Geology topics

Z. Ross

Publications and source records attributed to Z. Ross.

4 recordsLinked to original sources

USGS2022

A unified perspective of seismicity and fault coupling along the San Andreas Fault

The San Andreas Fault (SAF) showcases the breadth of possible earthquake sizes and occurrence behavior; in particular, the central SAF is a microcosm of such diversity. This section also exhibits the spectrum of fault coupling from locked to creeping. Here, we show that the observations of aseismic slip, temporal clustering of seismicity, and spatial variations in earthquake size distributions are tightly connected. Specifically, the creep rate along the central SAF is shown to be directly proportional to the fraction of nonclustered earthquakes for the period 1984–2020. This relationship provides a unified perspective of earthquake phenomenology along the SAF, where lower coupling manifests in weaker temporal clustering, with repeating earthquakes as an end-member. This new paradigm provides additional justification for characterizing the northwest ∼75 kilometers of the creeping segment as a transition zone, with potential implications for seismic hazard.

California↗

USGS2020

Activation of optimally and unfavourably oriented faults in a uniform local stress field during the 2011 Prague, Oklahoma, sequence

The orientations of faults activated relative to the local principal stress directions can provide insights into the role of pore pressure changes in induced earthquake sequences. Here, we examine the 2011 M 5.7 Prague earthquake sequence that was induced by nearby wastewater disposal. We estimate the local principal compressive stress direction near the rupture as inferred from shear wave splitting measurements at spatial resolutions as small as 750 m. We find that the dominant azimuth observed is parallel to previous estimates of the regional compressive stress with some secondary azimuths oriented subparallel to the strike of the major fault structures. From an extended catalogue, we map ten distinct fault segments activated during the sequence that exhibit a wide array of orientations. We assess whether the five near-vertical fault planes are optimally oriented to fail in the determined stress field. We find that only two of the fault planes, including the M 5.7 main shock fault, are optimally oriented. Both the M 4.8 foreshock and M 4.8 aftershock occur on fault planes that deviate 20–29° from the optimal orientation for slip. Our results confirm that induced event sequences can occur on faults not optimally oriented for failure in the local stress field. The results suggest elevated pore fluid pressures likely induced failure along several of the faults activated in the 2011 Prague sequence.

Oklahoma↗

USGS2020

3D fault architecture controls the dynamism of earthquake swarm

The vibrant evolutionary patterns made by earthquake swarms are incompatible with standard, effectively two-dimensional (2D) models for general fault architecture. We leverage advances in earthquake monitoring with a deep-learning algorithm to image a fault zone hosting a 4-year-long swarm in southern California. We infer that fluids are naturally injected into the fault zone from below and diffuse through strike-parallel channels while triggering earthquakes. A permeability barrier initially limits up-dip swarm migration but ultimately is circumvented. This enables fluid migration within a shallower section of the fault with fundamentally different mechanical properties. Our observations provide high-resolution constraints on the processes by which swarms initiate, grow, and arrest. These findings illustrate how swarm evolution is strongly controlled by 3D variations in fault architecture.

Science↗

USGS2019

Slow-growing and extended-duration seismicity swarms: Reactivating joints or foliations in the Cahuilla Valley Pluton, Central Peninsular Ranges, Southern California

Three prolific earthquake swarms and numerous smaller ones have occurred since 1980 in the Mesozoic igneous plutonic rocks of the Perris block of the Peninsular Ranges, Southern California. The major swarms occurred in 1980–1981, 1983–1984, and 2016–2018, with the latest swarm still ongoing. These swarms have no clear mainshock, with the largest events of M L 3.6, M L 3.7, and M w 4.4. Each successive swarm had larger cumulative seismic moment release with about 314 and 411 events of M ≥ 1.5, while the third swarm has produced about 451 events of M ≥ 1.5 (as of September 2018). The concurrent strike‐slip faulting occurred on north to northwest striking planes but with no orthogonal northeast trending seismicity alignments. These shallow swarms are probably driven by intrablock Pacific‐North America plate boundary stress loading of the two bounding major late Quaternary strike‐slip faults, the Elsinore and San Jacinto faults. The state of stress within the Cahuilla Valley pluton has a ~40° angle between the maximum principal stress and the average trend of the swarms, suggesting that migrating pore fluid pressures aid in the formation and growth of zones of weakness. These swarms, which last more than 600 days each, exhibit clear bilateral spatial migration for distances of up to ~7–8 km and reach their full length in about 20 months. The slow spatial‐temporal development of the swarms corresponds to a fluid diffusivity of 0.006 to 0.01 m 2 /s, consistent with very low permeability rocks as expected for this block. There is no geodetic or other evidence for a slow slip event driving the swarms.

California↗