USGS1978
Landsliding is a common problem in eastern Fairfax County, an area underlain by Potomac Group (Lower Cretaceous) Coastal Plain deposits of silt and clay interbedded and interfingered with sand and gravel. The slides commonly are present in clay and silt that, on the basis of laboratory tests, appear to be much too strong to have failed. However, the very plastic silt and clay deposits are commonly cut by long continuous to short discontinuous high-angle and subhorizontal joints, shears, and faults. These fractures can contribute to sliding. Failure along faults and shears takes place because the relative movement has greatly weakened and softened the clay and silt. The mechanism for failure along the joints is less obvious but may be related to infilling along joints, slight movement due to erosional unloading, swelling of clays, and softening along joints. Field investigations suggest that the three best developed high-angle joint sets in eastern Fairfax County have trends in the northeast quadrant. Lineaments plotted on a lineament map prepared from Landsat imagery also trend northeast parallel to the regional joint orientation. This regional orientation suggests that some of the fractures are tectonic in origin. Therefore, they should be anticipated in a broad zone many miles wide in the vicinity of the Fall Line. In addition, fractures of unknown origin contributing to landsliding, have been observed in massive Potomac Group clay and silt deposits. Irrespective of origin, these fractures require careful investigation and engineering to prevent slope failure at critical locations during and after major excavation.