Geology Reports⌕ Search

Geology topics

R. Durrheim

Publications and source records attributed to R. Durrheim.

4 recordsLinked to original sources
USGS2012

Evolution of the Precambrian lithosphere: Seismological and geochemical constraints

Several recent models of crustal evolution are based on the belief that the thickness of the continental crust is proportional to its age, with ancient crust being the thickest. A worldwide review of seismic structure contradicts this belief and falsifies these models, at least for the Archean. Proterozoic crust has a thickness of 40–55 km and a substantial high‐velocity (>7 km/s) layer at its base, while Archean crust is only 27–40 km thick (except at the site of younger rifts and collisional boundaries) and lacks the basal high‐velocity layer. Seismology also provides evidence that the lithosphere is thickest beneath Archean cratons, while diamond ages show that this lithospheric keel must have already existed in the Archean. Geochemical data also indicate significant differences between Archean and Proterozoic lithosphere. Major and trace element studies of sediments show a change in upper crustal composition between the Archean and Proterozoic. Archean rocks are depleted in Si and K and enriched in Na, Ca, and Mg. There is also a marked change in the Eu/Eu * ratio. Mantle xenoliths and continental flood basalts show that the mantle lithosphere beneath Archean crust is ultradepleted in FeO compared to that beneath post‐Archean crust. The secular change in the crust‐forming process is attributed to a decline in mantle temperature, leading to a change in the composition of the lithospheric mantle. The higher temperature of the Archean mantle led to the eruption of komatiitic lavas, producing a refractory lithospheric mantle which is ultradepleted in FeO and volatiles. The resultant lithospheric keel is intrinsically less dense than the surrounding mantle and thus not susceptible to delamination. It was sufficiently thick and cool for diamonds to form during the Archean. In contrast, Proterozoic crust developed above fertile mantle. The eruption of continental flood basalts and underplating of basaltic sills is attributed to subsequent heating and partial melting of the lithospheric mantle. Consequently, Proterozoic crust is thickened and has a high‐velocity basal layer.

Journal of Geophysical Research B: Solid Earth↗
USGS2009

A deployment of broadband seismic stations in two deep gold mines, South Africa

In-mine seismic networks throughout the TauTona and Mponeng gold mines provide precise locations and seismic source parameters of earthquakes. They also support small-scale experimental projects, including NELSAM (Natural Earthquake Laboratory in South African Mines), which is intended to record, at close hand, seismic rupture of a geologic fault that traverses the project region near the deepest part of TauTona. To resolve some questions regarding the in-mine and NELSAM networks, we deployed four portable broadband seismic stations at deep sites within TauTona and Mponeng for one week during September 2007 and recorded ground acceleration. Moderately large earthquakes within our temporary network were recorded with sufficiently high signal-to-noise that we were able to integrate the acceleration to ground velocity and displacement, from which moment tensors could be determined. We resolved the questions concerning the NELSAM and in-mine networks by using these moment tensors to calculate synthetic seismograms at various network recording sites for comparison with the ground motion recorded at the same locations. We also used the peak velocity of the S wave pulse, corrected for attenuation with distance, to estimate the maximum slip within the rupture zone of an earthquake. We then combined the maximum slip and seismic moment with results from laboratory friction experiments to estimate maximum slip rates within the same high-slip patches of the rupture zone. For the four largest earthquakes recorded within our network, all with magnitudes near 2, these inferred maximum slips range from 4 to 27 mm and the corresponding maximum slip rates range from 1 to 6 m/s. These results, in conjunction with information from previous ground motion studies, indicate that underground support should be capable of withstanding peak ground velocities of at least 5 m/s.

Mponeng gold mine, TauTona gold mine↗
USGS1991

Archean and Proterozoic crustal evolution: Evidence from crustal seismology

Seismic-velocity models for Archean and Proterozoic provinces throughout the world are analyzed. The thickness of the crust in Archean provinces is generally found to be about 35 km (except at collisional boundaries), whereas Proterozoic crust has a significantly greater thickness of about 45 km and has a substantially thicker high-velocity (>7.0 km/s) layer at the base. We consider two models that may explain these differences. The first model attributes the difference to a change in the composition of the upper mantle. The higher temperatures in the Archean mantle led to the eruption of komatiitic lavas, resulting in an ultradepleted lithosphere unable to produce significant volumes of basaltic melt. Proterozoic crust developed above fertile mantle, and subsequent partial melting resulted in basaltic underplating and crustal inflation. In the second model, convection in the hot Archean mantle is considered to have been too turbulent to sustain stable long-lived subduction zones. By the Proterozoic the mantle had cooled sufficiently for substantial island and continental arcs to be constructed, and the high-velocity basal layer was formed by basaltic underplating.

Geology↗