Geology Reports⌕ Search

Geology topics

Research about Clear Lake

Source-linked reports with geographic coverage including Clear Lake.

24 records · Page 2Linked to original sources
USGS1978

Mercury analysis of sediments from cores in Clear Lake, Lake County, California

Cores of late Quaternary sediments were collected from several sites in Clear Lake (fig. 1). Samples from two of these cores (fig. 2, 3) have been analyzed for their mercury content as part of a study on the time of emplacement of the mercury ore body at the nearby Sulphur Bank mine (fig. 1). The samples were analyzed in laboratories of the U.S. Geological Survey by the mercury vapor detector method (Vaughn and McCarthy, 1964; Vaughn, 1967). The analyses of core 6, except samples 332, 341, 343, 386, 406, and 462, were done by Mr. Kam Leong (Table 1); the remaining analyses were done by Mr. Allen Meier. Analyses of core 10 (table 2) were done by Mr. Meier. Meier reported interference by organic material in the samples he analyzed. Because the two sets of data are not in agreement, most of the samples submitted to Leong and Meier are being reanalyzed.

California↗
USGS1976

Sampling procedures and catalogue of samples for eight boreholes at Clear Lake, Lake County, California

Clear Lake, California, is situated in an area which has been subject to crustal movement, earthquake-generated ground shaking, volcanic eruptions, and climatic fluctuations during late Quaternary time. The U.S. Geological Survey, in cooperation with Lake County, has undertaken a study of the seismic, volcanic, and environmental history recorded in the late Quaternary sediments beneath the floor of the lake (Sims, 1974). This study is based on continuous core samples measuring 12 cm or 15 cm in diameter that were obtained in August-November, 1973, from 8 boreholes measuring 14-113 m in length (Figure 1). Preliminary description of many of these samples and interpretation of ancient seismic events can be found in Sims and Rymer (1975). Over 2,000 multiple samples have been taken from these cores in order to study the environmental record preserved in the lacustrine sediments. Samples were taken for pollen, diatoms, cladocera, bulk mineralogy, fine size analysis, macrofossils, and water-content/organic carbon-content at designated depths. In addition, volcanic ash and radiocarbon samples were removed for correlation studies and age determinations. This report provides a description of the standard sampling procedures designed for sapropelic muds and peat-rich clays, a description of modified sampling procedures developed for sampling sands and coarser sediments, and a catalogue of samples from the Clear Lake cores. Table 2 outlines the steps followed for the standard sampling procedures.

California↗
USGS1976

Preliminary description and interpretation of cores and radiographs from Clear Lake, Lake County, California: Core 3

Clear Lake, California is located in the California Coast Ranges about 120 km north of San Francisco and is the largest freshwater lake wholly within California. The lake basin is tectonically controlled (Anderson, 1936; Brice, 1953; Sims and Rymer, 1974) and the area seismically active (Coffman and von Hake, 1973). Interest in this lake was stimulated by hypotheses developed from a study of sediments in Van Norman Reservoir after the 1971 San Fernando earthquake (Sims, 1973). During this study three zones of deformational structures were found in the 1 m-thick sequence of sediments exposed over about 2 km2 of the reservoir bottom. These zones were correlated with moderate earthquakes that shook the San Fernando area in 1930, 1952, and 1971. Results of this study, coupled with the experimental formation of deformational structures similar to those from Van Norman Reservoir, led to a search for similar structures in Pleistocene and Holocene lakes and lake sediments in other seismically active areas. Clear Lake, California was chosen specifically because of its location near the San Andreas fault and the San Francisco-Oakland urban complex, and the probability of obtaining an uninterrupted sediment record from the present into Pleistocene time. Eight 12 to 15 cm diameter continuous cores were taken from the lake sediments (fig. 1) as part of a study of earthquake induced structures in sediments and the tectonic framework of the Clear Lake basin. The eight cores range in length from 13.87 m to 115.21 m (Table 1).

California↗
USGS1975

Preliminary description and interpretation of cores and radiographs from Clear Lake, Lake County, California: Core 7

Clear Lake, California is located in the California Coast Ranges about 120 km north of San Francisco and is the largest freshwater lake wholly within California. The lake basin is tectonically controlled (Anderson, 1936; Brice, 1953, Sims and Rymer, 1974) and the area seismically active (Coffman and von Hake, 1973). Interest in this lake was stimulated by hypotheses developed from a study of sediments in Van Norman Reservoir after the 1971 San Fernando earthquake (Sims, 1973). During this study three zones of deformational structures were found in the 1 m-thick sequence of sediments exposed over about 2 km 2 of the reservoir bottom. These zones were correlated with moderate earthquakes that shook the San Fernando area in 1930, 1952, and 1971. Results of this study, coupled with the experimental formation of deformational structures similar to those from Van Norman Reservoir, led to a search for similar structures in Pleistocene and Holocene lakes and lake sediments in other seismically active areas. Clear Lake, California was chosen specifically because of .:s location near the San Andreas fault and the San Francisco-Oakland urban complex, and the probability of obtaining an uninterrupted sediment record from the present into Pleistocene time. Eight 12 to 15 cm diameter continuous cores were taken from the lake sediments (fig. 1) as part of a study of earthquake induced structures in sediments and the tectonic framework of the Clear Lake basin. The eight cores range in length from 13.87 m to 133.09 m (Table 1).

California↗