Geology Reports⌕ Search

Geology topics

Research about Williamson County, Tennessee

Source-linked reports with geographic coverage including Williamson County, Tennessee.

3 recordsLinked to original sources

Hydrogeology of a hazardous-waste disposal site near Brentwood, Williamson County, Tennessee

Approximately 44,000 gal of industrial solvent wastes were disposed in pits on a farm near Brentwood, Tennessee, in 1978, and contaminants were reported in the soil and shallow groundwater on the site in 1985. In order for the State to evaluate possible remedial-action alternatives, an 18-month study was conducted to define the hydrogeologic setting of the site and surrounding area. The area is underlain by four hydrogeologic units: (1) an upper aquifer consisting of saturated regolith, Bigby-Cannon Limestone, and weathered Hermitage Formation; (2) the Hermitage confining unit; (3) a lower aquifer consisting of the Carters Limestone; and (4) the Lebanon confining unit. Wells generally are low yielding less than 1 gal/min), although locally the aquifers may yield as much as 80 gal/minute. This lower aquifer is anisotropic, and transmissivity of this aquifer is greatest in a northwest-southeast direction. Recharge to the groundwater system is primarily from precipitation, and estimates of average annual recharge rates range from 6 to 15 inches/year. Discharge from the groundwater system is primarily to the Little Harpeth River and its tributaries. Groundwater flow at the disposal site is mainly to a small topographic depression that drains the site. Geochemical data indicate four distinct water types. These types represent (1) shallow, rapidly circulating groundwater; (2) deeper (> than 100 ft), rapidly circulating groundwater; (3) shallow, slow moving groundwater; and (4) deeper, slow moving groundwater. Results of the numerical model indicate that most flow is in the upper aquifer.

Tennessee↗

Construction, geologic, and water-level data for observation wells near Brentwood, Williamson County, Tennessee

Thirty-four observation wells were installed at 17 sites in the area of a hazardous-waste disposal site near Brentwood, in Williamson County, Tennessee. These wells were installed to supplement data collected from domestic wells in the area, to help define the geology of the study area and to determine the water levels. Both lithologic and geophysical logs were obtained for each well drilled to help define the formations encountered. Four limestone units, corresponding to the Bigby-Cannon limestone, the Hermitage Formation, the Carters Limestone (including the T-3 bentonite), and the Lebanon Limestone, were described from well cuttings and borehole geophysical logs. Water levels have been collected at both the shallow and deep wells at each site.

Tennessee↗

Geology of an area near Brentwood, Williamson County, Tennessee

The lithology and geologic structure of an area near Brentwood, Williamson County, Tennessee, were studied to define the potential aquifers and confining units of the ground-water flow system. Four formations were identified. They are, in descending order, the Bigby-Cannon Limestone, the Hermitage Formation, the Carters Limestone, and the Lebanon Limestone. The Bigby-Cannon Limestone and the Carters Limestone are potential aquifers. The Hermitage Formation and the Lebanon Limestone are confining units. The Bigby-Cannon Limestone and the Hermitage Formation have been affected by recent erosion. Any variation of the Carters Limestone is controlled by pre-Carters erosion of the top of the Lebanon Limestone. The thickness of the Carters Limestone ranges from 65 to 79 feet. Structurally, the area reflects the regional northwest dip. A small scale anti-cline-syncline pair also is evident. This feature is not a result of erosion and also occurs in the T-3 bentonite bed in the Carters Limestone.

Tennessee↗