Geology Reports⌕ Search

Geology topics

Research about India

Source-linked reports with geographic coverage including India.

99 records · Page 6Linked to original sources
USGS1984

A seismic hazard map of India and adjacent areas

We have produced a probabilistic seismic hazard map showing peak ground accelerations in rock for India and neighboring areas having a 10% probability of being exceeded in 50 years. Seismogenic zones were identified on the basis of historical seismicity, seismotectonics and geology of the region. Procedures for reducing the incompleteness of earthquake catalogs were followed before estimating recurrence parameters. An eastern United States acceleration attenuation relationship was employed after it was found that intensity attenuation for the Indian region and the eastern United States was similar. The largest probabilistic accelerations are obtained in the seismotectonic belts of Kirthar, Hindukush, Himalaya, Arakan-Yoma, and the Shillong massif where values of over 70% g have been calculated.

Tectonophysics↗
USGS1981

Eastern Indian 3800-million-year-old crust and early mantle differentiation

Samarium-neodymium data for nine granitic and tonalite gneisses occurring as remnants within the Singhbhum granite batholith in eastern India define an isochron of age 3775 ± 89 × 10 6 years with an initial 143 Nd/ 144 Nd ratio of 0.50798 ± 0.00007. This age contrasts with the rubidium-strontium age of 3200 × 10 6 years for the same suite of rocks. On the basis of the new samarium-neodynium data, field data, and petrologic data, a scheme of evolution is proposed for the Archean crust in eastern India. The isotopic data provide evidence that parts of the earth's mantle were already differentiated with respect to the chondritic samarium-neodymium ratio 3800 × 10 6 years ago.

eastern India↗
USGS1973

Lonar Lake, India: An impact crater in basalt

Discovery of shock-metamorphosed material establishes the impact origin of Lonar Crater. Coarse breccia with shatter coning and microbreccia with moderately shocked fragments containing maskelynite were found in drill holes through the crater floor. Trenches on the rim yield strongly shocked fragments in which plagioclase has melted and vesiculated, and bombs and spherules of homogeneous rock melt. As the only known terrestrial impact crater in basalt, Lonar Crater provides unique opportunities for comparison with lunar craters. In particular, microbreccias and glass spherules from Lonar Crater have close analogs among the Apollo specimens.

Lonar Lake↗
USGS1973

A review of proposed ground-water assessment studies in states of Gujarat, Madhya Pradesh, Maharashtra, and Mysore, India

This report documents the findings and recommendations of the author, who was detailed for 30 days to USAID Mission to India to assist in preparing the scope of work for a USAID contract for consultant services for ground-water evaluation. The proposed study, Soil and Water Management Sub-project 368.6, covered three specific areas in four states in central and southern India (See TOAID A-653 of July 31, 1970, revised description of the sub-project). The study areas and principal cities are shown in figure 1.

Gujarat, Madhya Pradesh, Maharashtra, Mysore↗
USGS1969

Fault-plane Solution of the Koyna (India) Earthquake

THE peninsular shield of India has long been regarded as a stable region. The area had not been subject to orogenic deformation since the Pre-Cambrian, although a vast area (5 × 10 5 square km) was flooded by basalts during Late Cretaceous to the Eocene—the Deccan Trap. Several years ago, a small dam was built across the Koyna river, some 200 km south-east of Bombay (Fig. 1). The dam reservoir filled in stages, beginning with the monsoon of 1962, and reached a capacity of 2 × 10 9 m 3 and a maximum depth of about 70 m 1 .

Nature↗
USGS1961

Ground-water control in the Neyveli lignite field, South Arcot district, Madras State, India

Unconsolidated deposits of the Cuddalore series of Miocene age underlie much of the coastal plain of southern Madras . Several lignite seams occur in a thick sequence of sand, gravel, and clay that dips seaward about 40 to 100 feet per mile. The principal seam of lignite mapped in the Neyveli area averages more than 50 feet in thickness, underlies at least 80 square miles, and occurs at a minimum depth of 165 feet near Neyveli , where deposits totalling 230 million tons have been proved in an area of 4J square miles. The lignite seam is immediately underlain, throughout its area of occurrence, by a thick bed of sand and gravel that contains artesian water, the head of which is more than 100 feet above the top of the lignite at Neyveli . The sand and gravel aquifer is exposed to recharge in and near its outcrop area, 6 to 10 miles northwest of Neyveli , where the average annual rainfall is 41 inches. Hydraulic tests of the aquifer indicate that ground-water control for mining by opencast from a pit 6,000 feet long and 1,200 feet wide will require continuous withdrawal of about 40,000 gallons (Imperial) per minute from wells in and adjacent to the mine. The well field , including 50 to 65 large-capacity wells, must move with the open cut; and no appreciable decrease in the withdrawal rate can be expected throughout the life of the mine, which is designed to produce about 3j million tons of raw lignite per year.

Madras State↗
USGS1959

Ground-water provinces of India

This paper gives a general resume of ground-water utilization and development and describes the occurrence of water in eight ground-water provinces of India. The paper is based in part on observations of the writer during 1951-55 and in part on earlier work of the Geological Survey of India. Ground water has been utilized extensively in India since before the beginning of the Christian era. Currently (1956) ground water is an important source of supply for domestic, stock, municipal, and industrial needs throughout the Republic and is widely used for irrigation in the Peninsular and Ganges-Brahmaputra regions west of longitude 85°. Dug, bored, and drilled wells are the principal means by which ground water is developed, although locally infiltration tunnels or improved springs are used. Methods of lifting or pumping water from wells include the hand line and bucket, the hand-lift pump, the counterpoised sweep, bullocks, and "mote," the water wheel, horizontal and vertical centrifugal pumps, and deep-well turbine pumps. The most common device for lifting water for irrigation is still the time-honored bullock and "mote" (leather bag). However, in modern India there is increasing use of mechanical pumps. With respect to the occurrence of ground water, India can be divided into eight provinces, lying in three major regions, (1) the Peninsular region, (2) the Ganges-Brahmaputra region, and (3) the Himalayan region. The Peninsular region contains six ground-water provinces. Precambrian igneous, metamorphic, and indurated sedimentary rocks and early Tertiary volcanic rocks in three of these provinces yield many small supplies of water, which generally is of good quality but locally is brackish or salty. Cretaceous water-bearing sandstones in another province are moderately productive and in places are developed for large water supplies. Late Tertiary and Quaternary water-bearing sands and gravels in two other provinces sustain many small water supplies and several large water supplies-particularly in the coastal areas of southern India. The Ganges-Brahmaputra region is a single ground-water province in which many tens of thousands of small water supplies and several thousand large supplies are obtained from water-bearing sands and gravels in late Tertiary and Quaternary alluvium. This province constitutes a vast groundwater reservoir, which is the most productive in India. The Himalayan region also is considered as a single province, in which ground water occurs in a series of narrow valleys filled with moderately to highly permeable Quaternary alluvium. These alluvial valleys transmit large quantities of water to the ground-water reservoir in the Ganges-Brahmaputra region.

Economic Geology↗
USGS1955

Flood control problems

Throughout the world, alluvial soils are among the most fertile and easiest cultivated. Alluvial valleys are routes for transportation either by water or by road and railroad. Rivers are sources of water, a necessity of life. But these river valleys and alluvial deposits, which have so many desirable characteristics and which have increased so greatly in population, are periodically occupied by the river in performing its task of removing the excess of precipitation from the land area and carrying away the products of erosion. How a river behaves and how the river flood plain appears depend on the relationships between water and sediment combined with the existing topography. Thus rivers and their alluvial deposits provide an endless variety of forms which are shaped, to a large extent, by the river flow during periods of rapid removal of debris and of excessive rainfall. The mechanics of river formation are such, however, that the highest discharges are not contained within a limited channel. How much water a channel will carry depends upon the frequency of occurrence of a flow. Low flows, which occur very frequently, are not important in channel formation. Neither are the infrequent discharges of very great magnitude which, although powerful, do not occur often enough to shape the channel. Channel characteristics, are dependent on those discharges of moderate size which combine power with frequency of occurrence to modify the channel from. In the highest discharges of a stream, water rises above the confines of its banks and flows over the flood plain. It must be considered, therefore, that floods are natural phenomena which are characteristic of all rivers. They perform a vital function in the maintenance of river forms and out of bank flow may be expected with a reasonable degree of regularity.

Journal of Soil and Water Conservation in India↗