Geology Reports⌕ Search

Geology topics

Trond Ryberg

Publications and source records attributed to Trond Ryberg.

7 recordsLinked to original sources

Reference 1D seismic velocity models for volcano monitoring and imaging: Methods, models, and applications

Seismic velocity models of the crust are an integral part of earthquake monitoring systems at volcanoes. 1D models that vary only in depth are typically used for real‐time hypocenter determination and serve as critical reference models for detailed 3D imaging studies and geomechanical modeling. Such models are usually computed using seismic tomographic methods that rely on P ‐ and S ‐wave arrival‐time picks from numerous earthquakes recorded at receivers around the volcano. Traditional linearized tomographic methods that jointly invert for source locations, velocity structure, and station corrections depend critically on having reasonable starting values for the unknown parameters, are susceptible to local misfit minima and divergence, and often do not provide adequate uncertainty information. These issues are often exacerbated by sparse seismic networks, inadequate distributions of seismicity, and/or poor data quality common at volcanoes. In contrast, modern probabilistic global search methods avoid these issues only at the cost of increased computation time. In this article, we review both approaches and present example applications and comparisons at several volcanoes in the United States, including Mount Hood (Oregon), Mount St. Helens (Washington), the Island of Hawai’i, and Mount Cleveland (Alaska). We provide guidance on the proper usage of these methods as relevant to challenges specific to volcano monitoring and imaging. Finally, we survey‐published 1D P ‐wave velocity models from around the world and use them to derive a generic stratovolcano velocity model, which serves as a useful reference model for comparison and when local velocity information is sparse.

Seismological Research Letters↗

Subsurface geometry of the San Andreas fault in southern California: Results from the Salton Seismic Imaging Project (SSIP) and strong ground motion expectations

The San Andreas fault (SAF) is one of the most studied strike‐slip faults in the world; yet its subsurface geometry is still uncertain in most locations. The Salton Seismic Imaging Project (SSIP) was undertaken to image the structure surrounding the SAF and also its subsurface geometry. We present SSIP studies at two locations in the Coachella Valley of the northern Salton trough. On our line 4, a fault‐crossing profile just north of the Salton Sea, sedimentary basin depth reaches 4 km southwest of the SAF. On our line 6, a fault‐crossing profile at the north end of the Coachella Valley, sedimentary basin depth is &#x223C; 2 &#x2013; 3 &#x2009;&#x2009; km "> ∼ 2 – 3 km and centered on the central, most active trace of the SAF. Subsurface geometry of the SAF and nearby faults along these two lines is determined using a new method of seismic‐reflection imaging, combined with potential‐field studies and earthquakes. Below a 6–9 km depth range, the SAF dips &#x223C; 50 &#xB0; &#x2013; 60 &#xB0; "> ∼ 50 ° – 60 ° NE, and above this depth range it dips more steeply. Nearby faults are also imaged in the upper 10 km, many of which dip steeply and project to mapped surface fault traces. These secondary faults may join the SAF at depths below about 10 km to form a flower‐like structure. In Appendix D , we show that rupture on a northeast‐dipping SAF, using a single plane that approximates the two dips seen in our study, produces shaking that differs from shaking calculated for the Great California ShakeOut, for which the southern SAF was modeled as vertical in most places: shorter‐period ( T &lt; 1 &#x2009;&#x2009; s "> T < 1 s ) shaking is increased locally by up to a factor of 2 on the hanging wall and is decreased locally by up to a factor of 2 on the footwall, compared to shaking calculated for a vertical fault.

California↗

Seismic imaging of the Waltham Canyon fault, California: comparison of ray‐theoretical and Fresnel volume prestack depth migration

Near‐vertical faults can be imaged using reflected refractions identified in controlled‐source seismic data. Often theses phases are observed on a few neighboring shot or receiver gathers, resulting in a low‐fold data set. Imaging can be carried out with Kirchhoff prestack depth migration in which migration noise is suppressed by constructive stacking of large amounts of multifold data. Fresnel volume migration can be used for low‐fold data without severe migration noise, as the smearing along isochrones is limited to the first Fresnel zone around the reflection point. We developed a modified Fresnel volume migration technique to enhance imaging of steep faults and to suppress noise and undesired coherent phases. The modifications include target‐oriented filters to separate reflected refractions from steep‐dipping faults and reflections with hyperbolic moveout. Undesired phases like multiple reflections, mode conversions, direct P and S waves, and surface waves are suppressed by these filters. As an alternative approach, we developed a new prestack line‐drawing migration method, which can be considered as a proxy to an infinite frequency approximation of the Fresnel volume migration. The line‐drawing migration is not considering waveform information but requires significantly shorter computational time. Target‐oriented filters were extended by dip filters in the line‐drawing migration method. The migration methods were tested with synthetic data and applied to real data from the Waltham Canyon fault, California. The two techniques are applied best in combination, to design filters and to generate complementary images of steep faults.

California↗

Report for borehole explosion data acquired in the 1999 Los Angeles Region Seismic Experiment (LARSE II), Southern California: Part I, description of the survey

The Los Angeles Region Seismic Experiment (LARSE) is a joint project of the U.S. Geological Survey (USGS) and the Southern California Earthquake Center (SCEC). The purpose of this project is to produce seismic images of the subsurface of the Los Angeles region down to the depths at which earthquakes occur, and deeper, in order to remedy a deficit in our knowledge of the deep structure of this region. This deficit in knowledge has persisted despite over a century of oil exploration and nearly 70 years of recording earthquakes in southern California. Understanding the deep crustal structure and tectonics of southern California is important to earthquake hazard assessment. Specific imaging targets of LARSE include (a) faults, especially blind thrust faults, which cannot be reliably detected any other way; and (b) the depths and configurations of sedimentary basins. Imaging of faults is important in both earthquake hazard assessment but also in modeling earthquake occurrence. Earthquake occurrence cannot be understood unless the earthquake-producing "machinery" (tectonics) is known (Fuis and others, 2001). Imaging the depths and configurations of sedimentary basins is important because earthquake shaking at the surface is enhanced by basin depth and by the presence of sharp basin edges (Wald and Graves, 1998, Working Group on California Earthquake Probabilities, 1995; Field and others, 2001). (Sedimentary basins are large former valleys now filled with sediment eroded from nearby mountains.) Sedimentary basins in the Los Angeles region that have been investigated by LARSE include the Los Angeles, San Gabriel Valley, San Fernando Valley, and Santa Clarita Valley basins. The seismic imaging surveys of LARSE include recording of earthquakes (both local and distant earthquakes) along several corridors (or transects) through the Los Angeles region and also recording of man-made sources along these same corridors. Man-made sources have included airguns offshore and borehole explosions and vibrating-truck sources onshore. The two chief LARSE transects pass near recent moderate earthquakes, including the 1971 M 6.7 San Fernando, 1987 M 5.9 Whittier Narrows, 1991 M 5.8 Sierra Madre, and 1994 M 6.7 Northridge earthquakes. The first transect extended from San Clemente Island northeastward to the Mojave Desert (Line 1, Fig. 1), passing near the epicenter of the Whittier Narrows and Sierra Madre earthquakes. The second transect extended from west of San Clemente Island northward to the western Mojave Desert (Line 2, Figs. 1, 2), passing through the epicenter of the Northridge earthquake and near the epicenter of the San Fernando earthquake. Data along Line 1 were acquired during the years 1993-1994, and data along Line 2, during the years 1994–2000. In this open-file report and that of Murphy and others (in preparation), we present the details of the October 1999 explosion survey along Line 2, which extended from Santa Monica Bay northward to the western Mojave Desert (Figs. 1, 2). This survey is referred to as LARSE II. In this survey, 93 borehole explosions were detonated along the main north-south line and along 5 auxiliary lines in the San Fernando Valley and Santa Monica areas. These explosions were recorded by ~1400 seismographs. A variety of seismic instrumentation was used in these imaging surveys and was obtained from collaborators from around the world, including the Geological Survey of Canada (Ottawa, Canada), IRIS/PASSCAL (Socorro, NM), Lamont-Doherty Earth Observatory (Palisades, NY), Stanford University (Stanford, CA), SCEC (Los Angeles, CA), USGS (Menlo Park, CA, and Woods Hole, MA), University of Texas at El Paso (El Paso, TX), GeoForschungsZentrum (Potsdam, Germany), University of Karlsruhe (Karlsruhe, Germany), and University of Copenhagen (Copenhagen, Denmark). The reader is referred to Table 1 for instrumentation used in LARSE II.

California↗

The "LARSE" Project - Working Toward a Safer Future for Los Angeles

The Los Angeles region is underlain by a network of active faults, including many that are deep and do not break the Earth's surface. These hidden faults include the previously unknown one responsible for the devastating January 1994 Northridge earthquake, the costliest quake in U.S. history. So that structures can be built or strengthened to withstand the quakes that are certain in the future, the Los Angeles Region Seismic Experiment (LARSE) is locating hidden earthquake hazards beneath the region to help scientists determine where the strongest shaking will occur.

California↗

El Proyecto Sismico "LARSE" - Trabajando Hacia un Futuro con Mas Seguridad para Los Angeles

La region de Los Angeles contiene una red de fallas activas, incluyendo muchas fallas por empuje que son profundas y no rompen la superficie de la tierra. Estas fallas ocultas incluyen la falla anteriormente desconocida que fue responsable por la devastacion que ocurrio durante el terremoto de Northridge en enero de 1994, el terremoto mas costoso en la historia de los Estados Unidos. El Experimento Sismico en la Region de Los Angeles (Los Angeles Region Seismic Experiment, LARSE), esta localizando los peligros ocultos de los terremotos debajo de la region de Los Angeles para mejorar la construccion de las estructuras que pueden apoyar terremotos que son inevitables en el futuro, y que ayudaran a los cientificos determinar donde occurira el sacudimento mas fuerte y poderoso.

Fact Sheet↗