Geology topics
R.D. Norris
Publications and source records attributed to R.D. Norris.
Unusual July 10, 1996, rock fall at Happy Isles, Yosemite National Park, California
Effects of the July 10, 1996, rock fall at Happy Isles in Yosemite National Park, California, were unusual compared to most rock falls. Two main rock masses fell about 14 s apart from a 665-m-high cliff southeast of Glacier Point onto a talus slope above Happy Isles in the eastern part of Yosemite Valley. The two impacts were recorded by seismographs as much as 200 km away. Although the impact area of the rock falls was not particularly large, the falls generated an airblast and an abrasive dense sandy cloud that devastated a larger area downslope of the impact sites toward the Happy Isles Nature Center. Immediately downslope of the impacts, the airblast had velocities exceeding 110 m/s and toppled or snapped about 1000 trees. Even at distances of 0.5 km from impact, wind velocities snapped or toppled large trees, causing one fatality and several serious injuries beyond the Happy Isles Nature Center. A dense sandy cloud trailed the airblast and abraded fallen trunks and trees left standing. The Happy Isles rock fall is one of the few known worldwide to have generated an airblast and abrasive dense sandy cloud. The relatively high velocity of the rock fall at impact, estimated to be 110-120 m/s, influenced the severity and areal extent of the airblast at Happy Isles. Specific geologic and topographic conditions, typical of steep glaciated valleys and mountainous terrain, contributed to the rock-fall release and determined its travel path, resulting in a high velocity at impact that generated the devastating airblast and sandy cloud. The unusual effects of this rock fall emphasize the importance of considering collateral geologic hazards, such as airblasts from rock falls, in hazard assessment and planning development of mountainous areas.
Synchroneity of the K-T oceanic mass extinction and meteorite impact: Blake Nose, western North Atlantic
A 10-cm-thick layer of green spherules occurs precisely at the biostratigraphic boundary between the Cretaceous and Paleogene (K-T boundary) at Ocean Drilling Program Site 1049 (lat 30°08′N, long 76°06′W). The spherulitic layer contains abundant rock fragments (chalk, limestone, dolomite, chert, mica books, and schist) as well as shocked quartz, abundant large Cretaceous planktic foraminifera, and rounded clasts of clay as long as 4 mm interpreted as altered tektite glass probably derived from the Chicxulub impact structure. Most of the Cretaceous foraminifera present above the spherule layer are not survivors since small specimens are conspicuously rare compared to large individuals. Instead, the Cretaceous taxa in Paleocene sediments are thought to be reworked. The first Paleocene planktic foraminifera and calcareous nannofossil species are recorded immediately above the spherule bed, the upper part of which contains an iridium anomaly. Hence, deposition of the impact ejecta exactly coincided with the biostratigraphic K-T boundary and demonstrates that the impact event was synchronous with the evolutionary turnover in the oceans. These results are consistent with a reanalysis of the biostratigraphy of the K-T boundary stratotype, which argues that shallow-marine K-T boundary sections are not biostratigraphically more complete than deep-sea K-T boundary sites.
The 1936, 1945-1947, and 1950 earthquake sequences near Lassen Peak, California
Three vigorous earthquake sequences occurred near Lassen Peak in 1936, between 1945 and 1947, and in 1950; the latter two sequences included mainshocks of magnitude 5.0 and 5.5, respectively, and thousands of smaller events. No comparable earthquake sequences have occurred near Lassen Peak since 1950. The epicentral area lies within 20 km of the southern boundary of Lassen Volcanic National Park, in a northwest striking seismic zone that extends from Lake Tahoe to the vicinity of Mount Shasta. In comparing their time history and magnitude distribution with other earthquake sequences that have occurred in regions of Cenozoic volcanism within and east of the Cascade Range and the Sierra Nevada, we find that the Lassen earthquake sequences show similar characteristics to two earthquake sequences that occurred on Basin and Range faults near Herlong, California, and Klamath Falls, Oregon. We interpret this similarity as evidence that the Lassen earthquakes were caused by Basin and Range extension and may have occurred on one or more Basin and Range faults in the Lassen region. However, the limitations of the data do not allow other possible sources, such as magmatic injection, to be ruled out. The most important implication of the Lassen earthquake sequences is that earthquakes of M 5 or greater may occur in the Lassen region, perhaps quite close to Lassen Peak or other volcanoes. The record of Holocene volcanism and fault displacements in the region indicates that earthquake sequences driven by either tectonic or magmatic processes may occur near Lassen Peak, and any significant earthquake sequence should be carefully monitored to assess its nature.
The Cascade volcanoes; monitoring history and current land management
Explore the source record for details and available documents.
Results of seismological monitoring in the Cascade Range 1962-1989: earthquakes, eruptions, avalanches and other curiosities
Modern monitoring of seismic activity at Cascade Range volcanoes began at Longmire on Mount Rainier in 1958. Since then, there has been an expansion of the regional seismic networks in Washington, northern Oregon and northern California. Now, the Cascade Range from Lassen Peak to Mount Shasta in the south and Newberry Volcano to Mount Baker in the north is being monitored for earthquakes as small as magnitude 2.0, and many of the stratovolcanoes are monitored for non-earthquake seismic activity. This monitoring has yielded three major observations. First, tectonic earthquakes are concentrated in two segments of the Cascade Range between Mount Rainier and Mount Hood and between Mount Shasta and Lassen Peak, whereas little seismicity occurs between Mount Hood and Mount Shasta. Second, the volcanic activity and associated phenomena at Mount St. Helens have produced intense and widely varied seismicity. And third, at the northern stratovolcanoes, signals generated by surficial events such as debris flows, icequakes, steam emissions, rockfalls and icefalls are seismically recorded. Such records have been used to alert authorities of dangerous events in progress. -Authors