Geology Reports⌕ Search

Geology topics

P. W. Guild

Publications and source records attributed to P. W. Guild.

12 recordsLinked to original sources
USGS2022

Metallogenesis in the western United States

Although the Mesozoic-Cenozoic metallogeny of the western United States unquestionably resulted from convergence of the North American and Pacific Ocean plates, subduction alone does not adequately explain the distribution of the ore deposits in Laramide and post-Laramide time, when magmatism and mineralization extended irregularly eastward at least 1500 km from the continental margin. Stable isotopes (lead and initial 87 Sr/ 86 Sr) indicate derivation of some rock- and ore-forming elements from continental rather than oceanic lithosphere. A gross east-west metals zonation lacks the clearcut divisions evident to the north and south in the Cordillera. Lineaments, difficult or impossible to document unequivocally, seem nevertheless to have played some role in localizing mineral belts transverse to plate boundaries. It is suggested that mantle convection in a reactivated ensialic back-arc, triggered at least in part by subduction on one or more Benioff Zones, became increasingly important both with time and with distance eastward from the Mesozoic trench. Small magma pockets were generated episodically by partial fusion of the continental lithosphere, itself probably in-homogeneous, where deep crustal flaws, many ancient but some perhaps newly created, relieved pressure and provided access to the upper crust.

Western United States↗
USGS2014

Petrology and structure of the Moa Chromite district, Oriente Province, Cuba

Chromite deposits In the Moa district, on the north coast of Oriente Province, Cuba, form one facies of the ultramafic complex in which they occur. Two planar structures, one a compositional layering due to variations in the relative proportions of olivine, pyroxene, plagioclase feldspar, and chromite, and the other a foliation caused by the orientation of pyroxene crystals in peridotite, are in general parallel, but diverge in a few places. Dips are fairly constant, being moderate to the northwest over most of the area, but sharp reversals occur immediately adjacent to irregularities in the chromite deposits. Two prominent joint sets are present: (1) Cross joints striking parallel to the strike of the foliation and dipping approximately at right angles to it; and (2) longitudinal joints striking parallel to the direction of dip of the foliation and nearly vertical. Gabbro dikes follow the first set, chrysotlle veins the second. Within the ore bodies dikes are commonly coarser‐grained, larger, and far more abundant than in peridotite; they enclose coarse, angular fragments of chromite. ©1947. American Geophysical Union. All Rights Reserved.

Eos, Transactions, American Geophysical Union↗
USGS2014

Thrust faults and related structures in eastern Cuba

Detailed areal mapping in central Camagüey Province and reconnaissance mapping in northern and eastern Oriente Province, Cuba, have revealed two major structural zones: (1) A zone of intense deformation, including thrust faulting, which lies north of the geographic axis of the island; and (2) a belt of domical mountains bounded on the north by Nipe Bay and the coast, and on the south by the Cauto trough and Guantilnamo basin. In Camagüey, extensive masses of serpentine and overlying tuffs have been complexly folded and overridden from the north by a block, at least 25 miles long, of limestones that form the Sierra de Cubitas and Sierra de Camaján. The overthrust carried a northern fades of Cretaceous and Eocene limestones over a southern fades of tuffaceous rocks of similar age, and had a displacement of at least six miles. In places serpentine was thrust over younger formations, and most of the shearing in the serpentine is attributed to diastrophism. A thrust zone exposed in Loma La Vigía, 15 miles north of Holguín, suggests a similar tectonic history for northern Oriente Province. Chaotic giant breccias that include waterlaid debris indicate that the overthrusts moved across the ancient land surface in both Camagüey and Oriente districts. The folding apparently began in the Cretaceous and culminated in overthrusting during early middle Eocene time. Post‐Eocene deformation appears to be limited to warping or doming to maximum angles of about 20 degrees. The zone of domical mountains is somewhat more than 100 miles long from east to west by 25 to 30 miles wide, and comprises three main units: (1) the Sierra de Nipe and (2) Sierra del Cristal domes, principally of serpentine; and (3) the Cuchillas uplift, which includes the Cuchillas de Toar and Sierra de Purlal, composed of serpentine and pre‐serpentine rocks. These uplifts are overlapped progressively on all sides by sediments ranging in age from Upper Cretaceous to Oligocene and Miocene, the older beds in places being highly folded. The mountains owe their present relief of 2000 to 4000 feet to the doming of an extensive erosion surface in the late Pliocene or early Pleistocene. The north and east flanks of the Cuchillas uplift extend below sea level, and drowned streams and elevated coral reefs show regional instability since the last major doming. ©1947. American Geophysical Union. All Rights Reserved.

Eos, Transactions, American Geophysical Union↗
USGS1983

Tectonics and metallogenic provinces

Various theories have been advanced to explain the well-known uneven distribution of metals and ore-deposit types in space and time. Primordial differences in the mantle, preferential concentration of elements in the crust, the prevalence of ore-forming processes at certain times and (or) places, and combinations of one or several of these factors have all been called upon to account for the "metallogenic provinces," which can be defined loosely as regions containing similar deposits of one or a group of metals or minerals. Because many, perhaps most, provinces have complex, multistage origins, the relative importance of inheritance vs. process is still controversial. In recent years the geographic relationship of many geologically young provinces to present-day plate-tectonic positions (accreting or consuming margins, intraplate structures, etc.) has been widely recognized, and the presumption is strong that older provinces had similar relationships to former plates. As most ore deposits resulted from a favorable conjunction of geological processes that are no longer operative, elucidation of their genesis requires reconstruction of the geologic history of the province, with particular emphasis on events coeval with mineralization. Tectonic analysis is an important aspect of this reconstruction; data from orbiting satellites have contributed greatly to this analysis, as the voluminous literature of the past decade testifies. Both the synoptic view of large areas and the ability to emphasize faint contrasts have revealed linear, curvilinear, and circular features not previously recognized from field studies. Some of these undoubtedly reflect basement structures that have contributed to the development, or limit the extent, of metallogenic provinces. Their recognition and delineation will be increasingly valuable to the assessment of resources available and as guides to exploration for the ores needed by future generations. ?? 1983.

Advances in Space Research↗
USGS1976

Discovery of natural resources

Mankind will continue to need ores of more or less the types and grades used today to supply its needs for new mineral raw materials, at least until fusion or some other relatively cheap, inexhaustible energy source is developed. Most deposits being mined today were exposed at the surface or found by relatively simple geophysical or other prospecting techniques, but many of these will be depleted in the foreseeable future. The discovery of deeper or less obvious deposits to replace them will require the conjunction of science and technology to deduce the laws that governed the concentration of elements into ores and to detect and evaluate the evidence of their whereabouts. Great theoretical advances are being made to explain the origins of ore deposits and understand the general reasons for their localization. These advances have unquestionable value for exploration. Even a large deposit is, however, very small, and, with few exceptions, it was formed under conditions that have long since ceased to exist. The explorationist must suppress a great deal of "noise" to read and interpret correctly the "signals" that can define targets and guide the drilling required to find it. Is enough being done to ensure the long-term availability of mineral raw materials? The answer is probably no, in view of the expanding consumption and the difficulty of finding new deposits, but ingenuity, persistence, and continued development of new methods and tools to add to those already at hand should put off the day of "doing without" for many years. The possibility of resource exhaustion, especially in view of the long and increasing lead time needed to carry out basic field and laboratory studies in geology, geophysics, and geochemistry and to synthesize and analyze the information gained from them counsels against any letting down of our guard, however (17). Research and exploration by government, academia, and industry must be supported and encouraged; we cannot wait until an eleventh hour to mount a "crash program.".

Science↗
USGS1953

Iron deposits of the congonhas district, minas Gerais, Brazil

Various origins have been proposed for the itabirite and associated hematite ores of Minas Gerais, Brazil. The U.S. Geological Survey, in cooperation with the Brazilian Departamento Nacional da Produqao Mineral, has undertaken a comprehensive program of mapping of these Precambrian deposits, which bear many similarities to other Precambrian iron formations. Itabirite is a finely laminated quartz-iron oxide rock with more or less dolomite, corresponding to James's oxide facies. It occurs principally in the middle group of the Minas series-a eugeosynclinal assemblage of quartzite, schist, chemical precipitates, graywacke, and volcanic rocks. Iron and silica were precipitated rhythmically in a shallow restricted basin under somewhat acid conditions that inhibited the precipitation of carbonates. Erosion of moderately deformed rocks of the Minas series furnished sediments for the overlying conglomeratic Itacolumi series. Severe post-Itacolumi deformation folded and thrust-faulted rocks of both series; the accompanying regional metamorphism recrystallized the chert and iron oxide to quartz, specular hematite, and minor amounts of magnetite. Ultramafic intrusions antedate this diastrophism; granodiorites and various basic dike rocks are younger. Hydrothermal replacement of breccia zones in itabirite and of dolomitic beds associated with the iron formation produced high-grade specular hematite ore nearly free of impurities. The areal distribution of the deposits indicates that the solutions followed fault zones. Heated meteoric water may have been responsible for the replacement, as minerals of obvious magmatic origin are absent. Since early Tertiary time the area has been uplifted several thousand feet. Leaching and cementation related to the present surface have modified both the iron formation and the hematite deposits, giving rise to various types of commercial ore. © 1953 Society of Economic Geologists, Inc.

Economic Geology↗
USGS1951

Notes on the manganese ores of Brazil

Brazil has been a small but consistent source of manganese ore for world markets during the last five decades. Production both for export and for domestic use is likely to increase. Deposits can be classified into syngenetic (the primary manganese sediments in iron formation at Urucum) and epigenetic. The epigenetic deposits can be further subdivided into four classes: (a) The Queluz or Morro da Mina type, in which the manganese oxide ore has been derived by weathering processes from a manganese silicate-carbonate-sulfide protore. (b) The Lagoa Grande type, enclosed in itabirite, in which lean man-ganiferous horizons in the metamorphosed iron formation have been leached and the manganese concentrated by weathering processes. (c) Deposits in slightly manganiferous rocks of various types in which the manganese has been concentrated by weathering processes. (d) Deposits in barren rocks into which manganese oxides have been introduced from unknown sources. It is probable that the Lagoa Grande type is closely related in ultimate origin to the Urucum type, although the regional metamorphism suffered by the former obscures relations. The Urucum deposits and two deposits of the Morro da Mina type have large reserves of export-grade ore. Many deposits of the Lagoa Grande type are known and the aggregate reserves are large, although their grade makes them more suitable for domestic than for export use. Deposits of the other two types are numerous but small, and their grade seems to consign most ore from these deposits to the domestic market. © 1951 Society of Economic Geologists, Inc.

Economic Geology↗