Geology topics

Trevor P. Irons

Publications and source records attributed to Trevor P. Irons.

4 recordsLinked to original sources

USGS2014

Magnetic resonance sounding survey data collected in the North Platte, Twin Platte, and South Platte Natural Resource Districts, Western Nebraska, Fall 2012

This report is a release of digital data and associated survey descriptions from a series of magnetic resonance soundings (MRS, also known as surface nuclear magnetic resonance) that was conducted during October and November of 2012 in areas of western Nebraska as part of a cooperative hydrologic study by the North Platte Natural Resource District (NRD), South Platte NRD, Twin Platte NRD, the Nebraska Environmental Trust, and the U.S. Geological Survey (USGS). The objective of the study was to delineate the base-of-aquifer and refine the understanding of the hydrologic properties in the aquifer system. The MRS technique non-invasively measures water content in the subsurface, which makes it a useful tool for hydrologic investigations in the near surface (up to depths of approximately 150 meters). In total, 14 MRS production-level soundings were acquired by the USGS over an area of approximately 10,600 square kilometers. The data are presented here in digital format, along with acquisition information, survey and site descriptions, and metadata.

Nebraska↗

USGS2014

Using nuclear magnetic resonance and transient electromagnetics to characterise water distribution beneath an ice covered volcanic crater: The case of Sherman Crater Mt. Baker Washington.

Surface and laboratory Nuclear Magnetic Resonance (NMR) measurements combined with transient electromagnetic (TEM) data are powerful tools for subsurface water detection. Surface NMR (sNMR) and TEM soundings, laboratory NMR, complex resistivity, and X-Ray Diffraction (XRD) analysis were all conducted to characterise the distribution of water within Sherman Crater on Mt. Baker, WA. Clay rich rocks, particularly if water saturated, can weaken volcanoes, thereby increasing the potential for catastrophic sector collapses that can lead to far-travelled, destructive debris flows. Detecting the presence and volume of shallow groundwater is critical for evaluating these landslide hazards. The TEM data identified a low resistivity layer (<10 ohm-m), under 60 m of glacial ice related to water saturated clays. The TEM struggles to resolve the presence or absence of a plausible thin layer of bulk liquid water on top of the clay. The sNMR measurements did not produce any observable signal, indicating the lack of substantial accumulated bulk water below the ice. Laboratory analysis on a sample from the crater wall that likely represented the clays beneath the ice confirmed that the controlling factor for the lack of sNMR signal was the fine-grained nature of the media. The laboratory measurements further indicated that small pores in clays detected by the XRD contain as much as 50% water, establishing an upper bound on the water content in the clay layer. Forward modelling of geologic scenarios revealed that bulk water layers as thin as ½ m between the ice and clay layer would have been detectable using sNMR. The instrumentation conditions which would allow for sNMR detection of the clay layer are investigated. Using current instrumentation the combined analysis of the TEM and sNMR data allow for valuable characterisation of the groundwater system in the crater. The sNMR is able to reduce the uncertainty of the TEM in regards to the presence of a bulk water layer, a valuable piece of information in hazard assessment.

Washington↗

USGS2012

Quantification of aquifer properties with surface nuclear magnetic resonance in the Platte River valley, central Nebraska, using a novel inversion method

Surface nuclear magnetic resonance, a noninvasive geophysical method, measures a signal directly related to the amount of water in the subsurface. This allows for low-cost quantitative estimates of hydraulic parameters. In practice, however, additional factors influence the signal, complicating interpretation. The U.S. Geological Survey, in cooperation with the Central Platte Natural Resources District, evaluated whether hydraulic parameters derived from surface nuclear magnetic resonance data could provide valuable input into groundwater models used for evaluating water-management practices. Two calibration sites in Dawson County, Nebraska, were chosen based on previous detailed hydrogeologic and geophysical investigations. At both sites, surface nuclear magnetic resonance data were collected, and derived parameters were compared with results from four constant-discharge aquifer tests previously conducted at those same sites. Additionally, borehole electromagnetic-induction flowmeter data were analyzed as a less-expensive surrogate for traditional aquifer tests. Building on recent work, a novel surface nuclear magnetic resonance modeling and inversion method was developed that incorporates electrical conductivity and effects due to magnetic-field inhomogeneities, both of which can have a substantial impact on the data. After comparing surface nuclear magnetic resonance inversions at the two calibration sites, the nuclear magnetic-resonance-derived parameters were compared with previously performed aquifer tests in the Central Platte Natural Resources District. This comparison served as a blind test for the developed method. The nuclear magnetic-resonance-derived aquifer parameters were in agreement with results of aquifer tests where the environmental noise allowed data collection and the aquifer test zones overlapped with the surface nuclear magnetic resonance testing. In some cases, the previously performed aquifer tests were not designed fully to characterize the aquifer, and the surface nuclear magnetic resonance was able to provide missing data. In favorable locations, surface nuclear magnetic resonance is able to provide valuable noninvasive information about aquifer parameters and should be a useful tool for groundwater managers in Nebraska.

Nebraska↗

USGS2009

Inversion of multichannel geophysical data with projected kernels

Statistical de‐noising methods such as Principal Component Analysis modify data in a way not constrained by physics. In much the same way as frequency‐filtered data must incorporate altered frequency content into numerical interpretation, so must statistically rotated data include the rotation operator in inversion processes. We propose a method of accounting for statistical reduction of data in non‐linear inversions (such as for electromagnetic data) through an incorporation of the rotation operator into the kernels and sensitivity matrix. We show a generalized linear inversion to demonstrate the necessity of rotating the inversion kernels in this abstract and will present a nonlinear parametric example from an unexploded ordnance application.

Conference Paper↗