Geology topics

Michael P. Hunerlach

Publications and source records attributed to Michael P. Hunerlach.

5 recordsLinked to original sources

USGS2006

Geochemical data for mercury, methylmercury, and other constituents in sediments from Englebright Lake, California, 2002

This report presents geochemical data from two 2002 sampling campaigns conducted in Englebright Lake on the Yuba River in northern California. A deep coring campaign was done in May-June 2002 and a shallow sampling campaign was completed in October 2002. This work assessed the chemical composition of material deposited in the reservoir between 1940, the year Englebright Dam was completed, and 2002 as part of the Upper Yuba River Studies Program, an effort designed to evaluate the feasibility of introducing anadromous fish, including steelhead and spring-run Chinook salmon, upstream from Englebright Dam. Results of analyses of total mercury (HgT) in 444 subsamples, methylmercury (MeHg) in 243 subsamples, and other trace and major elements in 202 subsamples are presented. Data quality was evaluated on the basis of analyses of replicate pairs of subsamples, standard reference materials, blanks, and spike additions.Deep coring penetrated the full thickness of material deposited after 1940 at six locations in the reservoir; the cores reached a maximum depth of 32.8 meters below the reservoir floor. At the three deep coring sites closest to Englebright Dam, concentrations of HgT (dry basis) were consistently in the range of 100 to 500 ng/g (nanogram per gram), in sediment dominantly of silt size (median grain size of 0.004 to 0.063 mm [millimeter]). At the deep coring sites located farther upstream, the upper parts of the profile had lower concentrations of HgT, generally ranging from 2 to 100 ng/g, in sediment dominantly of sand size (median grain size from 0.063 to 2 mm). The lower part of the vertical profiles at three upstream coring sites had higher concentrations of HgT than the upper and middle parts of these profiles, and had finer median grain size. The highest median concentration of MeHg (1.1 ng/g) was in the top 2 cm (centimeter) of the shallow box cores. This vertical interval also had the highest value of the ratio of MeHg to HgT, 0.41 percent. Median concentrations of MeHg and median values of MeHg/HgT decreased systematically with depth from 0-4 to 4-8 to 8-12 cm in the shallow cores. However, similar systematic decreases were not observed at the meter scale in the deep cores of the MEM (MEthylMercury) series. The overall median of the ratio MeHg/HgT in the deep cores was 0.25 percent, not much less than the overall median value for the shallow cores (0.33 percent). Mercury-203 radiotracer divalent inorganic mercury (203Hg(II)) was used to determine microbial mercury-methylation potential rates for 11 samples collected from three reservoir locations and various depths in the sediment profile. For the five shallow mercury-methylation subsamples, ancillary geochemical parameters were assayed, including microbial sulfate reduction rates, sulfur speciation (sediment acid volatile sulfide, total reduced sulfur, and pore-water sulfate), iron speciation (sediment acid extractable iron(II), amorphous iron(III), crystalline iron(III) and pore-water iron(II)), pore-water chloride and dissolved organic carbon, and pH, oxidation-reduction potential (Eh) and whole-sediment organic content. The highest potential rates of microbial mercury methylation were measured in shallow (0 to 8 cm depth) sediments (5 to 30 nanograms of mercury per gram dry sediment per day), whereas potential rates for subsamples collected from depths greater than 500 cm were consistently below the detection limit of the radiotracer method (< 0.02 nanogram of mercury per gram dry sediment per day). Chemical analyses of trace and major elements in bed sediment are presented for 202 samples from deep cores from five locations in Englebright Lake. The mean values and standard deviations for selected trace elements were as follows (in micrograms per gram): antimony, 2.4 ± 1.6; arsenic, 69 ± 48; chromium, 134 ± 23; lead, 33 ± 25; and nickel, 87 ± 24. Concentrated samples of heavy-mineral grains, prepared using nine large-volume composite samples from

California↗

USGS2005

Mercury contamination from historical gold mining in California

Mercury contamination from historical gold mines represents a potential risk to human health and the environment. This fact sheet provides background information on the use of mercury in historical gold mining and processing operations in California, with emphasis on historical hydraulic mining areas. It also describes results of recent USGS projects that address the potential risks associated with mercury contamination. Miners used mercury (quicksilver) to recover gold throughout the western United States. Gold deposits were either hardrock (lode, gold-quartz veins) or placer (alluvial, unconsolidated gravels). Underground methods (adits and shafts) were used to mine hardrock gold deposits. Hydraulic, drift, or dredging methods were used to mine the placer gold deposits. Mercury was used to enhance gold recovery in all the various types of mining operations; historical records indicate that more mercury was used and lost at hydraulic mines than at other types of mines. On the basis of USGS studies and other recent work, a better understanding is emerging of mercury distribution, ongoing transport, transformation processes, and the extent of biological uptake in areas affected by historical gold mining. This information has been used extensively by federal, state, and local agencies responsible for resource management and public health in California.

Fact Sheet↗

USGS2005

Geochemical characterization of water, sediment, and biota affected by mercury contamination and acidic drainage from historical gold mining, Greenhorn Creek, Nevada County, California, 1999-2001

In 1999, the U.S. Geological Survey (USGS) initiated studies of mercury and methylmercury occurrence, transformation, and transport in the Bear River and Yuba River watersheds of the northwestern Sierra Nevada. Because these watersheds were affected by large-scale, historical gold extraction using mercury amalgamation beginning in the 1850s, they were selected for a pilot study of mercury transport by the USGS and other cooperating agencies. This report presents data on methylmercury (MeHg) and total mercury (THg) concentrations in water, bed sediment, invertebrates, and frogs collected at 40 stations during 1999-2001 in the Greenhorn Creek drainage, a major tributary to Bear River. Results document several mercury contamination “hot spots” that represent potential targets for ongoing and future remediation efforts at abandoned mine sites in the study area. Water-quality samples were collected one or more times at each of 29 stations. The concentrations of total mercury in 45 unfiltered water samples ranged from 0.80 to 153,000 nanograms per liter (ng/L); the median was 9.6 ng/L. Total mercury concentrations in filtered water (41 samples) ranged from less than 0.3 to 8,000 ng/L; the median was 2.7 ng/L. Concentrations of methylmercury in the unfiltered water (40 samples) ranged from less than 0.04 to 9.1 ng/L; the median was 0.07 ng/L. Methylmercury in filtered water (13 samples) ranged from less than 0.04 to 0.27 ng/L; the median was 0.04 ng/L. Acidic drainage with pH values as low as 3.4 was encountered in some of the mined areas. Elevated concentrations of aluminum, cadmium, copper, iron, manganese, nickel, and zinc were found at several stations, especially in the more acidic water samples. Total mercury concentrations in sediment were determined by laboratory and field methods. Total mercury concentrations (determined by laboratory methods) in ten samples from eight stations ranged from about 0.0044 to 12 µg/g (microgram per gram, equivalent to parts per million). Methylmercury concentrations in these samples ranged from less than 0.00011 to 0.0095 µg/g. A field panning method was used to determine the concentration of liquid elemental mercury in 22 samples from 14 stations. Measured quantities of elemental mercury recovered by panning ranged from a trace amount estimated at 100 milligrams per kilogram (equivalent to parts per million) to 45,000 milligrams per kilogram (equivalent to 4.5 per cent, by weight). In total, 194 invertebrate samples were collected at 31 stations; 78 of the samples were analyzed for concentrations of THg and MeHg and used to calculate MeHg to THg ratios. A total of 69 frog samples were collected at 19 stations, and all were analyzed only for THg. Ranges of MeHg concentrations (µg/g, wet weight) in invertebrate samples and number of samples (n) were 0.0012-0.048 for banana slugs (Arionidae, n = 27), 0.027-0.39 for dobsonflies (Corydalidae, n = 14), 0.029-0.50 for predaceous diving beetles (Dytiscidae, n = 31), 0.026-0.52 for predaceous stoneflies (Perlidae, n = 18), 0.011-1.6 for dragonflies (Odonata, n = 46), and 0.061-0.55 for water striders (Gerridae, n = 56). The ratio of MeHg to THg in invertebrates was greater than 50 percent for 74 of 78 samples. The data from this reconnaissance sampling effort have been used by land-management agencies in selecting abandoned mine sites for remediation. The Forest Service has remediated the Sailor Flat site, and the Bureau of Land Management has initiated plans to remediate the Boston Mine drainage tunnel.

California↗

USGS2004

Geochemistry of Mercury and other trace elements in fluvial tailings upstream of Daguerre Point Dam, Yuba River, California, August 2001

This study was designed to characterize the particle-size distribution and the concentrations of total mercury (HgT), methylmercury (MeHg), and other constituents in sediments trapped behind Daguerre Point Dam, a 28-foot-high structure on the lower Yuba River in California. The results of the study will assist other agencies in evaluating potential environmental impacts from mobilization of sediments if Daguerre Point Dam is modified or removed to improve the passage of anadromous fish. Methylmercury is of particular concern owing to its toxicity and propensity to bioaccumulate. A limited amount of recent work on hydraulic and dredge tailings in other watersheds has indicated that mercury and MeHg concentrations may be elevated in the fine-grained fractions of placer mining debris, particularly clay and silt. Mercury associated with tailings from placer gold mines is a source of continued contamination in Sierra Nevada watersheds and downstream water bodies, including the Sacramento?San Joaquin Delta and the San Francisco Bay of northern California. Churn drilling was used to recover sediments and heavy minerals at 5-foot intervals from six locations upstream of Daguerre Point Dam. Maximum depth of penetration ranged from 17.5 to 35 feet below land surface, resulting in 31 discreet drilled intervals. Drilling in permeable, unconsolidated sediments below the streambed of the Yuba River released a significant volume of water along with the sediment, which complicated the sampling and characterization effort. Overflow of a silty fraction sampled at the drill site contained suspended sediment consisting predominantly of silt and clay, with HgT concentration ranging from 33 to 1,100 ng/g (nanogram per gram) dry weight. A sandy fraction, collected after sieving sediment through a 2-millimeter vibratory screen, contained from 14 to 82 percent sand and 1 to 29 percent silt plus clay, and had HgT concentrations ranging from 6.8 to 81 ng/g dry weight. A clay-silt fraction, sampled from material remaining in suspension after the sandy fraction settled for 15-20 minutes, contained mercury concentrations from 23 to 370 ng/g dry weight. Concentrations of MeHg were less than the detection limit (<0.001 ng/g dry weight) in 30 of 31 samples of the sandy fraction. In the suspended clay-silt fraction, MeHg was detected in 16 of 31 samples, in which it ranged in concentration from 0.04 (estimated) to 0.61 ng/g wet weight. Potential rates of mercury methylation and demethylation were evaluated in seven samples using radiotracer methods. Mercury methylation (MeHg production) potentials were generally low, ranging from less than 0.15 to about 1.6 ng/g/d (nanogram per gram of dry sediment per day). Mercury demethylation (MeHg degradation) potentials were moderately high, ranging from 1.0 to 2.2 ng/g/d. The ratio of methylation potential (MP) to demethylation potential (DP) ranged from less than 0.14 to about 1.4 (median = 0.24, mean = 0.44, number of samples = 7), suggesting that the potential for net production of MeHg in deep sediments is generally low. The MeHg production rates and MP/DP ratios were higher in the shallower interval in two of the three holes where two depth intervals were assessed, whereas the MeHg concentrations were higher in the shallower interval for all three holes. A similar spatial distribution was found for concentrations of solid-phase sulfide (measured as total reduced sulfur and likely representing iron-sulfide and iron-disulfide compounds), which were much higher in shallower samples (about 700 to about 2,100 nanomoles per gram, dry sediment) than in deeper samples (32 to 55 nanomoles per gram, dry sediment) in these three holes. If reduced sulfur compounds are oxidized to sulfate as a consequence of sediment disturbance, the activity of sulfate-reducing bacteria might be stimulated, causing a short-term increase in methylation of inorganic Hg(II) (divalent mercury).

California↗

USGS2000

Mercury contamination from historic gold mining in California

Mercury contamination from historic gold mines represents a potential risk to human health and the environment. This fact sheet provides background information on the use of mercury in historic gold mining and processing operations in California, and describes a new USGS project that addresses the potential risks associated with mercury from these sources, with emphasis on historic hydraulic mining areas. Miners used mercury (quicksilver) to recover gold throughout the western United States at both placer (alluvial) and hardrock (lode) mines. The vast majority of mercury lost to the environment in California was from placer-goldmines, which used hydraulic, drift, and dredging methods. At hydraulic mines, placer ores were broken down with monitors (or water cannons, fig. 1) and the resulting slurry was directed throughsluices and drainage tunnels, where goldparticles combined with liquid mercury to form gold?mercury amalgam. Loss ofmercury in this process was 10 to 30 percent per season (Bowie, 1905), resulting in highly contaminated sediments at mine sites (fig. 2). Elevated mercury concentrations in present-day mine waters and sediments indicate thathundreds to thousands of pounds of mercury remain at each of the many sites affected by hydraulic mining. High mercury levels in fish, amphibians, and invertebrates downstream of the hydraulic mines are a consequence of historic mercury use. On the basis of USGS studies and other recent work, a better understanding is emerging of mercury distribution, ongoing transport, transformation processes, and the extent of biological uptake in areas affected by historic gold mining. This information will be useful to agencies responsible for prudent land and resource management and for protecting public health.

California↗