Geology ReportsSearch

Geology topics

M.S. Steckler

Publications and source records attributed to M.S. Steckler.

2 recordsLinked to original sources

High tsunami frequency as a result of combined strike-slip faulting and coastal landslides

Earthquakes on strike-slip faults can produce devastating natural hazards. However, because they consist predominantly of lateral motion, these faults are rarely associated with significant uplift or tsunami generation. And although submarine slides can generate tsunami, only a few per cent of all tsunami are believed to be triggered in this way. The 12 January Mw 7.0 Haiti earthquake exhibited primarily strike-slip motion but nevertheless generated a tsunami. Here we present data from a comprehensive field survey that covered the onshore and offshore area around the epicentre to document that modest uplift together with slope failure caused tsunamigenesis. Submarine landslides caused the most severe tsunami locally. Our analysis suggests that slide-generated tsunami occur an order-of-magnitude more frequently along the Gonave microplate than global estimates predict. Uplift was generated because of the earthquake?s location, where the Caribbean and Gonave microplates collide obliquely. The earthquake also caused liquefaction at several river deltas that prograde rapidly and are prone to failure. We conclude that coastal strike-slip fault systems such as the Enriquillog-Plantain Garden fault produce relief conducive to rapid sedimentation, erosion and slope failure, so that even modest predominantly strike-slip earthquakes can cause potentially catastrophic slide-generated tsunamig-a risk that is underestimated at present. ?? 2010 Macmillan Publishers Limited. All rights reserved.

Nature Geoscience

Modelling passive margin sequence stratigraphy

We have modelled stratigraphic sequences to aid in deciphering the sedimentary response to sea-level change. Sequence geometry is found to be most sensitive to sea level, but other factors, including subsidence rate and sediment supply, can produce similar changes. Sediment loading and compaction also play a major role in generating accommodation, a factor often neglected in sequence-stratigraphic models. All of these parameters can control whether a type 1 or type 2 sequence boundary is produced. The models indicate that variations in margin characteristics produce systematic shifts in sequence boundary timing and systems tract distribution. The timing of the sequence boundary formation and systems tracts may differ by up to one-half of a sea-level cycle. Thus correlative sequence boundaries will not be synchronous. While rates of sea-level change may exceed the rate of thermal subsidence, isostasy and compaction may amplify the rate of total subsidence to several times greater than the thermal subsidence. Thus, total subsidence does not vary uniformly across the margin since it is modified by the sediment load. The amplitude of sea-level changes cannot be determined accurately without accounting for the major processes that affect sediment accumulation. Backstripping of a seismic line on the New Jersey margin is used to reconstruct continental margin geometry. The reconstructions show that the pre-existing ramp-margin geometry, rather than sea level, controls clinoform heights and slopes and sedimentary bypass. Backstripping also reveals progressive deformation of sequences due to compaction. Further work is still needed to understand quantitatively the role of sea level and the tectonic and sedimentary processes controlling sequence formation and influencing sequence architecture.

Book chapter