Geology topics

Research about Redwell Basin

Source-linked reports with geographic coverage including Redwell Basin.

2 recordsLinked to original sources

USGS2021

Direct observation of the depth of active groundwater circulation in an alpine watershed

The depth of active groundwater circulation is a fundamental control on stream flows and chemistry in mountain watersheds, yet it remains challenging to characterize and is rarely well constrained. We collected hydraulic conductivity, hydraulic head, temperature, chemical, noble gas, and 3 H/ 3 He groundwater age data from discrete levels in two boreholes 46 and 81 m deep in an alpine watershed, in combination with chemical and age data from shallow groundwater discharge, to discern groundwater flow rates at different depths and directly observe active and inactive groundwater. Vertical head gradients are steep (average of 0.4) and thermal profiles are consistent with typical linear conductive continental geotherms. Groundwater deeper than ∼20 m is distinct from shallow groundwater and creek water in its chemistry, noble gas signature, and age (dominantly >65 years compared to <9 years). Together these results suggest low vertical groundwater flow velocities and a relatively shallow active circulation depth of ∼20 m. This hypothesis is tested with a simple 2‐D numerical fluid flow and heat transport model representing a hillslope transect through the two boreholes. The modeling indicates that the subhorizontally bedded sedimentary rocks underlying the basin are highly anisotropic with low vertical hydraulic conductivity, and at most ∼10% of bedrock recharge (equivalent to <2% of stream baseflow) flows below a depth of 20 m. The study demonstrates the considerable value of discrete‐depth hydrogeologic, chemical, and age data for determining active circulation depth, and illustrates an approach for maximizing the utility of individual boreholes drilled for mountain bedrock aquifer characterization.

Colorado↗

USGS2010

Reactive solute-transport simulation of pre-mining metal concentrations in mine-impacted catchments: Redwell Basin, Colorado, USA

With the increased importance of water resources in the western United States and many areas worldwide, the remediation of impacts from historical mining becomes ever more important. A possible process of making decisions about remediation for a catchment might include identification of principal sources of metals in the catchment, classification of the sources as natural or anthropogenic, and simulations to evaluate different options for removal of anthropogenic sources. The application of this process is based on understanding the pre-mining conditions in the catchment, so that remediation goals appropriately correct for the impacts of mining. A field experiment in Redwell Basin, Colorado, provided a setting to demonstrate this process and to evaluate pre-mining concentrations through reactive solute-transport modeling. The field experiment provided spatially detailed stream and inflow samples that were the basis for model calibration. Only two inflows along the study reach were affected by mining or mine exploration. To simulate pre-mining conditions, these inflows were removed from the model calibration; the result was a simulation of the stream with all the non-mining inputs. At a point downstream from the two mining inflows, the simulated pre-mining pH would have been 5.1, up from the measured 3.8. At the higher pH, the streambed likely would have been coated with Al precipitate. Simulated pre-mining Zn and Cu would have been 1300 µg/L and 18 µg/L, lower than the measured concentrations of 3340 and 93 µg/L. Despite these changes, the pre-mining conditions would not have met aquatic-life standards.

Colorado↗