Geology Reports⌕ Search

Geology topics

Research about Death Valley

Source-linked reports with geographic coverage including Death Valley.

31 records · Page 2Linked to original sources
USGS2001

Ground-water discharge determined from estimates of evapotranspiration, Death Valley regional flow system, Nevada and California

The Death Valley regional flow system (DVRFS) is one of the larger ground-water flow systems in the southwestern United States and includes much of southern Nevada and the Death Valley region of eastern California. Centrally located within the ground-water flow system is the Nevada Test Site (NTS). The NTS, a large tract covering about 1,375 square miles, historically has been used for testing nuclear devices and currently is being studied as a potential repository for the long-term storage of high-level nuclear waste generated in the United States. The U.S. Department of Energy, as mandated by Federal and State regulators, is evaluating the risk associated with contaminants that have been or may be introduced into the subsurface as a consequence of any past or future activities at the NTS. Because subsurface contaminants can be transported away from the NTS by ground water, components of the ground-water budget are of great interest. One such component is regional ground-water discharge. Most of the ground water leaving the DVRFS is limited to local areas where geologic and hydrologic conditions force ground water upward toward the surface to discharge at springs and seeps. Available estimates of ground-water discharge are based primarily on early work done as part of regional reconnaissance studies. These early efforts covered large, geologically complex areas and often applied substantially different techniques to estimate ground-water discharge. This report describes the results of a study that provides more consistent, accurate, and scientifically defensible measures of regional ground-water losses from each of the major discharge areas of the DVRFS. Estimates of ground-water discharge presented in this report are based on a rigorous quantification of local evapotranspiration (ET). The study identifies areas of ongoing ground-water ET, delineates different ET areas based on similarities in vegetation and soil-moisture conditions, and determines an ET rate for each delineated area. Each area, referred to as an ET unit, generally consists of one or more assemblages of local phreatophytes or a unique moist soil environment. Ten ET units are identified throughout the DVRFS based on differences in spectral-reflectance characteristics. Spectral differences are determined from satellite imagery acquired June 21, 1989, and June 13, 1992. The units identified include areas of open playa, moist bare soils, sparse to dense vegetation, and open water. ET rates estimated for each ET unit range from a few tenths of a foot per year for open playa to nearly 9 feet per year for open water. Mean annual ET estimates are computed for each discharge area by summing estimates of annual ET from each ET unit within a discharge area. The estimate of annual ET from each ET unit is computed as the product of an ET unit's acreage and estimated ET rate. Estimates of mean annual ET range from 450 acre-feet in the Franklin Well area to 30,000 acre-feet in Sarcobatus Flat. Ground-water discharge is estimated as annual ET minus that part of ET attributed to local precipitation. Mean annual ground-water discharge estimates range from 350 acre-feet in the Franklin Well area to 18,000 acre-feet in Ash Meadows. Generally, these estimates are greater for the northern discharge areas (Sarcobatus Flat and Oasis Valley) and less for the southern discharge areas (Franklin Lake, Shoshone area, and Tecopa/ California Valley area) than those previously reported.

California, Nevada↗
USGS2001

Hydraulic-property estimates for use with a transient ground-water flow model of the Death Valley regional ground-water flow system, Nevada and California

The Death Valley regional ground-water flow system encompasses an area of about 43,500 square kilometers in southeastern California and southern Nevada, between latitudes 35? and 38?15' north and longitudes 115? and 117?45' west. The study area is underlain by Quaternary to Tertiary basin-fill sediments and mafic-lava flows; Tertiary volcanic, volcaniclastic, and sedimentary rocks; Tertiary to Jurassic granitic rocks; Triassic to Middle Proterozoic carbonate and clastic sedimentary rocks; and Early Proterozoic igneous and metamorphic rocks. The rock assemblage in the Death Valley region is extensively faulted as a result of several episodes of tectonic activity. This study is comprised of published and unpublished estimates of transmissivity, hydraulic conductivity, storage coefficient, and anisotropy ratios for hydrogeologic units within the Death Valley region study area. Hydrogeologic units previously proposed for the Death Valley regional transient ground-water flow model were recognized for the purpose of studying the distribution of hydraulic properties. Analyses of regression and covariance were used to assess if a relation existed between hydraulic conductivity and depth for most hydrogeologic units. Those analyses showed a weak, quantitatively indeterminate, relation between hydraulic conductivity and depth.

California, Nevada↗
USGS2000

Late Cenozoic crustal extension and magmatism, southern Death Valley region, California

The late Cenozoic geologic history of the southern Death Valley region is characterized by coeval crustal extension and magamatism. Crustal extension is accommodated by numerous listric and planar normal faults as well as right- and left-lateral strike slip faults. The normal faults sip 30°-50° near the surface and flatten and merge leozoic miogeoclinal rocks; the strike-slip faults act as tear faults between crustal blocks that have extended at different times and at different rates. Crustal extension began 13.4-13.1 Ma and migrated northwestward with time; undeformed basalt flows and lacustrine deposits suggest that extension stopped in this region (but continued north of the Death Valley graben) between 5 and 7 Ma. Estimates of crustal extension in this region vary from 30-50 percent to more than 100 percent. Magmatic rocks syntectonic with crustal extension in the southern Death Valley region include 12.4-6.4 Ma granitic rocks as well as bimodal 14.0-4.0 Ma volcanic rocks. Geochemical and isotopic evidence suggest that the granitic rocks get younger and less alkalic from south to north; the volcanic rocks become more mafic with less evidence of crustal interaction as they get younger. The close spatial and temporal relation between crustal extension and magmatism suggest a genetic and probably a dynamic relation between these geologic processes. We propose a rectonic-magmatic model that requires heat to be transported into the crust by mantle-derived mafic magmas. These magmas pond at lithologic or rheologic boundaries, begin the crystallize, and partially melt the surrounding crustal rocks. With time, the thermally weakened crust is extended (given a regional extensional stress field) concurrent with granitic magmatism and bimodal volcanism.

California↗
USGS1999

Cenozoic basins of the Death Valley extended terrane as reflected in regional-scale gravity anomalies

The contrast in density between basin-filling deposits and underlying basement rocks in the Basin and Range province produces a distinctive pattern of gravity anomalies that roughly correlates with basin-and-range topography. This is especially apparent in the Death Valley extended terrane, where minima in residual gravity closely correspond to well-known extensional basins, such as Owens Valley, Saline Valley, Pahrump Valley, and Death Valley itself. A three-dimensional calculation of the thickness and shape of Cenozoic deposits throughout the Basin and Range based on digital gravity, geologic, and topographic information is here interpreted in terms of the depths and shapes of extensional basins in the Death Valley region. In most basins, the gravity inversion predicts a much more complex basement than might be assumed from the surface topography. Death Valley itself is, to first order, a two-dimensional feature; as reflected by the topography of the bounding ranges down to 400–800 m below the valley floor, it is a long, narrow, and continuous valley along its entire length of 200 km. This apparent uniformity, however, belies a complex basement surface beneath the Cenozoic cover as revealed by the gravity inversion. The floor of Death Valley is pockmarked with four deep (3–5 km), steep-sided depressions that may have formed as relatively small pull-apart structures superimposed on the more uniform extension that created the twodimensional aspects of Death Valley. Lateral dimensions of these subbasins suggest a minimum of 10 km of northwest extension across Death Valley. If a regionally continuous detachment surface lies beneath Death Valley, it must lie deeper than the subbasins, that is, below a depth of 3–5 km. Similar deep, steep-sided subbasins are seen elsewhere in the Death Valley extended terrane, notably at Saline Valley, Panamint Valley, Pahrump Valley, the Amargosa Desert, and Fremont Valley, but are noticeably absent from the Mojave Desert block south of the Garlock fault zone where extensional rates are lower. The floor of the caldera complex at the southwest Nevada volcanic field is predicted by the gravity inversion to be extraordinarily deep (>8 km) and rugged. Deep, linear basins that branch out of the caldera complex may reflect modification of extensional strain due to massive injections of magma into the middle and upper crust.

California, Nevada↗
USGS1993

Mapping playa evaporite minerals with AVIRIS data: A first report from Death Valley, California

Efflorescent salt crusts in Death Valley, California, were mapped by using Airborne Visible/Infrared Imaging Spectrometer (AVIRIS) data and a recently developed least-squares spectral band-fitting algorithm. Eight different saline minerals were remotely identified, including three borates, hydroboracite, pinnoite, and rivadavite, that have not been previously reported from the Death Valley efflorescent crusts. The three borates are locally important phases in the crusts, and at least one of the minerals, rivadavite, appears to be forming directly from brine. Borates and other evaporite minerals provide a basis for making remote chemical measurements of desert hydrologic systems. For example, in the Eagle Borax Spring area, the AVIRIS mineral maps pointed to elevated magnesium and boron levels in the ground waters, and to the action of chemical divides causing subsurface fractionation of calcium. Many other chemical aspects of playa brines should have an expression in the associated evaporite assemblages. Certain anhydrous evaporites, including anhydrite, glauberite, and thenardite, lack absorption bands in the visible and near-infrared wavelength range, and crusts composed of these minerals could not be characterized by using AVIRIS. In these situations, thermal-infrared remote sensing data may complement visible and near-infrared data for mapping evaporites. Another problem occurred in wet areas of Death Valley, where water absorption caused low signal levels in the 2.0-2.5 ??m wavelength region that obscured any spectral features of evaporite minerals. Despite these difficulties, the results of this study demonstrate the potential for using AVIRIS and other imaging spectrometer data to study playa chemistry. Such data can be useful for understanding chemical linkages between evaporites and ground waters, and will facilitate studies of how desert ground-water regimes change through time in response to climatic and other variables.

California↗
USGS1986

Reconnaissance surficial geologic map of northern Death Valley, California and Nevada

Sedimentary deposits of northern Death Valley include units of alluvial, eolian, lacustrine, and spring origin. The alluvial deposits, which include both fan and pediment deposits, predominate. Fan deposits are divided into four major units; locally one of these is further divided into three subunits. Pediment deposits may be divided into two subunits. Hyphenated map symbols (for example, Qf 4-3 ) are used where two deposits cannot be separated at the map scale; symbols separated by a slash indicate areas where thin veneers of younger deposits overlie old deposits (for example, Qf 3 /Qp 2 ).

California, Nevada↗
USGS1977

Appraisal of the water resources of Death Valley, California-Nevada

The hydrologic system in Death Valley is probably in a steady-state condition--that is, recharge and discharge are equal, and net changes in the quantity of ground water in storage are not occurring. Recharge to ground water in the valley is derived from interbasin underflow and from local precipitation. The two sources may be of the same magnitude. Ground water beneath the valley moves toward the lowest area, a 200-square-mile saltpan, much of which is underlain by rock salt and other saline minerals, probably to depths of hundreds of feet or even more than 1,000 feet. Some water discharges from the saltpan by evaportranspiration. Water beneath the valley floor, excluding the saltpan, typically contains between 3,000 and 5,000 milligrams per liter of dissolved solids. Water from most springs and seeps in the mountains contains a few hundred to several hundred milligrams per liter of dissolved solids. Water from large springs that probably discharge from interbasin flow systems typically contains between 500 and 1,000 milligrams per liter dissolved solids. Present sites of intensive use by man are supplied by springs, with the exception of the Stovepipe Wells Hotel area. Potential sources of supply for this area include (1) Emigrant Spring area, (2) Cottonwood Spring, and (3) northern Mesquite Flat. (Woodard-USGS)

California, Nevada↗
USGS1959

Turtleback faults of Death Valley, California: A reinterpretation

Turtlebacks are smooth, curved surfaces, which form north-northwestward-plunging elongate domes on the east side of Death Valley. These surfaces are roughly parallel to bedding or foliation of anticlines in Precambrian schist, gneiss, and marble. Late Cenozoic fan and playa deposits are faulted over these surfaces along the turtleback faults. Previously the turtleback faults have been interpreted as part of a thrust fault, perhaps the Amargosa thrust fault, that was arched after thrusting. They are interpreted here as individual normal faults younger than the thrust fault and, contrary to previous interpretations, much younger than the formation of the anticlines in the Precambrian rocks. The tectonic history of this unusual area is here considered to include the following events: (1) Precambrian folding of the Precambrian rocks; (2) post-Paleozoic and pre-middle(?) Tertiary Amargosa thrusting; (3) uplift and erosion of Paleozoic strata and the Amargosa thrust fault, down to the folded Precambrian rocks in the Black Mountains block; (4) Middle (?) Tertiary rhyolite extrusions and the accumulation of later Tertiary fan and playa deposits; (5) Pliocene or Pleistocene uplift of the Black Mountains relative to Death Valley, along the Black Mountains fault system, with consequent removal of support for the Tertiary deposits on the turtleback surfaces, and the development of the turtleback faults by normal faulting, or sliding, of the Tertiary sedimentary rocks down the turtleback surfaces toward Death Valley; and, (6) Pleistocene to Recent renewal of movement on the Black Mountains fault system.

California↗