Geology topics

Rebecca M. Harrington

Publications and source records attributed to Rebecca M. Harrington.

11 recordsLinked to original sources

USGS2025

Earthquake stress-drop values delineate spatial variations in maximum shear stress in the Japanese forearc lithosphere

Earthquake stress drop (Δσ) may increase with depth and stress in the brittle lithosphere. However, the range of uncertainty in Δσ and the lack of constraints on absolute stress make it difficult to establish whether they are correlated. Here, we investigate Δσ dependence on depth and maximum shear stress ( τ max ) based on ~11 years of seismicity in the northeastern Japanese forearc following the 2011 Tohoku-Oki megathrust earthquake. We interpret Δσ estimates computed using both individual spectra and spectral-ratio methods and find that Δσ exhibits a clear depth dependence within the seismically active upper ~60 km of the forearc lithosphere ( ~ 0.8 MPa per 10 km). We further compare Δσ values with quantitative τ max estimates from finite-element models of force balance. We find that median Δσ values increase with τ max in the brittle forearc lithosphere and that earthquake stress release is proportional to τ max . The dependence of Δσ on τ max explains the apparent depth dependence of Δσ and suggests that average Δσ values provide a relative measure of the stress at failure. In the northeastern Japanese forearc, Δσ values remained roughly constant in the decade following the Tohoku-Oki earthquake, suggesting negligible changes in failure stress in the forearc since the mainshock.

Communications Earth and Environment↗

USGS2023

Quantifying site effects and their influence on earthquake source parameter estimations using a dense array in Oklahoma

We investigate the effects of site response on source parameter estimates using earthquakes recorded by the LArge-n Seismic Survey in Oklahoma (LASSO). While it is well known that near-surface unconsolidated sediments can cause an apparent breakdown of earthquake self-similarity, the influence of laterally varying site conditions remains unclear. We analyze site conditions across the 1825-station array on a river plain within an area of 40 km by 23 km using vertical ground motions from 14 regional earthquakes. While the source radiation pattern controls P-wave ground motions below 8 Hz, the surface geology correlates with P-wave ground motions above 8 Hz and S-wave ground motions at 2–21 Hz. Stations installed in alluvial sediments have vertical ground motions that can exceed three times the array median. We use the variation of ground motion of regional earthquakes across the array as a proxy for site effects. The corner frequencies and stress drops of local earthquakes ( M L = 0.01–3) estimated using a standard single-spectra approach show negative correlations with the site-effect proxy, while the seismic moments show positive correlations. In contrast, the spectral-ratio approach effectively shows no correlation. The overall bias is small as expected for this relatively homogeneous structure; accurate estimation of site-related biases requires at least 30 stations. Correcting for site-related biases reduces the standard deviations of the source parameters by less than 13% of the total variations. Remaining variations are partially associated with source directivity and model misfits— as small earthquakes can have complex ruptures.

Oklahoma↗

USGS2020

Using a large-n seismic array to explore the robustness of spectral estimations

Spectral analysis is widely used to estimate and refine earthquake source parameters such as source radius, seismic moment, and stress drop. This study aims to quantify the precision of the single spectra and empirical Green's function spectral ratio approach using the Large‐ n Seismic Survey in Oklahoma (LASSO) array. The dense station coverage in an area of local saltwater disposal offers a unique opportunity to observe and quantify radiation pattern effects and subsequent precision of spectral estimates of small earthquakes ( M < 3). The results suggest that the precision of source properties estimated from direct phase arrivals for arrays with less than 20 stations should be assumed to be not less than 30% and could be as high as 150% if less than five stations are used. Furthermore, we do not see clear evidence for, or against, a scaling of stress drop with magnitude of small earthquakes ( M < 3) as observed by other studies.

Oklahoma↗

USGS2020

Subduction megathrust heterogeneity characterized from 3D seismic data

Megathrust roughness and structural complexity are thought to be controls on earthquake slip at subduction zones because they result in heterogeneity in shear strength and resolved stress. However, because active megathrust faults are difficult to observe, the causes and scales of complexity are largely unknown. Here we measured the in situ properties of the megathrust of the Middle America subduction zone in a three-dimensional seismic reflection volume to determine how fault properties vary. We quantify spatial variability in the megathrust roughness, overburden and rock physical properties. Heterogeneity in the megathrust roughness exists at length scales of a few kilometres because the megathrust is dissected by active lower-plate normal faults, which offset the megathrust and renewed fault roughness. Spatial variations in the rock physical properties at the plate interface are characterized by correlation length scales of hundreds of metres. Frontal prism taper, historical seismicity and the variation in earthquake stress drop values local to the megathrust are all affected by the heterogeneity at these length scales. Both geometric and rheological complexities may therefore control the mechanical behaviour of the subduction plate interface, which includes earthquake rupture characteristics.

Central America megathrust, Pacific Ocean↗

USGS2018

Induced earthquake families reveal distinctive evolutionary patterns near disposal wells

The timing of events in seismic sequences can provide insights into the physical processes controlling fault slip. In southern Kansas, the rate of earthquakes rose rapidly starting in 2013 following expansion of energy production into the area, demanding the disposal of large volumes of wastewater into deep wells. Seismicity catalogs that are complete to low magnitudes can provide insights into the physical processes that induce seismicity near wastewater disposal. We develop a catalog of over 130,000 earthquakes recorded in southern Kansas from mid‐March 2014 through December 2017 by applying a matched filter algorithm to an original catalog of 5,831 template earthquakes. Detections have nearly identical waveforms to their associated template event and represent slip on nearly co‐located sections of a fault. We select template events with at least 100 associated detections and examine the characteristics of these prolific families of earthquakes. We find that families located close (<10 km) to areas with significant volumes of injected fluids have near‐Poissonian interevent times and the families remain active over longer durations. Families farther from high‐volume injection wells show strong clustering of interevent times and shorter sequence durations. We conclude that increasing pore fluid pressures from nearby disposal of large volumes of wastewater is the primary driver of these long duration episodes, with earthquake‐earthquake interactions driving sequences at greater distance from the wells.

Kansas↗

USGS2016

3-D P- and S-wave velocity structure and low-frequency earthquake locations in the Parkfield, California region

To refine the 3-D seismic velocity model in the greater Parkfield, California region, a new data set including regular earthquakes, shots, quarry blasts and low-frequency earthquakes (LFEs) was assembled. Hundreds of traces of each LFE family at two temporary arrays were stacked with time–frequency domain phase weighted stacking method to improve signal-to-noise ratio. We extend our model resolution to lower crustal depth with LFE data. Our result images not only previously identified features but also low velocity zones (LVZs) in the area around the LFEs and the lower crust beneath the southern Rinconada Fault. The former LVZ is consistent with high fluid pressure that can account for several aspects of LFE behaviour. The latter LVZ is consistent with a high conductivity zone in magnetotelluric studies. A new Vs model was developed with S picks that were obtained with a new autopicker. At shallow depth, the low Vs areas underlie the strongest shaking areas in the 2004 Parkfield earthquake. We relocate LFE families and analyse the location uncertainties with the NonLinLoc and tomoDD codes. The two methods yield similar results.

California↗

USGS2016

Along-strike variations in fault frictional properties along the San Andreas Fault near Cholame, California from joint earthquake and low-frequency earthquake relocations

Recent observations of low‐frequency earthquakes (LFEs) and tectonic tremor along the Parkfield–Cholame segment of the San Andreas fault suggest slow‐slip earthquakes occur in a transition zone between the shallow fault, which accommodates slip by a combination of aseismic creep and earthquakes (<15  km depth), and the deep fault, which accommodates slip by stable sliding (>35  km depth). However, the spatial relationship between shallow earthquakes and LFEs remains unclear. Here, we present precise relocations of 34 earthquakes and 34 LFEs recorded during a temporary deployment of 13 broadband seismic stations from May 2010 to July 2011. We use the temporary array waveform data, along with data from permanent seismic stations and a new high‐resolution 3D velocity model, to illuminate the fine‐scale details of the seismicity distribution near Cholame and the relation to the distribution of LFEs. The depth of the boundary between earthquakes and LFE hypocenters changes along strike and roughly follows the 350°C isotherm, suggesting frictional behavior may be, in part, thermally controlled. We observe no overlap in the depth of earthquakes and LFEs, with an &sim;5  km separation between the deepest earthquakes and shallowest LFEs. In addition, clustering in the relocated seismicity near the 2004 M w 6.0 Parkfield earthquake hypocenter and near the northern boundary of the 1857 M w 7.8 Fort Tejon rupture may highlight areas of frictional heterogeneities on the fault where earthquakes tend to nucleate.

California↗

USGS2015

Using a modified time-reverse imaging technique to locate low-frequency earthquakes on the San Andreas Fault near Cholame, California

We present a new method to locate low-frequency earthquakes (LFEs) within tectonic tremor episodes based on time-reverse imaging techniques. The modified time-reverse imaging technique presented here is the first method that locates individual LFEs within tremor episodes within 5 km uncertainty without relying on high-amplitude P-wave arrivals and that produces similar hypocentral locations to methods that locate events by stacking hundreds of LFEs without having to assume event co-location. In contrast to classic time-reverse imaging algorithms, we implement a modification to the method that searches for phase coherence over a short time period rather than identifying the maximum amplitude of a superpositioned wavefield. The method is independent of amplitude and can help constrain event origin time. The method uses individual LFE origin times, but does not rely on a priori information on LFE templates and families.We apply the method to locate 34 individual LFEs within tremor episodes that occur between 2010 and 2011 on the San Andreas Fault, near Cholame, California. Individual LFE location accuracies range from 2.6 to 5 km horizontally and 4.8 km vertically. Other methods that have been able to locate individual LFEs with accuracy of less than 5 km have mainly used large-amplitude events where a P-phase arrival can be identified. The method described here has the potential to locate a larger number of individual low-amplitude events with only the S-phase arrival. Location accuracy is controlled by the velocity model resolution and the wavelength of the dominant energy of the signal. Location results are also dependent on the number of stations used and are negligibly correlated with other factors such as the maximum gap in azimuthal coverage, source–station distance and signal-to-noise ratio.

California↗

USGS2015

Isolated cases of remote dynamic triggering in Canada detected using cataloged earthquakes combined with a matched-filter approach

Here we search for dynamically triggered earthquakes in Canada following global main shocks between 2004 and 2014 with M S  > 6, depth < 100 km, and estimated peak ground velocity > 0.2 cm/s. We use the Natural Resources Canada (NRCan) earthquake catalog to calculate β statistical values in 1° × 1° bins in 10 day windows before and after the main shocks. The statistical analysis suggests that triggering may occur near Vancouver Island, along the border of the Yukon and Northwest Territories, in western Alberta, western Ontario, and the Charlevoix seismic zone. We also search for triggering in Alberta where denser seismic station coverage renders regional earthquake catalogs with lower completeness thresholds. We find remote triggering in Alberta associated with three main shocks using a matched-filter approach on continuous waveform data. The increased number of local earthquakes following the passage of main shock surface waves suggests local faults may be in a critically stressed state.

Alberta↗

USGS2015

Self-similar rupture implied by scaling properties of volcanic earthquakes occurring during the 2004-2008 eruption of Mount St. Helens, Washington

We analyze a group of 6073 low-frequency earthquakes recorded during a week-long temporary deployment of broadband seismometers at distances of less than 3 km from the crater at Mount St. Helens in September of 2006. We estimate the seismic moment ( M 0 ) and spectral corner frequency ( f 0 ) using a spectral ratio approach for events with a high signal-to-noise (SNR) ratio that have a cross-correlation coefficient of 0.8 or greater with at least five other events. A cluster analysis of cross-correlation values indicates that the group of 421 events meeting the SNR and cross-correlation criteria forms eight event families that exhibit largely self-similar scaling. We estimate the M 0 and f 0 values of the 421 events and calculate their static stress drop and scaled energy ( E R / M 0 ) values. The estimated values suggest self-similar scaling within families, as well as between five of eight families (i.e., and constant). We speculate that differences in scaled energy values for the two families with variable scaling may result from a lack of resolution in the velocity model. The observation of self-similar scaling is the first of its kind for such a large group of low-frequency volcanic tectonic events occurring during a single active dome extrusion eruption.

Journal of Geophysical Research B: Solid Earth↗

USGS2013

Semiautomated tremor detection using a combined cross-correlation and neural network approach

Despite observations of tectonic tremor in many locations around the globe, the emergent phase arrivals, low‒amplitude waveforms, and variable event durations make automatic detection a nontrivial task. In this study, we employ a new method to identify tremor in large data sets using a semiautomated technique. The method first reduces the data volume with an envelope cross‒correlation technique, followed by a Self‒Organizing Map (SOM) algorithm to identify and classify event types. The method detects tremor in an automated fashion after calibrating for a specific data set, hence we refer to it as being “semiautomated”. We apply the semiautomated detection algorithm to a newly acquired data set of waveforms from a temporary deployment of 13 seismometers near Cholame, California, from May 2010 to July 2011. We manually identify tremor events in a 3 week long test data set and compare to the SOM output and find a detection accuracy of 79.5%. Detection accuracy improves with increasing signal‒to‒noise ratios and number of available stations. We find detection completeness of 96% for tremor events with signal‒to‒noise ratios above 3 and optimal results when data from at least 10 stations are available. We compare the SOM algorithm to the envelope correlation method of Wech and Creager and find the SOM performs significantly better, at least for the data set examined here. Using the SOM algorithm, we detect 2606 tremor events with a cumulative signal duration of nearly 55 h during the 13 month deployment. Overall, the SOM algorithm is shown to be a flexible new method that utilizes characteristics of the waveforms to identify tremor from noise or other seismic signals.

California↗