Geology Reports⌕ Search

Geology topics

Research about Vancouver Island

Source-linked reports with geographic coverage including Vancouver Island.

7 recordsLinked to original sources
USGS2025

Rapid fault healing from cementation controls the dynamics of deep slow slip and tremor

Despite its status as one of the most important discoveries in geophysics, the physical mechanism(s) responsible for slow slip events (SSEs) are not well understood. Here, we synthesize observations of deep SSEs in the Cascadia Subduction Zone and argue that rapid, cohesive fault strengthening may control the dynamics of deep SSEs. Cohesive strength is frequently ignored in constitutive laws used to describe fault rheology in numerical simulations of earthquakes and SSEs alike. To demonstrate its importance, we perform and analyze a suite of petrological experiments that simulate fault healing under representative pressure and temperature conditions. We show that significant cohesive strength recovery caused by dissolution-precipitation processes occurs on timescales of just a few hours. Together, our experimental and observational results support the idea that cohesion is a key component of fault strength under SSE conditions and highlight the need for its inclusion in both future experiments and numerical models of fault slip.

British Columbia, Washington↗
USGS2024

First Occurrence of the nonindigenous Asian foraminifera Ammonia confertitesta in the Northeastern Pacific Ocean: Vancouver Island, British Columbia, Canada

Observations in 2022 of intertidal and subtidal foraminiferal faunas at four localities along the central-eastern side of Vancouver Island, British Columbia, Canada, and molecular analyses have documented the first occurrence of the nonindigenous Asian species Ammonia confertitesta Zheng in the northwestern Pacific Ocean. The species was present at three of these localities: Davis Lagoon south of Ladysmith (4% in the lagoon and 49% on the beach) and 0.6% in Nanaimo Harbor. The vector of introduction is thought to be the release of ballast water and associated sediment. These releases probably occurred in the Port of Vancouver, which were then transported by means of the cyclonic circulation across the Strait of Georgia, or from local anchorages close to the sampling sites. The timing of the introduction is impossible to determine because no stratigraphic record is presently available. However, foraminiferal studies in the late 1980s near the Port of Vancouver that recovered calcareous taxa did not report the presence of this species, nor was it found at 33 sites sampled from 1997 to 1999 throughout the Strait of Georgia.

Vancouver Island↗
USGS2021

Paleoseismic trenching reveals late quaternary kinematics of the Leech River Fault: Implications for forearc strain accumulation in Northern Cascadia

New paleoseismic trenching indicates late Quaternary oblique right‐lateral slip on the Leech River fault, southern Vancouver Island, Canada, and constrains permanent forearc deformation in northern Cascadia. A south‐to‐north reduction in northward Global Navigation Satellite System velocities and seismicity across the Olympic Mountains, Strait of Juan de Fuca (JDF), and the southern Strait of Georgia, has been used as evidence for permanent north–south crustal shortening via thrust faulting between a northward migrating southern forearc and rigid northern backstop in southwestern Canada. However, previous paleoseismic studies indicating late Quaternary oblique right‐lateral slip on west‐northwest‐striking forearc faults north of the Olympic Mountains and in the southern Strait of Georgia are more consistent with forearc deformation models that invoke oroclinal bending and(or) westward extrusion of the Olympic Mountains. To help evaluate strain further north across the Strait of JDF, we present the results from two new paleoseismic trenches excavated across the Leech River fault. In the easternmost Good Hope trench, we document a vertical fault zone and a broad anticline deforming glacial till. Comparison of till clast orientations in faulted and undeformed glacial till shows evidence for postdeposition faulted till clast rotation, indicating strike‐slip shear. The orientation of opening mode fissuring during surface rupture is consistent with right‐lateral slip and the published regional S H max "> S H max SHmax directions. Vertical separation and the formation of scarp‐derived colluvium along one fault also indicate a dip‐slip component. Radiocarbon charcoal dating within offset glacial till and scarp‐derived colluvium suggest a single surface rupturing earthquake at 9.4 ± 3.4    ka "> 9.4 ± 3.4 ka 9.4±3.4 ka ⁠ . The oblique right‐lateral slip sense inferred in the Good Hope trench is consistent with slip kinematics observed on other regional west‐northwest‐striking faults and indicates that these structures do not accommodate significant north–south shortening via thrust faulting.

Washington↗
USGS2019

Two-dimensional seismic velocities and structural variations at three British Columbia Hydro and Power Authority (BC Hydro) dam sites, Vancouver Island, British Columbia, Canada

Summary In June, 2017, we acquired seismic data along five linear profiles at three British Columbia Hydro and Power Authority (BC Hydro, a Canadian provincial Crown Corporation) dam sites (John Hart, Ladore, and Strathcona Dams) on Vancouver Island, British Columbia, Canada. We also attempted to acquire linear seismic profiles at two additional BC Hydro dam sites (Ruskin Dam and Stave Falls Dam) east of the City of Vancouver, British Columbia, Canada; however, due to a seismograph programming error, little active-source data from Ruskin Dam and Stave Falls Dam were recorded. Thus, results from Ruskin Dam and Stave Falls Dam are not included in this report. At the three dam sites with successful data acquisition, we acquired both active- and passive-source data. Data acquisition details for each of the three dam sites varied in terms of seismic sources, the number of seismographs, and profile length and orientation. However, for active-source acquisition at each dam site, we acquired one or more linear seismic profiles ranging in length from about 150 to 400 meters (m), and along each profile, seismograph spacing was either 3 m or 5 m (see appendix 1). All data were recorded in three components (vertical and two horizontals). To greatly increase the resolution of the seismic velocity structure along these profiles, we co-located active sources at each seismograph.

British Columbia↗
USGS2017

Evidence for distributed clockwise rotation of the crust in the northwestern United States from fault geometries and focal mechanisms

Paleomagnetic and GPS data indicate that Washington and Oregon have rotated clockwise for the past 16 Myr. Late Cenozoic and Quaternary fault geometries, seismicity lineaments, and focal mechanisms provide evidence that this rotation is accommodated by north directed thrusting and right-lateral strike-slip faulting in Washington, and SW to W directed normal faulting and right-lateral strike-slip faulting to the east. Several curvilinear NW to NNW trending high-angle strike-slip faults and seismicity lineaments in Washington and NW Oregon define a geologic pole (117.7°W, 47.9°N) of rotation relative to North America. Many faults and focal mechanisms throughout northwestern U.S. and southwestern British Columbia have orientations consistent with this geologic pole as do GPS surface velocities corrected for elastic Cascadia subduction zone coupling. Large Quaternary normal faults radial to the geologic pole, which appear to accommodate crustal rotation via crustal extension, are widespread and can be found along the Lewis and Clark zone in Montana, within the Centennial fault system north of the Snake River Plain in Idaho and Montana, to the west of the Wasatch Front in Utah, and within the northern Basin and Range in Oregon and Nevada. Distributed strike-slip faults are most prominent in western Washington and Oregon and may serve to transfer slip between faults throughout the northwestern U.S.

British Columbia, Oregon, Washington↗
USGS2009

Seismic wave triggering of nonvolcanic tremor, episodic tremor and slip, and earthquakes on Vancouver Island

[1] We explore the physical conditions that enable triggering of nonvolcanic tremor and earthquakes by considering local seismic activity on Vancouver Island, British Columbia during and immediately after the arrival of large-amplitude seismic waves from 30 teleseismic and 17 regional or local earthquakes. We identify tremor triggered by four of the teleseismic earthquakes. The close temporal and spatial proximity of triggered tremor to ambient tremor and aseismic slip indicates that when a fault is close to or undergoing failure, it is particularly susceptible to triggering of further events. The amplitude of the triggering waves also influences the likelihood of triggering both tremor and earthquakes such that large amplitude waves triggered tremor in the absence of detectable aseismic slip or ambient tremor. Tremor and energy radiated from regional/local earthquakes share the same frequency passband so that tremor cannot be identified during these smaller, more frequent events. We confidently identify triggered local earthquakes following only one teleseism, that with the largest amplitude, and four regional or local events that generated vigorous aftershock sequences in their immediate vicinity. Earthquakes tend to be triggered in regions different from tremor and with high ambient seismicity rates. We also note an interesting possible correlation between large teleseismic events and episodic tremor and slip (ETS) episodes, whereby ETS events that are “late” and have built up more stress than normal are susceptible to triggering by the slight nudge of the shaking from a large, distant event, while ETS events that are “early” or “on time” are not.

Vancouver Island↗