Geology ReportsSearch

Geology topics

Research about San Juan Bautista, California

Source-linked reports with geographic coverage including San Juan Bautista, California.

2 recordsLinked to original sources

Short-period strain (0.1–105 s): Near-source strain field for an earthquake (ML 3.2) near San Juan Bautista, California

Measurements of dilational earth strain in the frequency band 25–10 −5 Hz have been made on a deep borehole strainmeter installed near the San Andreas fault. These data are used to determine seismic radiation fields during nuclear explosions, teleseisms, local earthquakes, and ground noise during seismically quiet times. Strains of less than 10 −10 on these instruments can be clearly resolved at short periods (< 10 s) and are recorded with wide dynamic range digital recorders. This permits measurement of the static and dynamic strain variations in the near field of local earthquakes. Noise spectra for earth strain referenced to 1 (strain) 2 /Hz show that strain resolution decreases at about 10 dB per decade of frequency from −150 dB at 10 −4 Hz to −223 dB at 10 Hz. Exact expressions are derived to relate the volumetric strain and displacement field for a homogeneous P wave in a general viscoelastic solid as observed on colocated dilatometers and seismometers. A rare near-field recording of strain and seismic velocity was obtained on May 26, 1984, from an earthquake ( M L 3.2) at a hypocentral distance of 3.2 km near the San Andreas fault at San Juan Bautista, California. While the data indicate no precursory strain release at the 5 × 10 −11 strain level, a coseismic strain release of 1.86 nanostrain was observed. This change in strain is consistent with that calculated from a simple dislocation model of the event. Ground displacement spectra, determined from the downhole strain data and instrument-corrected surface seismic data, suggest that source parameters estimated from surface recordings may be contaminated by amplification effects in near-surface low-velocity materials.

California

Modelling aftershock migration and afterslip of the San Juan Bautista, California, earthquake of October 3, 1972

The San Juan Bautista earthquake of October 3, 1972 ( M L = 4.8), located along the San Andreas fault in central California, initiated an aftershock sequence characterized by a subtle, but perceptible, tendency for aftershocks to spread to the northwest and southeast along the fault zone. The apparent dimension of the aftershock zone along strike increased from about 7–10 km within a few days of the earthquake, to about 20 km eight months later. In addition, the mainshock initiated a period of accelerated fault creep, which was observed at 2 creep meters situated astride the trace of the San Andreas fault within about 15 km of the epicenter of the mainshock. The creep rate gradually returned to the preearthquake rate after about 3 yrs. Both the spreading of the aftershocks and the rapid surface creep are interpreted as reflecting a period of rapid creep in the fault zone representing the readjustment of stress and displacement following the failure of a “stuck” patch or asperity during the San Juan Bautista earthquake. Numerical calculations suggest that the behavior of the fault zone is consistent with that of a material characterized by a viscosity of about 3.6×10 14 P, although the real rheology is likely to be more complicated. In this model, the mainshock represents the failure of an asperity that slips only during earthquakes. Aftershocks represent the failure of second-order asperities which are dragged along by the creeping fault zone.

California