USGS2018
In 2017, the U.S. Geological Survey, in cooperation with the U.S. Department of Energy, drilled and constructed borehole TAN-2312 for stratigraphic framework analyses and long-term groundwater monitoring of the eastern Snake River Plain aquifer at the Idaho National Laboratory in southeast Idaho. The location of borehole TAN-2312 was selected because it was downgradient from TAN and believed to be the outer extent of waste plumes originating from the TAN facility. Borehole TAN-2312 initially was cored to collect continuous geologic data, and then re-drilled to complete construction as a monitor well. The final construction for borehole TAN-2312 required 16- and 10-inch (in.) diameter carbon-steel well casing to 37 and 228 feet below land surface (ft BLS), respectively, and 9.9-in. diameter open-hole completion below the casing to 522 ft BLS. Depth to water is measured near 244 ft BLS. Following construction and data collection, a temporary submersible pump and water-level access line were placed near 340 ft BLS to allow for aquifer testing, for collecting periodic water samples, and for measuring water levels. Borehole TAN-2312 was cored continuously, starting at the first basalt contact (about 37 ft BLS) to a depth of 568 ft BLS. Not including surface sediment (0–37 ft), recovery of basalt and sediment core at borehole TAN-2312 was about 93 percent; however, core recovery from 170 to 568 ft BLS was 100 percent. Based on visual inspection of core and geophysical data, basalt examined from 37 to 568 ft BLS consists of about 32 basalt flows that range from approximately 3 to 87 ft in thickness and 4 sediment layers with a combined thickness of approximately 76 ft. About 2 ft of total sediment was described for the saturated zone, observed from 244 to 568 ft BLS, near 296 and 481 ft BLS. Sediment described for the saturated zone were composed of fine-grained sand and silt with a lesser amount of clay. Basalt texture for borehole TAN-2312 generally was described as aphanitic, phaneritic, and porphyritic. Basalt flows varied from highly fractured to dense with high to low vesiculation. Geophysical and borehole video logs were collected after core drilling and after final construction at borehole TAN-2312. Geophysical logs were examined synergistically with available core material to suggest zones where groundwater flow was anticipated. Natural gamma log measurements were used to assess sediment layer thickness and location. Neutron and gamma-gamma source logs were used to identify fractured areas for aquifer testing. Acoustic televiewer logs, fluid logs, and electromagnetic flow meter results were used to identify fractures and assess groundwater movement when compared against neutron measurements. Furthermore, gyroscopic deviation measurements were used to measure horizontal and vertical displacement for borehole TAN-2312. After construction of borehole TAN-2312, a single-well aquifer test was completed September 27, 2017, to provide estimates of transmissivity and hydraulic conductivity. Estimates for transmissivity and hydraulic conductivity were 1.51×102 feet squared per day and 0.23 feet per day, respectively. During the 220-minute aquifer test, well TAN-2312 had about 23 ft of measured drawdown at sustained pumping rate of 27.2 gallons per minute. The transmissivity and hydraulic conductivity estimates for well TAN-2312 were lower than the values determined from previous aquifer tests in other wells near Test Area North. Water samples were analyzed for cations, anions, metals, nutrients, volatile organic compounds, stable isotopes, and radionuclides. Water samples for most of the inorganic constituents showed concentrations near background levels for eastern regional groundwater. Water samples for stable isotopes of oxygen, hydrogen, and sulfur indicated some possible influence of irrigation on the water quality. The volatile organic compound data indicated that this well had some minor influence by wastewater disposal practices at Test Area North.