Geology topics

R.B. Perkins

Publications and source records attributed to R.B. Perkins.

4 recordsLinked to original sources

USGS2014

Geochemistry of a marine phosphate deposit: A signpost to phosphogenesis

The Permian age Phosphoria Formation in southeastern Idaho and adjoining states represents possibly the largest marine phosphate deposit in the world. The Meade Peak Member, which contains the highest concentrations and amount of carbonate fluorapatite in the formation, was not significantly altered by mechanical reworking during deposition or subsequently by chemical weathering. Thus, its present composition reflects properties of the Phosphoria Sea that were critical to its accumulation and possibly to the accumulation of most major marine phosphate deposits. These properties included the chemistry of the water column, the hydrography, and the level of primary productivity. Calculated accumulation rates of the PO 4 3− and trace nutrients – Cd, Cu, Ni, and Zn – recorded a dynamic upwelling rate of c. 30 m year −1 that supported primary productivity of 2g C m −2 day −1 . High accumulation rates of the hydrogenous redox-sensitive trace metals – Cr, Mo, U, and V – reflect bottom-water redox conditions that were dominantly suboxic, maintained by a balance between the oxidation of ~ 8% of the organic detritus that settled out of the photic zone and advection of bottom water with a residence time of c .10 years. A limited flux into the basin of siliciclastic lithogenous debris contributed further to elevated concentrations of the seawater-derived sediment fractions.

Book chapter↗

USGS2008

Trace-element budgets in the Ohio/Sunbury shales of Kentucky: Constraints on ocean circulation and primary productivity in the Devonian-Mississippian Appalachian Basin

The hydrography of the Appalachian Basin in late Devonian-early Mississippian time is modeled based on the geochemistry of black shales and constrained by others' paleogeographic reconstructions. The model supports a robust exchange of basin bottom water with the open ocean, with residence times of less than forty years during deposition of the Cleveland Shale Member of the Ohio Shale. This is counter to previous interpretations of these carbon-rich units having accumulated under a stratified and stagnant water column, i.e., with a strongly restricted bottom bottom-water circulation. A robust circulation of bottom waters is further consistent with the palaeoclimatology, whereby eastern trade-winds drove upwelling and arid conditions limited terrestrial inputs of siliciclastic sediment, fresh waters, and riverine nutrients. The model suggests that primary productivity was high (~ 2??g C m- 2 d- 1), although no higher than in select locations in the ocean today. The flux of organic carbon settling through the water column and its deposition on the sea floor was similar to fluxes found in modern marine environments. Calculations based on the average accumulation rate of the marine fraction of Ni suggest the flux of organic carbon settling out of the water column was approximately 9% of primary productivity, versus an accumulation rate (burial) of organic carbon of 0.5% of primary productivity. Trace-element ratios of V:Mo and Cr:Mo in the marine sediment fraction indicate that bottom waters shifted from predominantly anoxic (sulfate reducing) during deposition of the Huron Shale Member of the Ohio Shale to predominantly suboxic (nitrate reducing) during deposition of the Cleveland Shale Member and the Sunbury Shale, but with anoxic conditions occurring intermittently throughout this period. ?? 2008 Elsevier B.V.

Palaeogeography, Palaeoclimatology, Palaeoecology↗

USGS2004

Chapter 4 The meade peak member of the phosphoria formation: Temporal and spatial variations in sediment geochemistry

Variations in the geochemistry of rocks from the Meade Peak Member of the Phosphoria Formation were examined using ratios of elements associated with either the +terrigenous or marine sediment fractions. Inter-element relationships in the terrigenous fraction appear useful for chemo-stratigraphic correlation. A sharp decrease upsection in K 2 O/AI 2 O 3 ratios occurs in the lower half of all but the most northeasterly section, wherein an offset is still evident in average and minimum values. These offsets correspond closely to the lower Guadalupian Series boundary as defined by conodont zonations, coincident with a change from major low-stand to transgressive conditions. The offsets are possibly the result of increased transport distances or flooding of source areas related to transgres- sion of the Phosphoria sea on the Wyoming shelf. A series of intervals displaying high Fe 2 O 3 /Al 2 O 3 , Ba/Al 2 O 3 and Sc/Al 2 O 3 ratios occur in the upper beds of the easternmost sections. The intervals do not appear to reflect amplified marine signals, but rather the introduction of terrigenous sediment from a secondary source, or, simply, reworking of sediments under higher energy conditions. The westernmost section, presumably repre- senting the deepest parts of the Phosphoria basin, contains intervals with high Ba/Al 2 O 3 . We suggest these horizons represent periods of low sediment accumulation during maxi- mum flooding and high-stand conditions. Inter-element relationships in the marine-derived sediment fraction indicate that bottom waters of the Phosphoria basin were dominantly denitrifying (suboxic). Ratios of Cd and Mo to Zn and Cu closely approach those in modern plankton in most of the sections, implying a major biogenic source for these elements. Exceptions occur through- out the westernmost (distal) section, possibly due to changes in the dominant plankton populations and relative nutrient uptakes, and in the upper part of the most northeasterly (shoreward, ramp) section, which we suggest is due to increased oxygen levels. Relatively thick phosphatic layers occur in basinal areas due largely to lack of terrig- enous dilution during deposition. These basinal deposits appear to have lower concentra- tions of many trace elements than more shoreward deposits. This may reflect deposition away from areas of peak primary production. Alternatively, biogenic detritus in these areas may have been derived from differing populations of primary producers with differing nutrient requirements. Both mid-shelf (middle ramp) and marginal environments were sites of accumulation of rich phosphatic units with high concentrations of trace elements. Deposits from marginal areas have the most varied geochemistry, largely because they experienced greater variability in terrigenous sediment influx. Even moderate changes in sea level may have dramatically altered energy levels, sediment mixing, and the amount of organic detritus reaching the sediment surface in these shallower marginal areas.

Colorado, Idaho, Montana, Nebraska, North Dakota, ↗

USGS2004

Chapter 14 Rex Chert member of the Permian Phosphoria Formation: Composition, with emphasis on elements of environmental concern

We present bulk chemical and mineralogical compositions, as well as petrographic and outcrop descriptions, of rocks collected from three measured outcrop sections of the Rex Chert Member of the Phosphoria Formation in southeast Idaho. The three measured sections were chosen from 10 outcrops of Rex Chert that were described in the field. The Rex Chert overlies the Meade Peak Phosphatic Shale Member of the Phosphoria Formation, the source of phosphate ore in the region. Rex Chert removed as overburden constitutes part of the material transferred to waste-rock piles during phosphate mining. It is also used to surface roads in the mining district. It has been proposed that the chert be used to cap and isolate waste piles, thereby inhibiting the leaching of potentially toxic elements into the environment. The rock samples studied here are from individual chert beds representative of each stratigraphic section sampled. The Cherty Shale Member of the Phosphoria Formation that overlies the Rex Chert in measured section 1 and the upper Meade Peak and the transition zone to the Rex Chert in section 7 were also described and sampled. The cherts are predominantly spiculite composed of granular and mosaic quartz, and sponge spicules, with various but minor amounts of other fossils and detrital grains. The Cherty Shale Member and transition rocks between the Meade Peak and Rex Chert are siliceous siltstones and argillaceous cherts with ghosts of sponge spicules and somewhat more detrital grains than the chert. The dominant mineral is quartz. Carbonate beds are rare in each section and are composed predominantly of calcite and dolomite in addition to quartz. Feldspar, mica, clay minerals, calcite, dolomite, and carbonate fluorapatite are minor to trace minerals in the chert. The concentration of SiO 2 in the chert averages 94.6 wt.%. Organic-carbon content is generally very low, but can be as much as 1.8% in Cherty Shale Member samples and as much as 3.3% in samples from the transition between the Meade Peak and Rex Chert. Likewise, phosphate (P 2 O 5 ) is generally low in the chert, but can be as much as 3.1% in individual chert beds. Selenium concentrations in Rex Chert and Cherty Shale Member samples vary from <0.2 to 138 ppm, with a mean concentration of 7.0 ppm. This mean Se content is heavily dependent on two values of 101 and 138 ppm for siliceous siltstone from the lower part of the Rex Chert, which contains rocks that are transitional in character between the Meade Peak and Rex Chert Members. Without those two samples, the mean Se concentration is < 1.0 ppm. Other elements of environmental interest, As, Cr, V, Zn, Hg, and Cd, generally occur in concentrations near or below that in average continental shale. Stratigraphic changes, equivalent to temporal changes in the depositional basin, in chemical composition of rocks are notable either as uniform changes through the sections or as distinct differences in the mean composition of rocks that comprise the upper and lower halves of the sections. Q-mode factors are interpreted to represent the following rock and mineral components: chert-silica component consisting of Si (±Ba); phosphorite-carbonate fluorapatite component composed of P, Ca, As, Y, V, Cr, Sr, and La (± Fe, Zn, Cu, Ni, Li, Se, Nd, Hg); shale component composed of Al, Na, Zr, K, Ba, Li, and organic C (± Ti, Mg, Se, Ni, Fe, Sr, V, Mn, Zn); carbonate component (dolomite, calcite, silicified carbonates) composed of carbonate C, Mg, Ca, and Si (±Mn); and, tentatively, organic matter-hosted elements (and/or sulfide-sulfate phases) composed of Cu (± organic C, Zn, Mn, Si, Ni, Hg, Li). Selenium shows a dominant association with organic matter and to lesser degrees associations with other shale components and carbonate fluorapatite. Consideration of larger numbers of factors in Q-mode analysis indicates that native Se (a factor containing Se (± Ba)) may also comprise a minor component of the Se complement. Comparison of our data with those from newly exposed outcrops in active phosphate mines indicates that weathering of typical Rex Chert outcrops likely plays an important role in removing environmentally sensitive elements.

Idaho↗