Geology topics

Research about Pawnee, Oklahoma

Source-linked reports with geographic coverage including Pawnee, Oklahoma.

3 recordsLinked to original sources

USGS2019

Rupture model of the M5.8 Pawnee, Oklahoma earthquake from regional and teleseismic waveforms

The 2016 M5.8 Pawnee, Oklahoma earthquake is the largest earthquake to have been induced by wastewater disposal. We infer the coseismic slip history from analysis of apparent source time functions and inversion of regional and teleseismic P‐waveforms, using aftershocks as empirical Green's functions. The earthquake nucleated on the shallow part of the fault, initially rupturing towards the surface, followed shortly thereafter by slip deeper on the fault. Deeper slip occurred below the aftershocks and at greater depths than most induced seismicity in the region, suggesting that small‐ to moderate‐sized earthquakes may not occur on deeper parts of faults in Oklahoma because they are further from failure than shallower fault sections. Comparisons with models of pore pressure perturbations further suggest that the earthquake may have initiated within a region of higher pore pressure perturbation but was not confined to this zone. These observations inform source physics and understanding of maximum magnitudes.

Oklahoma↗

USGS2017

Geodetic slip model of the 3 September 2016 Mw 5.8 Pawnee, Oklahoma, earthquake: Evidence for fault‐zone collapse

The 3 September 2016 M w 5.8 Pawnee earthquake in northern Oklahoma is the largest earthquake ever recorded in Oklahoma. The coseismic deformation was measured with both Interferometric Synthetic Aperture Radar and Global Positioning System (GPS), with measureable signals of order 1 cm and 1 mm, respectively. We derive a coseismic slip model from Sentinel‐1A and Radarsat 2 interferograms and GPS static offsets, dominated by distributed left‐lateral strike slip on a primary west‐northwest–east‐southeast‐trending subvertical plane, whereas strike slip is concentrated near the hypocenter (5.6 km depth), with maximum slip of ∼1 m located slightly east and down‐dip of the hypocenter. Based on systematic misfits of observed interferogram line‐of‐sight (LoS) displacements, with LoS based on shear‐dislocation models, a few decimeters of fault‐zone collapse are inferred in the hypocentral region where coseismic slip was the largest. This may represent the postseismic migration of large volumes of fluid away from the high‐slip areas, made possible by the creation of a temporary high‐permeability damage zone around the fault.

Oklahoma↗

USGS2017

Oklahoma experiences largest earthquake during ongoing regional wastewater injection hazard mitigation efforts

The 3 September 2016, M w 5.8 Pawnee earthquake was the largest recorded earthquake in the state of Oklahoma. Seismic and geodetic observations of the Pawnee sequence, including precise hypocenter locations and moment tensor modeling, shows that the Pawnee earthquake occurred on a previously unknown left-lateral strike-slip basement fault that intersects the mapped right-lateral Labette fault zone. The Pawnee earthquake is part of an unprecedented increase in the earthquake rate in Oklahoma that is largely considered the result of the deep injection of waste fluids from oil and gas production. If this is, indeed, the case for the M 5.8 Pawnee earthquake, then this would be the largest event to have been induced by fluid injection. Since 2015, Oklahoma has undergone wide-scale mitigation efforts primarily aimed at reducing injection volumes. Thus far in 2016, the rate of M 3 and greater earthquakes has decreased as compared to 2015, while the cumulative moment—or energy released from earthquakes—has increased. This highlights the difficulty in earthquake hazard mitigation efforts given the poorly understood long-term diffusive effects of wastewater injection and their connection to seismicity.

Oklahoma↗