M. Simons | Geology Reports

USGS2011

Superficial simplicity of the 2010 El Mayorg-Cucapah earthquake of Baja California in Mexico

The geometry of faults is usually thought to be more complicated at the surface than at depth and to control the initiation, propagation and arrest of seismic ruptures 1 , 2 , 3 , 4 , 5 , 6 . The fault system that runs from southern California into Mexico is a simple strike-slip boundary: the west side of California and Mexico moves northwards with respect to the east. However, the M w 7.2 2010 El Mayor–Cucapah earthquake on this fault system produced a pattern of seismic waves that indicates a far more complex source than slip on a planar strike-slip fault 7 . Here we use geodetic, remote-sensing and seismological data to reconstruct the fault geometry and history of slip during this earthquake. We find that the earthquake produced a straight 120-km-long fault trace that cut through the Cucapah mountain range and across the Colorado River delta. However, at depth, the fault is made up of two different segments connected by a small extensional fault. Both segments strike N130° E, but dip in opposite directions. The earthquake was initiated on the connecting extensional fault and 15 s later ruptured the two main segments with dominantly strike-slip motion. We show that complexities in the fault geometry at depth explain well the complex pattern of radiated seismic waves. We conclude that the location and detailed characteristics of the earthquake could not have been anticipated on the basis of observations of surface geology alone.

California, Arizona↗

USGS2010

Complex rupture during the 12 January 2010 Haiti earthquake

Initially, the devastating Mw 7.0, 12 January 2010 Haiti earthquake seemed to involve straightforward accommodation of oblique relative motion between the Caribbean and North American plates along the Enriquillog-Plantain Garden fault zone. Here, we combine seismological observations, geologic field data and space geodetic measurements to show that, instead, the rupture process may have involved slip on multiple faults. Primary surface deformation was driven by rupture on blind thrust faults with only minor, deep, lateral slip along or near the main Enriquillog-Plantain Garden fault zone; thus the event only partially relieved centuries of accumulated left-lateral strain on a small part of the plate-boundary system. Together with the predominance of shallow off-fault thrusting, the lack of surface deformation implies that remaining shallow shear strain will be released in future surface-rupturing earthquakes on the Enriquillog-Plantain Garden fault zone, as occurred in inferred Holocene and probable historic events. We suggest that the geological signature of this earthquakeg-broad warping and coastal deformation rather than surface rupture along the main fault zoneg-will not be easily recognized by standard palaeoseismic studies. We conclude that similarly complex earthquakes in tectonic environments that accommodate both translation and convergenceg-such as the San Andreas fault through the Transverse Ranges of Californiag-may be missing from the prehistoric earthquake record. ?? 2010 Macmillan Publishers Limited. All rights reserved.

Nature Geoscience↗

USGS2000

Preliminary report on the 16 October 1999 M 7.1 Hector mine, California, earthquake

The M w 7.1 Hector Mine, California, earthquake occurred at 9:46 GMT on 16 October 1999. The event caused minimal damage because it was located in a remote, sparsely populated part of the Mojave Desert, approximately 47 miles east-southeast of Barstow, with epicentral coordinates 34.59°N 116.27°W and a hypocentral depth of 5 ± 3 km. Twelve foreshocks, M 1.9-3.8, preceded the mainshock during the previous twelve hours. All of these events were located close to the hypocenter of the mainshock. The Hector Mine earthquake occurred within the Eastern California Shear Zone (ECSZ). By virtue of its remote location, the societal impact of the Hector Mine earthquake was, fortunately, minimal in spite of the event's appreciable size. The ECSZ is characterized by high seismicity, a high tectonic strain rate, and a broad, distributed zone of north-northwest-trending faults (ECSZ; Figure 1 ; Dokka and Travis, 1990 ; Sauber et al., 1986 ; Sauber et al., 1994 ; Sieh et al., 1993 ). Data regarding the slip rates of faults within the ECSZ suggest that on the order of 15% of the Pacific-North American plate motion occurs along this zone ( Sauber et al., 1986 ; Wesnousky, 1986 ). Most of the faults in the ECSZ have low slip rates and long repeat times for major earthquakes, on the order of several thousands to tens of thousands of years. The occurrence of the Hector Mine earthquake within seven years and only about 30 km east of the 1992 M w 7.3 Landers earthquake suggests that the closely spaced surface faults in the ECSZ are mechanically related. The Hector Mine event involved rupture on two previously mapped fault zones—the Bullion Fault and an unnamed, more northerly-trending fault that is informally referred to in this paper as the Lavic Lake Fault (Dibblee, 1966 , 1967a , b ). Traces of the Bullion Fault exhibit evidence of Holocene displacement and were zoned as active in 1988 under California's Mquist-Priolo Earthquake Fault Zoning Act ( Hart and Bryant, 1997 ). The pattern of rupture along more than one named fault was also observed from the 1992 Landers earthquake ( Hauksson et al., 1993 ; Sieh et al., 1994). Much of the fault zone that produced the Hector Mine earthquake had been buried by relatively young stream deposits, and the fault scarps in bedrock have a subdued morphology. It appears that these faults have not experienced significant offset for perhaps 10,000 years or more ( Hart, 1987 ). Planned future investigations will refine the age of the last event on these faults. The portion of the Lavic Lake Fault that ruptured between the northern end of the Bullion Mountains and Lavic Lake had not previously been mapped. However, our field investigations have identified ancient, subdued fault scarps along portions of the 1999 rupture zone in this area. It thus appears that the entire segment of the Lavic Lake Fault that was involved in the 1999 event had ruptured in the past. As is typical for most faults within the Eastern California Shear Zone, the rate of movement along the Lavic Lake Fault may be quite slow (<1 mm/yr) and should produce earthquakes only infrequently. This event is a reminder that faults that have ruptured in late Quaternary time, but that lack evidence of Holocene displacement, can still produce earthquakes in this low-slip-rate tectonic setting. Additionally, the Hector Mine earthquake is noteworthy for a couple of other reasons. First, it clearly produced triggered seismicity over much of southern California, from the rupture zone toward the south-southwest in particular. Second, as we will discuss, the event may provide new data and insight into recently developed paradigms concerning earthquake interactions and the role of static stress changes. Questions such as these will, of course, be the subject of extensive detailed analyses in years to come. Fortunately, the Hector Mine sequence will provide one of the best data sets obtained to date for a significant earthquake in the United States. Because it occurred when major upgrades to both the regional seismic network (TriNet) and the regional geodetic network (SCIGN) were well underway, the Earth science community will have abundant high-quality data with which to explore the important and interesting questions that have been raised. In this paper, we present and discuss the basic data and preliminary results from the Hector Mine earthquake.

California↗