Russell A. Ludlow | Geology Reports

USGS2016

Estimated use of water in the Delaware River Basin in Delaware, New Jersey, New York, and Pennsylvania, 2010

The Delaware River Basin (DRB) was selected as a Focus Area Study in 2011 by the U.S. Geological Survey (USGS) as part of the USGS National Water Census. The National Water Census is a USGS research program that focuses on national water availability and use and then develops new water accounting tools and assesses water availability at both the regional and national scales. One of the water management needs that the DRB study addressed, and that was identified by stakeholder groups from the DRB, was to improve the integration of state water use and water-supply data and to provide the compiled water use information to basin users. This water use information was also used in the hydrologic modeling and ecological components of the study. Instream and offstream water use was calculated for 2010 for the DRB based on information received from Delaware, New Jersey, New York, and Pennsylvania. Water withdrawal, interbasin transfers, return flow, and hydroelectric power generation release data were compiled for 11 categories by hydrologic subregion, basin, subbasin, and subwatershed. Data availability varied by state. Site-specific data were used whenever possible to calculate public supply, irrigation (golf courses, nurseries, sod farms, and crops), aquaculture, self-supplied industrial, commercial, mining, thermoelectric, and hydroelectric power withdrawals. Where site-specific data were not available, primarily for crop irrigation, livestock, and domestic use, various techniques were used to estimate water withdrawals. Total water withdrawals in the Delaware River Basin were calculated to be about 7,130 million gallons per day (Mgal/d) in 2010. Calculations of withdrawals by source indicate that freshwater withdrawals were about 4,130 Mgal/d (58 percent of the total) and the remaining 3,000 Mgal/d (42 percent) were from saline water. Total surface-water withdrawals were calculated to be 6,590 Mgal/d, or 92 percent of the total; about 54 percent (3,590 Mgal/d) of surface water withdrawn was freshwater. Total groundwater withdrawals were calculated to be 545 Mgal/d (8 percent of the total), all of which was freshwater. During 2010, calculated withdrawals by category, in decreasing order, were: thermoelectric power, 4,910 Mgal/d; public supply, 1,490 Mgal/d; self-supplied industrial, 350 Mgal/d; irrigation, 175 Mgal/d; self-supplied domestic, 117 Mgal/d; mining, 41.3 Mgal/d; aquaculture, 19.3 Mgal/d; livestock, 6.72 Mgal/d, and commercial, 5.89 Mgal/d. The amount of instream use for hydroelectric power generation purposes in 2010 was reported to be 273 Mgal/d for the Wallenpaupack Plant and 127 Mgal/d for the Mongaup River system. Total return flows in the DRB were 2,960 Mgal/d in 2010. Although municipal wastewater-treatment plants accounted for 539 (97 percent) of the return-flow sites, they accounted for about 70 percent of the total return flows in the DRB. There was limited information on return flows from thermoelectric power.

Delaware, New Jersey, New York, Pennsylvania↗

USGS2004

Chester County ground-water atlas, Chester County, Pennsylvania

Chester County encompasses 760 square miles in southeastern Pennsylvania. Groundwater-quality studies have been conducted in the county over several decades to address specific hydrologic issues. This report compiles and describes water-quality data collected during studies conducted mostly after 1990 and summarizes the data in a county-wide perspective. In this report, water-quality constituents are described in regard to what they are, why the constituents are important, and where constituent concentrations vary relative to geology or land use. Water-quality constituents are grouped into logical units to aid presentation: water-quality constituents measured in the field (pH, alkalinity, specific conductance, and dissolved oxygen), common ions, metals, radionuclides, bacteria, nutrients, pesticides, and volatile organic compounds. Water-quality constituents measured in the field, common ions (except chloride), metals, and radionuclides are discussed relative to geology. Bacteria, nutrients, pesticides, and volatile organic compounds are discussed relative to land use. If the U.S. Environmental Protection Agency (USEPA) or Chester County Health Department has drinking water standards for a constituent, the standards are included. Tables and maps are included to assist Chester County residents in understanding the water-quality constituents and their distribution in the county. Ground water in Chester County generally is of good quality and is mostly acidic except in the carbonate rocks and serpentinite, where it is neutral to strongly basic. Calcium carbonate and magnesium carbonate are major constituents of these rocks. Both compounds have high solubility, and, as such, both are major contributors to elevated pH, alkalinity, specific conductance, and the common ions. Elevated pH and alkalinity in carbonate rocks and serpentinite can indicate a potential for scaling in water heaters and household plumbing. Low pH and low alkalinity in the schist, quartzite, and gneiss rocks can indicate a potential for corrosive water. The only constituent measured in the field that has a USEPA Secondary Maximum Contaminant Level (SMCL) is pH. The SMCL for pH is 6.5-8.5; 64 percent of samples analyzed for pH were acidic (below pH 6.5). Only 1 percent of samples were basic (above pH 8.5). Of the common ions, the USEPA has SMCLs for chloride, sulfate, and total dissolved solids. The USEPA has a SMCL and a Primary Maximum Contaminant Level (PMCL) for fluoride. Chloride is more closely related to land use than geology. In Chester County, chloride exceeded the SMCL (250 mg/L) only in 5 percent of the services (commercial services, community services, and military) land-use areas. No samples analyzed for sulfate exceeded the SMCL (250 mg/L). Only 3 percent of samples analyzed for total dissolved solids exceeded the SMCL (500 milligrams per liter) (mg/L). No samples analyzed for fluoride equaled or exceeded the SMCL (2.0 mg/L) or PMCL (4.0 mg/L). Iron concentrations exceeded the USEPA SMCL in 11 percent of samples and were highest in schist (14 percent) and gneiss (13 percent). Manganese concentrations exceeded the SMCL in 19 percent of samples and were highest in quartzite and schist (both 28 percent). Lead and arsenic were present in low concentrations: the highest concentrations of lead occurred in water from quartzite (8 percent exceeded the USEPA Action Level), and arsenic was detected mostly in Triassic sedimentary rocks (9 percent exceeded the USEPA PMCL). The highest concentrations of copper occurred more frequently in quartzite rocks, and to a lesser extent were evenly distributed between ground water in gneiss, schist, and Triassic sedimentary rocks. Elevated concentrations of radon-222 and the combined radium-226/radium-228 radionuclides were common in water from quartzite and schist. Gross alpha and gross beta particle activities were elevated in water from quartzite and carbonate rocks. In contrast, elevated concentrations of uranium primarily were measured in water from Triassic sedimentary and carbonate rocks. Despite a sampling bias towards agricultural land use, only two samples indicated the presence of fecal coliforms. Samples analyzed for nutrients generally exhibited low concentrations, but about 11 percent of samples collected for nitrate exceeded the USEPA PMCL. Only one nitrite sample (less than 1 percent) exceeded the respective USEPA PMCL. Approximately 190 samples were collected for each of the three pesticides in this report: lindane, dieldrin, and diazinon. Sampling was biased towards agricultural, low-medium density residential, and wooded land uses. Approximately 95 percent of samples for each pesticide were below minimum reporting levels (MRL). Only lindane has a USEPA PMCL, and only one sample exceeded the standard. Results for dieldrin and diazinon were similar, except results for two diazinon samples where concentrations were 57.0 and 490 micrograms per liter (μg/L). Volatile organic compounds in this report were analyzed in water from 198 samples. Sampling was biased towards agricultural, low-medium density residential, and wooded land uses. Two percent of samples analyzed for trichloroethylene and less than 1 percent of samples analyzed for tetrachloroethylene exceeded their respective USEPA PMCLs (each 5.0 μg/L). No samples analyzed for 1,1,1-trichloroethane exceeded the USEPA PMCL (200 μg/L). No samples analyzed for methyl tert-butyl ether exceeded the USEPA Drinking Water Advisory (20μg/L).

Open-File Report↗

USGS2000

Estimated water withdrawals and use in Pennsylvania, 1995

In practical terms, water use is divided into two basic types: instream use and offstream use. Instream use is water used in its natural channel, basin, or behind a dam and includes activities such as ﬁshing, boating, and other recreational activities. Instream use also includes hydroelectric power generation. Off-stream use is water pumped or diverted from its natural channel, basin, or aquifer. Off-stream uses are divided into the following categories: public supply, domestic, commercial, industrial, thermoelectric power, mining, livestock, and irrigation. This fact sheet provides an overview of offstream and hydroelectric power water use in Pennsylvania. It describes water withdrawals by source, water withdrawals and deliveries by category, changes in water use over time, and water-management responsibilities in the State.

Pennsylvania↗