Research about Summer Coon volcano

USGS2007

A model for radial dike emplacement in composite cones based on observations from Summer Coon volcano, Colorado, USA

We mapped the geometry of 13 silicic dikes at Summer Coon, an eroded Oligocene stratovolcano in southern Colorado, to investigate various characteristics of radial dike emplacement in composite volcanoes. Exposed dikes are up to about 7 km in length and have numerous offset segments along their upper peripheries. Surprisingly, most dikes at Summer Coon increase in thickness with distance from the center of the volcano. Magma pressure in a dike is expected to lessen away from the pressurized source region, which would encourage a blade-like dike to decrease in thickness with distance from the center of the volcano. We attribute the observed thickness pattern as evidence of a driving pressure gradient, which is caused by decreasing host rock shear modulus and horizontal stress, both due to decreasing emplacement depths beneath the sloping flanks of the volcano. Based on data from Summer Coon, we propose that radial dikes originate at depth below the summit of a host volcano and follow steeply inclined paths towards the surface. Near the interface between volcanic cone and basement, which may represent a neutral buoyancy surface or stress barrier, magma is transported subhorizontally and radially away from the center of the volcano in blade-like dikes. The dikes thicken with increasing radial distance, and offset segments and fingers form along the upper peripheries of the intrusions. Eruptions may occur anywhere along the length of the dikes, but the erupted volume will generally be greater for dike-fed eruptions far from the center of the host volcano owing to the increase in driving pressure with distance from the source. Observed eruptive volumes, vent locations, and vent-area intrusions from inferred post-glacial dike-fed eruptions at Mount Adams, Washington, USA, support the proposed model. Hazards associated with radial dike emplacement are therefore greater for longer dikes that propagate to the outer flanks of a volcano.

Colorado↗

USGS2004

Patterns of magma flow in segmented silicic dikes at Summer Coon volcano, Colorado: AMS and thin section analysis

A complex pattern of magma flow is found in two silicic dikes of a radial swarm at Summer Coon, an eroded stratovolcano in southern Colorado. The two intrusions are broken into multiple segments that suggest vertical dike propagation. However, anisotropy of magnetic susceptibility (AMS) measurements and thin section observations suggest that magma flow was often subhorizontal and away from the center of the volcano. Segments that are proximal to the central intrusion are characterized by magma that flowed steeply upward at the proximal segment extremity, then laterally along the segment, and finally downward at the distal end of the segment. Magma flow in offset segment tips located far from the volcano center was subhorizontal towards the adjacent segment, implying lateral propagation of segment tips towards one another. This observation suggests relatively high driving pressure in distal dike segments, as supported by dike thickening with radial distance from the center of the volcano. The present study indicates that radial dike evolution at stratovolcanoes is dominated by lateral flow of magma and dike segmentation is a poor magma flow indicator. A horizontally propagating radial dike has the potential to cause an eruption low on the flank of a composite cone, which poses a significant yet largely unrecognized hazard to population centers and infrastructure that may surround the volcano.

Colorado↗