Integrated surface and borehole strong-motion, soil-response arrays in San Francisco, California: Empirical measurements of low-strain site coefficients at site class E and D soil sites
An integrated set of four borehole arrays and ten surface installations is installed in the city of San Francisco, California to measure the response of soft-soil deposits to strong earthquake ground motions. The borehole arrays extend through thick layers of soft water-saturated soils of Holocene age and older more consolidated soils of Pleistocene age into bedrock at depths up to 90 m. The surface installations are configured in pairs to provide simultaneous comparative surface measurements of soft soils and nearby rock. The rock locations also permit comparative measurements of rock as observed at the surface and in nearby boreholes. The arrays are designed to address a wide variety of scientific and engineering issues, and especially the issue of anelastic and nonlinear soil response at high strain levels as might be recorded during a large regional earthquake. Recordings of ground motions from the largest regional earthquakes which have occurred since the installation of the arrays show marked evidence of amplification as measured on the borehole and surface arrays. Implications of the results for low-strain site coefficients in present U.S. building codes are discussed.