Geology topics
Publications and source records attributed to Uri S. ten Brink.
Review of The Dead Sea, the Lake and its Setting. Tina M. Niemi, Zvi Ben-Avraham, and Joel R. Gat (Editors). Oxford Monographs on Geology and Geophysics No. 36. Oxford University Press, N.Y. 286 pp. ISBN 0-19-508703-8, 1997. $75.
Relative contributions of geologic and anthropogenic processes to subsidence of southern Louisiana are vigorously debated. Of these, shallow sediment compaction is often considered dominant, although this has never been directly observed or effectively demonstrated. Quantitative understanding of subsidence is important for predicting relative sea level rise, storm surge flooding due to hurricanes, and for successful wetland restoration. Despite many shallow borings, few appropriate stratigraphic and geotechnical data are available for site-specific calculations. We overcome this by determining present compaction rates from Monte Carlo simulations of the incremental sedimentation and compaction of stratigraphies typical of the Holocene of southern Louisiana. This approach generates distributions of present compaction rates that are not expected to exceed 5 mm/yr, but may locally. Locations with present subsidence rates greater than the predicted maximum probable shallow compaction rates are likely influenced by additional processes.
We have established for the first time a size frequency distribution for carbonate submarine slope failures. Using detailed bathymetry along the northern edge of the carbonate platform north of Puerto Rico, we show that the cumulative distribution of slope failure volumes follows a power-law distribution. The power-law exponent of this distribution is similar to those for rock falls on land, commensurate with their interpreted failure mode. The carbonate volume distribution and its associated volume-area relationship are significantly different from those for clay-rich debris lobes in the Storegga slide, Norway. Coupling this relationship with tsunami simulations allows an estimate of the maximum tsunami runup and the maximum number of potentially damaging tsunamis from landslides to the north shore of Puerto Rico. Copyright 2006 by the American Geophysical Union.
A major earthquake on the Seattle fault, Washington, ca. A.D. 900-930 was first inferred from uplifted shorelines and tsunami deposits. Despite follow-up geophysical and geological investigations, the rupture parameters of the earthquake and the geometry of the fault are uncertain. Here we estimate the fault geometry, slip direction, and magnitude of the earthquake by modeling shoreline elevation change. The best fitting model geometry is a reverse fault with a shallow roof ramp consisting of at least two back thrusts. The best fitting rupture is a SW-NE ohlique reverse slip with horizontal shortening of 15 m, rupture depth of 12.5 km, and magnitude Mw = 7.5. ?? 2006 Geological Society of America.
The spatial distribution of the earthquakes in the Arava Valley, a 150-km section of the Dead Sea Transform, is compared for the first time with the local subsurface geological features derived from geophysical and geological data. Gravity data suggested that the Gharandal, Timna, and Elat basins were filled by low-density young sediments. These features were confirmed by seismic reflection profiles and high-resolution aeromagnetic (HRAM) survey. The HRAM survey delineated the trace of the Dead Sea Transform (DST), which separates magnetic anomalies in the eastern and western parts of the valley, and revealed the occurrence of the unknown deep magmatics. Overall, the earthquake activity appears to be strongly related to the Dead Sea Transform. However, on a local scale, there is no apparent correlation between the seismicity and the mapped fault segments comprising the DST fault system. Absence of the correlation may be a result of insufficient accuracy of the earthquake localization and/or the inclined fault plane. However, in spite of such inaccuracy, it is clearly observed that the large clusters of the low-magnitude earthquakes coincide well with the sedimentary basins. Two pronounced clusters appear to coincide with the subsurface magmatics. We assume that the subsurface geology predetermines areas of stress accumulation and earthquakes. These areas can be the end of faults, or fault jogs, which sometimes create basins. Magmatism can also be affected by the stress field and predetermine the stress and earthquakes' allocation. ?? 2007 Science From Israel/LPPLtd.
On September 24-30, 2002, six days of scientific surveying to map a section of the Puerto Rico Trench (PRT) took place aboard the National Oceanic and Atmospheric Administration (NOAA) ship Ron Brown. The cruise was funded by NOAA's Office of Ocean Exploration. Multibeam bathymetry and acoustic-backscatter data were collected over an area of about 25,000 sq. km of the Puerto Rico trench and its vicinity at water depths of 4000-8400 m. Weather conditions during the entire survey were good; there were light to moderate winds and 1-2 foot swells experiencing minor chop. The roll and pitch of the ship's interaction with the ocean were not conspicuous. Cruise participants included personnel from USGS, NOAA, and University of New Hampshire Center for Coastal and Ocean Mapping/Joint Hydrographic Center. The cruise resulted in the discovery of a major active strike-slip fault system close to the trench, submarine slides on the descending North American tectonic plate, and an extinct mud volcano, which was cut by the strike-slip fault system. Another strike-slip fault system closer to Puerto Rico that was previously considered to accommodate much of the relative plate motion appears to be inactive. The seaward continuation of the Mona Rift, a zone of extension between Puerto Rico and the Dominican Republic that generated a devastating tsunami in 1918, was mapped for the first time.
The Puerto Rico trench exhibits great water depth, an extremely low gravity anomaly, and a tilted carbonate platform between (reconstructed) elevations of +1300 m and -4000 m. I argue that these features are manifestations of large vertical movements of a segment of the Puerto Rico trench, its forearc, and the island of Puerto Rico that took place 3.3 m.y. ago over a time period as short as 14-40 kyr. I explain these vertical movements by a sudden increase in the slab's descent angle that caused the trench to subside and the island to rise. The increased dip could have been caused by shearing or even by a complete tear of the descending North American slab, although the exact nature of this deformation is unknown. The rapid (14-40 kyr) and uniform tilt along a 250 km long section of the trench is compatible with scales of mantle flow and plate bending. The proposed shear zone or tear is inferred from seismic, morphological, and gravity observations to start at the trench at 64.5??W and trend southwestwardly toward eastern Puerto Rico. The tensile stresses necessary to deform or tear the slab could have been generated by increased curvature of the trench following a counterclockwise rotation of the upper plate and by the subduction of a large seamount.
No abstract available.
Explore the source record for details and available documents.
Strike-slip faults in the forearc region of a subduction zone often present significant seismic hazard because of their proximity to population centers. We explore the interaction between thrust events on the subduction interface and strike-slip faults within the forearc region using three-dimensional models of static Coulomb stress change. Model results reveal that subduction earthquakes with slip vectors subparallel to the trench axis enhance the Coulomb stress on strike-slip faults adjacent to the trench but reduce the stress on faults farther back in the forearc region. In contrast, subduction events with slip vectors perpendicular to the trench axis enhance the Coulomb stress on strike-slip faults farther back in the forearc, while reducing the stress adjacent to the trench. A significant contribution to Coulomb stress increase on strike-slip faults in the back region of the forearc comes from "unclamping" of the fault, i.e., reduction in normal stress due to thrust motion on the subduction interface. We argue that although Coulomb stress changes from individual subduction earthquakes are ephemeral, their cumulative effects on the pattern of lithosphere deformation in the forearc region are significant. We use the Coulomb stress models to explain the contrasting deformation pattern between two adjacent segments of the Caribbean subduction zone. Subduction earthquakes with slip vectors nearly perpendicular to the Caribbean trench axis is dominant in the Hispaniola segment, where the strike-slip faults are more than 60 km inland from the trench. In contrast, subduction slip motion is nearly parallel to the Caribbean trench axis along the Puerto Rico segment, where the strike-slip fault is less than 15 km from the trench. This observed jump from a strike-slip fault close to the trench axis in the Puerto Rico segment to the inland faults in Hispaniola is explained by different distributions of Coulomb stress in the forearc region of the two segments, as a result of the change from the nearly trench parallel slip on the Puerto Rico subduction interface to the more perpendicular subduction slip beneath Hispaniola. The observations and modeling suggest that subduction-induced strike-slip seismic hazard to Puerto Rico may be smaller than previously assumed but the hazard to Hispaniola remains high. Copyright 2004 by the American Geophysical Union.
Explore the source record for details and available documents.
A moored-buoy system for collecting real-time seismic data from the coastal ocean has been developed and will be deployed for its initial field trial in the fall of 2003. The key component in this moored system is an ultra-stretchy mooring hose that provides compliance for waves and currents and protects the electrical conductors connecting an Ocean Bottom Seismometer (OBS) to a surface buoy from the effects of bending and stretching. This hose is able to stretch to more than twice its unstretched length of 30 m without putting excessive strain on the electrical conductors embedded in its wall. In the initial trials of this system, the OBS will be deployed on the bottom in 40 m of water and connected to the mooring hose through a cable on the seafloor. It will transmit continuous data at a rate of about 5,000 bps to a radio link in the surface buoy. A repeater modem located at the Gay Head lighthouse on Martha's Vineyard about 18 km from the mooring site will receive the transmissions and forward the data to our laboratory at WHOI, about 46 km distant. A GPS receiver on the surface buoy will be configured to send accurate and synchronized time to the OBS on the seafloor, which will make it possible to include data from these undersea systems in the existing seismic data network without the need for any preprocessing. Power to operate the RF link and the OBS will be supplied by solar panels and rechargeable batteries on the surface buoy.
Explore the source record for details and available documents.
We use the 3-D gravity inversion technique to model the shape of the Hula basin, a pull-apart basin along the Dead Sea Transform. The interpretation was constrained using the Notera-3-well density logs and current geological knowledge. The model obtained by inversion shows a rhomb-shaped graben filled with approximately 4 km of young sediments in the deepest part of the basin. The reliability of this model was verified using 3-D forward modeling with an accuracy of 0.5 km. Curvature attributes of the gravity field depict the main fault pattern, suggesting that the Hula basin is a subsiding rhomb-shaped graben, bordered by steep-sided, deep basement faults on the western and eastern sides (Qiryat Shemona and Jordan River faults) and by gradual, en-echelon step faults on the southern and northern margins of the basin. ?? 2003 Laser Pages Publishing Ltd.
The Cenozoic rift system of Baikal, located in the interior of the largest continental mass on Earth, is thought to represent a potential analog of the early stage of breakup of supercontinents. We present a detailed P wave velocity structure of the crust and sediments beneath the Central Basin, the deepest basin in the Baikal rift system. The structure is characterized by a Moho depth of 39–42.5 km; an 8-km-thick, laterally continuous high-velocity (7.05–7.4 km/s) lower crust, normal upper mantle velocity (8 km/s), a sedimentary section reaching maximum depths of 9 km, and a gradual increase of sediment velocity with depth. We interpret the high-velocity lower crust to be part of the Siberian Platform that was not thinned or altered significantly during rifting. In comparison to published results from the Siberian Platform, Moho under the basin is elevated by <3 km. On the basis of these results we propose that the basin was formed by upper crustal extension, possibly reactivating structures in an ancient fold-and-thrust belt. The extent and location of upper mantle extension are not revealed by our data, and it may be offset from the rift. We believe that the Baikal rift structure is similar in many respects to the Mesozoic Atlantic rift system, the precursor to the formation of the North Atlantic Ocean. We also propose that the Central Baikal rift evolved by episodic fault propagation and basin enlargement, rather than by two-stage rift evolution as is commonly assumed.
We interpret large-scale subsidence (5–6 km depth) with little attendant brittle deformation in the southern Dead Sea basin, a large pull-apart basin along the Dead Sea transform plate boundary, to indicate lower crustal thinning due to lower crustal flow. Along-axis flow within the lower crust could be induced by the reduction of overburden pressure in the central Dead Sea basin, where brittle extensional deformation is observed. Using a channel flow approximation, we estimate that lower crustal flow would occur within the time frame of basin subsidence if the viscosity is ≤7×10 19 –1×10 21 Pa s, a value compatible with the normal heat flow in the region. Lower crustal viscosity due to the strain rate associated with basin extension is estimated to be similar to or smaller than the viscosity required for a channel flow. However, the viscosity under the basin may be reduced to 5×10 17 –5×10 19 Pa s by the enhanced strain rate due to lateral shear along the transform plate boundary. Thus, lower crustal flow facilitated by shear may be a viable mechanism to enlarge basins and modify other topographic features even in the absence of underlying thermal anomalies.
No abstract available.