jersey.

4 recordsLinked to original sources
USGS2006

Tracing the continuity of pleistocene aquifers in northern New Jersey by seismic methods

Seismic refraction measurements were used to draw a new bedrock contour map in Morris County, New Jersey , where the major ground‐water supplies are found in Quaternary sand and gravel deposits filling pre‐ Pleistocene channels. Aquifer performance tests aided in tracing the continuity of the Quaternary aquifers in these channels. In one case, the lack of continuity between two wells substantiated the seismic prediction that two separate channels were involved. The success of the seismic exploration emphasizes the value of using such methods , so that test drilling can be devoted to exploring the more favorable areas for production wells.

New Jersey↗
USGS2003

Geochemistry of the furnace magnetite bed, Franklin, New Jersey, and the relationship between stratiform iron oxide ores and stratiform zinc oxide-silicate ores in the New Jersey highlands

The New Jersey Highlands terrace, which is an exposure of the Middle Proterozoic Grenville orogenic belt located in northeastern United States, contains stratiform zinc oxide-silicate deposits at Franklin and Sterling Hill and numerous massive magnetite deposits. The origins of the zinc and magnetite deposits have rarely been considered together, but a genetic link is suggested by the occurrence of the Furnace magnetite bed and small magnetite lenses immediately beneath the Franklin zinc deposit. The Furnace bed was metamorphosed and deformed along with its enclosing rocks during the Grenvillian orogeny, obscuring the original mineralogy and obliterating the original rock fabrics. The present mineralogy is manganiferous magnetite plus calcite. Trace hydrous silicates, some coexisting with fluorite, have fluorine contents that are among the highest ever observed in natural assemblages. Furnace bed calcite has ??13C values of -5 ?? 1 per mil relative to Peedee belemnite (PDB) and ??18O values of 11 to 20 per mil relative to Vienna-standard mean ocean water (VSMOW). The isotopic compositions do not vary as expected for an original siderite layer that decarbonated during metamorphism, but they are consistent with nearly isochemical metamorphism of an iron oxide + calcite protolith that is chemically and minerlogically similar to iron-rich sediments found near the Red Sea brine pools and isotopically similar to Superior-type banded iron formations. Other magniferous magnite + calcite bodies occur at approximately the same stratigraphic position as far 50 km from the zinc deposits. A model is presented in which the iron and zinc deposits formed along the western edge of a Middle Proterozoic marine basin. Zinc was transported by sulfate-stable brines and was precipitated under sulfate-stable conditions as zincian carbonates and Fe-Mn-Zn oxides and silicates. Whether the zincian assemblages settled from the water column or formed by replacement reactions in shallowly buried sediments is uncertain. The iron deposits formed at interfaces between anoxic and oxygenated waters. The Furnace magnetite bed resulted from seawater oxidation of hydrothermally transported iron near a brine conduit. Iron deposits also formed regionally on the basin floor at the interface betveen anoxic deep waters and oxygenated shallower waters. These deposits include not only manganiferous magnetite + calcite bodies similar to the Furnace magnetite bed but also silicate-facies deposits that formed by iron oxide accumulation where detrital sediment was abundant. A basin margin model can be extended to Grenvillian stratiform deposits in the northwest Adirondacks of New York and the Mont Laurier basin of Quebec. In these areas iron deposits (pyrite or magnetite) are found basinward of marble-hosted sphalerite deposits, such as those in the Balmat-Edwards district. Whether the iron and zinc precipitated as sulfide assemblages or carbonate-oxide-silicate assemblages depended on whether sufficient organic matter or other reductants were available in local sediments or bottom waters to stabilize H2S.

New Jersey↗
USGS1991

Generation of trondhjemite from partial melting of dacite under granulite facies conditions: An example from the New Jersey Highlands, USA

New field and geochemical data place the Losee Metamorphic Suite (a tonalite/trondhjemite complex) of northern New Jersey into the context of a major Proterozoic continental are represented by a discontinuous belt of northern Appalachian metadacite. Samples of Losee rock range from extremely leucocratic trondhjemite locally associated with amphibolite, to banded biotite, hornblende, pyroxene, and garnet-bearing tonalites. The major element and REE composition of the tonalite closely resembles dacite from continental are settings and model melts extracted from an eclogite residue by partial melting at 15 kbar. The REE composition of most Losee trondhjemite is enriched in REE, particularly HREE, compared with Losee tonalite, and is interpreted as the product of local anatectic melting of Losee tonalite (metadacite) that occurred in a granulite facies environment during the Grenville orogeny.

New Jersey↗