Nick Davatzes | Geology Reports

USGS2022

Friction in clay-bearing faults increases with the ionic radius of interlayer cations

Smectite can dramatically reduce the strength of crustal faults and may cause creep on natural faults without great earthquakes; however, the frictional mechanism remains unexplained. Here, our shear experiments reveal systematic increase in shear strength with the increase of the ionic radius of interlayer cations among lithium-, sodium-, potassium-, rubidium-, and cesium-montmorillonites, a smectite commonly found in faults. Using density-functional-theory calculations, we find that relatively small sodium ions fit in the ditrigonal cavities on the montmorillonite surfaces, resulting in weakening of interlayer repulsion during sliding. On the other hand, relatively large potassium ions do not fit in the ditrigonal cavities, resulting in a larger resistance to sliding due to electrostatic repulsion between potassium ions. Calculated shear strength is consistent with our shear experiments by considering the partial dehydration of the frictional contact area. These results provide the basis for developing a quantitative model of smectite-bearing fault rheology.

Communications Earth & Environment↗

USGS2015

Numerical modeling of injection, stress and permeability enhancement during shear stimulation at the Desert Peak Enhanced Geothermal System

Creation of an Enhanced Geothermal System relies on stimulation of fracture permeability through self-propping shear failure that creates a complex fracture network with high surface area for efficient heat transfer. In 2010, shear stimulation was carried out in well 27-15 at Desert Peak geothermal field, Nevada, by injecting cold water at pressure less than the minimum principal stress. An order-of-magnitude improvement in well injectivity was recorded. Here, we describe a numerical model that accounts for injection-induced stress changes and permeability enhancement during this stimulation. In a two-part study, we use the coupled thermo-hydrological-mechanical simulator FEHM to: (i) construct a wellbore model for non-steady bottom-hole temperature and pressure conditions during the injection, and (ii) apply these pressures and temperatures as a source term in a numerical model of the stimulation. In this model, a Mohr-Coulomb failure criterion and empirical fracture permeability is developed to describe permeability evolution of the fractured rock. The numerical model is calibrated using laboratory measurements of material properties on representative core samples and wellhead records of injection pressure and mass flow during the shear stimulation. The model captures both the absence of stimulation at low wellhead pressure (WHP ≤1.7 and ≤2.4 MPa) as well as the timing and magnitude of injectivity rise at medium WHP (3.1 MPa). Results indicate that thermoelastic effects near the wellbore and the associated non-local stresses further from the well combine to propagate a failure front away from the injection well. Elevated WHP promotes failure, increases the injection rate, and cools the wellbore; however, as the overpressure drops off with distance, thermal and non-local stresses play an ongoing role in promoting shear failure at increasing distance from the well.

Nevada↗