EXPLORE THE ARCHIVE

Research about Ridgecrest

Source-linked reports with geographic coverage including Ridgecrest.

3 recordsLinked to original sources

USGS2026

Detecting earthquakes in noisy real-time GNSS data with deep learning for improved PGD magnitude estimation

To disseminate accurate and useful warnings, earthquake early warning (EEW) systems must quickly determine the size and location of an earthquake to estimate expected shaking. Traditional seismic‐based algorithms tend to underestimate the true magnitudes of large earthquakes, a phenomenon known as magnitude saturation. This limitation motivated the recent inclusion of Global Navigation Satellite Systems (GNSS) data into the U.S. Geological Survey’s ShakeAlert EEW system with the Geodetic First Approximation of Size and Time (GFAST) algorithm because GNSS data do not saturate with large ground motions. However, the noise levels of GNSS data are very high compared with traditional seismic data, which obscures P ‐wave arrivals and can result in less accurate magnitude estimations if displacement amplitudes are low, such as for lower magnitude earthquakes or large source–station distances. In this study, we develop a deep‐learning model that detects earthquakes in GNSS data and use the Ridgecrest, California, earthquake sequence as a case study to demonstrate how the model could act as a filter to reduce the amount of low‐quality data that enters an algorithm like GFAST. To preserve our limited real earthquake data for model inference, we generated a training dataset composed of >700,000 synthetic displacement waveforms. We combined the synthetic waveforms with real‐time GNSS noise to produce realistically noisy training waveforms and then tested our model on additional synthetic data and performed inference using the real data that were held back. We discuss the performance of our trained model on both the unseen synthetic data and real inference data. Our model can be used to selectively filter only high‐quality data where an earthquake signal is observed for input into an algorithm like GFAST (outperforming a simple signal‐to‐noise ratio–based filter) to reduce the error in GFAST’s real‐time earthquake magnitude estimations.

California↗

USGS2025

Near-fault amplification and ground motion variability during the 2019 Ridgecrest, California sequence

We estimate ground-motion variability near the 2019 M 7.1 Ridgecrest earthquake sequence. Accurate seismic hazard estimation requires understanding ground-motion spatial correlations, yet many studies lack the dense station coverage needed to resolve small-scale variability. The 2019 M 7.1 Ridgecrest earthquake sequence presents a unique opportunity to examine ground motions and their spatial correlations at a range of interstation distances. The permanent seismic network was augmented with hundreds of temporary stations including several fault-crossing nodal arrays. We compute the event ( δE i ) and within-event ( δW ij ) residuals from the observed peak ground velocity and peak ground acceleration data to isolate potential sources of ground-motion variability. We then compare δW ij between station pairs that record an event to understand the semivariance of the ground motion versus interstation distance. By fitting an exponential model to the semivariances, we determine a correlation range of 25 km for the Ridgecrest region. Although the exponential model fits the broad-scale increase of semivariance with interstation distance, we also observe smaller-scale trends. We find that ground motions are less correlated for station pairs that are near or across faults that ruptured during the 2019 Ridgecrest sequence. We also find large, positive median δW ij with relative values 2–3 times larger than nearby stations for individual stations’ near-fault traces. Near-fault amplification and greater ground-motion variability can delineate fault zones and may locally increase the seismic hazard.

California↗

USGS2025

Mechanics and statistics of postseismic shaking

Analysis of two weeks of continuous post-seismic shaking after the 2019 M7.1 Ridgecrest, CA earthquake sequence using 4 nearby borehole seismometers reveals that continuous ground motions decay as Omori’s law in time and follow the Gutenberg-Richter distribution in logarithmic amplitude. The measured temporal decay in amplitudes agrees with predictions of the rate-and-state framework and indicates shaking amplitudes are proportional to the velocity of afterslip. Our ground motion-based statistical framework provides a basis to forecast shaking intensity in the minutes to hours after a large earthquake.

California↗