Geology topics

Research about Cascadia forearc

Source-linked reports with geographic coverage including Cascadia forearc.

3 recordsLinked to original sources

USGS2022

Fluid transport and storage in the Cascadia forearc influenced by overriding plate lithology

Subduction of hydrated oceanic lithosphere can carry water deep into the Earth, with consequences for a range of tectonic and magmatic processes. Most of the fluid is released in the forearc where it plays a critical role in controlling the mechanical properties and seismic behaviour of the subduction megathrust. Here we present results from three-dimensional inversions of data from nearly 400 long-period magnetotelluric sites, including 64 offshore, to provide insights into the distribution of fluids in the forearc of the Cascadia subduction zone. We constrain the geometry of the electrically resistive Siletz terrane, a thickened section of oceanic crust accreted to North America in the Eocene, and the conductive accretionary complex underthrust along the margin. We find that fluids accumulate over timescales exceeding 1 My above the plate in metasedimentary units, while the mafic rocks of Siletzia remain dry. Fluid concentrations tend to peak at slab depths of 17.5 and 30 km, suggesting control by metamorphic processes, but also concentrate around the edges of Siletzia, suggesting that this mafic block is impermeable, with dehydration fluids escaping up-dip along the megathrust. Our results demonstrate that the lithology of the overriding crust can play a critical role in controlling fluid transport in a subduction zone.

British Columbia, California, Oregon, Washington↗

USGS2017

Influence of the megathrust earthquake cycle on upper-plate deformation in the Cascadia forearc of Washington State, USA

The influence of subduction zone earthquake cycle processes on permanent forearc deformation is poorly understood. In the Cascadia subduction zone forearc of Washington State, USA, deformed and incised fluvial terraces serve as archives of longer-term (10 3 –10 4 yr) strain manifest as both fluvial incision and slip on upper-plate faults. We focus on comparing these geomorphic records in the Wynoochee River valley in the southern Olympic Mountains with short-term (10 1 yr) deformation driven by interseismic subduction zone coupling. We use optically stimulated luminescence dating and high-resolution elevation data to characterize strath terrace incision and differential uplift across the Canyon River fault, which cuts Wynoochee River terraces. This analysis demonstrates reverse slip rates of ∼0.1–0.3 mm/yr over the past ∼12–37 k.y., which agree with rates predicted by a GPS-constrained boundary element model of interseismic stress from Cascadia subduction zone coupling. Similarly, model-predicted patterns of interseismic uplift mimic the overall pattern of incision in the lower Wynoochee River valley, as revealed by strath elevations dated at 14.1 ± 1.2 ka. Agreement between modeled short-term and observed long-term records of forearc strain suggests that interseismic stress drives slip on upper-plate faults and fluvial incision in Cascadia. Consistency over multiple time scales may indicate relative stability in spatial patterns of subduction zone coupling over at least ∼10 4 yr intervals.

Washington↗

USGS2006

Local thickening of the Cascadia forearc crust and the origin of seismic reflectors in the uppermost mantle

Seismic reflection profiles from three different surveys of the Cascadia forearc are interpreted using P wave velocities and relocated hypocentres, which were both derived from the first arrival travel time inversion of wide-angle seismic data and local earthquakes. The subduction decollement, which is characterized beneath the continental shelf by a reflection of 0.5 s duration, can be traced landward into a large duplex structure in the lower forearc crust near southern Vancouver Island. Beneath Vancouver Island, the roof thrust of the duplex is revealed by a 5–12 km thick zone, identified previously as the E reflectors, and the floor thrust is defined by a short duration reflection from a < 2-km-thick interface at the top of the subducting plate. We show that another zone of reflectors exists east of Vancouver Island that is approximately 8 km thick, and identified as the D reflectors. These overlie the E reflectors; together the two zones define the landward part of the duplex. The combined zones reach depths as great as 50 km. The duplex structure extends for more than 120 km perpendicular to the margin, has an along-strike extent of 80 km, and at depths between 30 km and 50 km the duplex structure correlates with a region of anomalously deep seismicity, where velocities are less than 7000 m s − 1 . We suggest that these relatively low velocities indicate the presence of either crustal rocks from the oceanic plate that have been underplated to the continent or crustal rocks from the forearc that have been transported downward by subduction erosion. The absence of seismicity from within the E reflectors implies that they are significantly weaker than the overlying crust, and the reflectors may be a zone of active ductile shear. In contrast, seismicity in parts of the D reflectors can be interpreted to mean that ductile shearing no longer occurs in the landward part of the duplex. Merging of the D and E reflectors at 42–46 km depth creates reflectivity in the uppermost mantle with a vertical thickness of at least 15 km. We suggest that pervasive reflectivity in the upper mantle elsewhere beneath Puget Sound and the Strait of Georgia arises from similar shear zones.

Cascadia forearc↗