Research about San Andreas Fault System

USGS2026

Cajon Pass and the southern San Andreas Fault System: Earthquake cycle stress accumulation and present-day loading

With over a century since the last major rupture affecting the wider Los Angeles region, tectonic stress has steadily built along the southern San Andreas and San Jacinto fault systems, raising concerns of an imminent large earthquake. Cajon Pass, located at the junction of these faults, represents a critical site for potential through-going ruptures in Southern California. We constructed new 4D earthquake cycle simulations using a 1000-year paleoseismic rupture history of the San Andreas Fault System (SAFS) to assess spatial and temporal variations in stress. A semi-analytic Fourier transform model was used to compute stress from 3D dislocations in an elastic plate overlying a Maxwell viscoelastic half-space, assuming a complete coseismic reset of resolved shear stress on ruptured elements. Results show highest stress accumulation north of Cajon Pass (∼1.8 MPa/100 years) due to greater slip rates, and lower rates south of Cajon Pass (∼1.0–1.5 MPa/100 years). By 2025, Coulomb stress is estimated at 2.8 MPa on the Mojave South (MOS) segment, 1.8 MPa on the North San Bernardino (NSB1) segment and 3.6 MPa on the San Jacinto Bernardino (SJB) segment. Segments accumulate stresses with characteristic ranges of pre-event stress interpreted as failure thresholds: 1.2–2.7 MPa for MOS, 0.4–1.6 MPa for NSB1, and 1.2–2.9 MPa for SJB. When the stress disparity between segments SJB and MOS narrows, the faults appear to rupture jointly, suggesting that stress levels may control how Cajon Pass acts as an earthquake gate. These results may inform seismic hazard assessments by linking stress evolution to fault interactions.

California↗

USGS2013

Chemical controls on fault behavior: weakening of serpentinite sheared against quartz-bearing rocks and its significance for fault creep in the San Andreas system

The serpentinized ultramafic rocks found in many plate-tectonic settings commonly are juxtaposed against crustal rocks along faults, and the chemical contrast between the rock types potentially could influence the mechanical behavior of such faults. To investigate this possibility, we conducted triaxial experiments under hydrothermal conditions (200-350°C), shearing serpentinite gouge between forcing blocks of granite or quartzite. In an ultramafic chemical environment, the coefficient of friction, µ, of lizardite and antigorite serpentinite is 0.5-0.6, and µ increases with increasing temperature over the tested range. However, when either lizardite or antigorite serpentinite is sheared against granite or quartzite, strength is reduced to µ ~ 0.3, with the greatest strength reductions at the highest temperatures (temperature weakening) and slowest shearing rates (velocity strengthening). The weakening is attributed to a solution-transfer process that is promoted by the enhanced solubility of serpentine in pore fluids whose chemistry has been modified by interaction with the quartzose wall rocks. The operation of this process will promote aseismic slip (creep) along serpentinite-bearing crustal faults at otherwise seismogenic depths. During short-term experiments serpentine minerals reprecipitate in low-stress areas, whereas in longer experiments new Mg-rich phyllosilicates crystallize in response to metasomatic exchanges across the serpentinite-crustal rock contact. Long-term shear of serpentinite against crustal rocks will cause the metasomatic mineral assemblages, which may include extremely weak minerals such as saponite or talc, to play an increasingly important role in the mechanical behavior of the fault. Our results may explain the distribution of creep on faults in the San Andreas system.

California↗