Geology topics

S. Wright

Publications and source records attributed to S. Wright.

4 recordsLinked to original sources

USGS2010

Modeling downstream fining in sand-bed rivers. I: Formulation

In this paper a numerical modeling formulation is presented for simulation of the development of the longitudinal profile and bed sediment distribution in sand-bed rivers. The objective of the model application, which is presented in the companion paper (Wright and Parker, 2005), is to study the development of two characteristics of large, low-slope, sand-bed rivers: (1) a downstream decrease in bed slope (i.e. concave upward longitudinal profile) and (2) a downstream decrease in characteristic bed sediment diameter (e.g. the median bed surface size D 50 ). Three mechanisms that lead to an upward concave profile and downstream fining are included in the modeling formulation: (1) a delta prograding into standing water at the downstream boundary, (2) sea-level rise, and (3) tectonic subsidence. In the companion paper (Wright and Parker, 2005) the model is applied to simulate the development of the longitudinal profile and downstream fining in sand-bed rivers flowing into the ocean during the past 5000 years of relatively slow sea-level rise.

Journal of Hydraulic Research↗

USGS2010

Modeling downstream fining in sand-bed rivers. II: Application

In this paper the model presented in the companion paper, Wright and Parker (2005) is applied to a generic river reach typical of a large, sand-bed river flowing into the ocean in order to investigate the mechanisms controlling longitudinal profile development and downstream fining. Three mechanisms which drive downstream fining are studied: a delta prograding into standing water, sea-level rise, and tectonic subsidence. Various rates of sea-level rise (typical of the late Holocene) and tectonic subsidence are modeled in order to quantify their effects on the degree of profile concavity and downstream fining. Also, several other physical mechanisms which may affect fining are studied, including the relative importance of the suspended versus bed load, the effect of the loss of sediment overbank, and the influence of the delta bottom slope. Finally, sensitivity analysis is used to show that the grain-size distribution at the interface between the active layer and substrate has a significant effect on downstream fining.

Journal of Hydraulic Research↗

USGS2004

Density stratification effects in sand-bed rivers

In this paper the effects of density stratification in sand-bed rivers are studied by the application of a model of vertical velocity and concentration profiles, coupled through the use of a turbulence closure that retains the buoyancy terms. By making the governing equations dimensionless, it is revealed that the slope is the additional dimensionless parameter introduced by inclusion of the buoyancy terms. The primary new finding is that in general density stratification effects tend to be greater in large, low-slope rivers than in their smaller, steeper brethren. Under high flow conditions the total suspended load and size distribution of suspended sediment can be significantly affected by density stratification, and should be accounted for in any general theory of suspended transport. ?? ASCE.

Journal of Hydraulic Engineering↗

USGS2004

Flow resistance and suspended load in sand-bed rivers: Simplified stratification model

New methods are presented for the prediction of the flow depth, grain-size specific near-bed concentration, and bed-material suspended sediment transport rate in sand-bed rivers. The salient improvements delineated here all relate to the need to modify existing formulations in order to encompass the full range of sand-bed rivers, and in particular large, low-slope sand-bed rivers. They can be summarized as follows: (1) the inclusion of density stratification effects in a simplified manner, which have been shown in the companion paper to be particularly relevant for large, low-slope, sand-bed rivers; (2) a new predictor for near-bed entrainment rate into suspension which extends a previous relation to the range of large, low-slope sand-bed rivers; and (3) a new predictor for form drag which again extends a previous relation to include large, low-slope sand-bed rivers. Finally, every attempt has been made to cast the relations in the simplest form possible, including the development of software, so that practicing engineers may easily use the methods. ?? ASCE.

Journal of Hydraulic Engineering↗