W.H. Pedler | Geology Reports

USGS1996

Integrated borehole logging methods for wellhead protection applications

Modeling of ground water infiltration and movement in the wellhead area is a critical part of an effective wellhead protection program. Such models depend on an accurate description of the aquifer in the wellhead area so that reliable estimates of contaminant travel times can be used in defining a protection area. Geophysical and hydraulic measurements in boreholes provide one of the most important methods for obtaining the data needed to specify wellhead protection measures. Most effective characterization of aquifers in the wellhead vicinity results when a variety of geophysical and hydraulic measurements are made where geophysical measurements can be calibrated in terms of hydraulic variables, and where measurements are made at somewhat different scales of investigation. The application of multiple geophysical measurements to ground water flow in the wellhead area is illustrated by examples in alluvial, fractured sedimentary, and fractured crystalline rock aquifers. Data obtained from a single test well are useful, but cannot indicate how conductive elements in the aquifer are connected to form large-scale flow paths. Geophysical and hydraulic measurements made in arrays of observation boreholes can provide information about such large-scale flow paths, and are especially useful in specifying aquifer properties in wellhead protection studies.

Engineering Geology↗

USGS1993

Application of borehole geophysics in defining the wellhead protection area for a fractured crystalline bedrock aquifer

Wellbore geophysical techniques were used to characterize fractures and flow in a bedrock aquifer at a site near Blackwater Brook in Dover, New Hampshire. The primary focus ofthis study was the development of a model to assist in evaluating the area surrounding a planned water supply well where contaminants introduced at the land surface might be induced to flow towards a pumping well. Well logs and geophysical surveys used in this study included lithologic logs based on examination of cuttings obtained during drilling; conventional caliper and natural gamma logs; video camera and acoustic televiewer surveys; highresolution vertical flow measurements under ambient conditions and during pumping; and borehole fluid conductivity logs obtained after the borehole fluid was replaced with deionized water. These surveys were used for several applications: 1) to define a conceptual model of aquifer structure to be used in groundwater exploration; 2) to estimate optimum locations for test and observation wells; and 3) to delineate a wellhead protection area (WHPA) for a planned water supply well. Integration of borehole data with surface geophysical and geological mapping data indicated that the study site lies along a northeast-trending intensely fractured contact zone between surface exposures of quartz monzonite and metasedimentary rocks. Four of five bedrock boreholes at the site were estimated to produce more than 150 gallons per minute (gpm) (568 L/min) of water during drilling. Aquifer testing and other investigations indicated that water flowed to the test well along fractures parallel to the northeast-trending contact zone and along other northeast and north-northwest-trending fractures. Statistical plots of fracture strikes showed frequency maxima in the same northeast and north-northwest directions, although additional maxima occurred in other directions. Flowmeter surveys and borehole fluid conductivity logging after fluid replacement were used to identify water-producing zones in the boreholes; fractures associated with inflow into boreholes showed a dominant northeast orientation. Borehole fluid conductivity logging after fluid replacement also gave profiles of such water-quality parameters as fluid electrical conductivity (FEC), pH, temperature, and oxidation-reduction potential, strengthening the interpretation of crossconnection of boreholes by certain fracture zones. The results of this study showed that the application of these borehole geophysical techniques at the Blackwater Brook site led to an improved understanding of such parameters as fracture location, attitude, flow direction and velocity, and water quality; all of which are important in the determination of a WHPA.

Log Analyst↗