Geology ReportsSearch

Geology topics

Kent C. Glover

Publications and source records attributed to Kent C. Glover.

4 recordsLinked to original sources

Leachate migration from an in-situ oil-shale retort near Rock Springs, Wyoming

Hydrogeologic factors influencing leachate movement from an in-situ oil-shale retort near Rock Springs, Wyoming, were investigated through models of ground-water flow and solute transport. Leachate, indicated by the conservative ion thiocyanate, has been observed ? mile downgradient from the retort. The contaminated aquifer is part of the Green River Formation and consists of thin, permeable layers of tuff and sandstone interbedded with oil shale. Most solute migration has occurred in an 8-foot sandstone at the top of the aquifer. Ground-water flow in the study area is complexly three dimensional and is characterized by large vertical variations in hydraulic head. The solute-transport model was used to predict the concentration of thiocyanate at a point where ground water discharges to the land surface. Leachate with peak concentrations of thiocyanate--45 milligrams per liter or approximately one-half the initial concentration of retort water--was estimated to reach the discharge area during January 1985. This report describes many of th3 advantages, as well as the problems, of site-specific studies. Data such as the distribution of thin, permeable beds or fractures might introduce an unmanageable degree of complexity to basin-wide studies but can be incorporated readily into site-specific models. Solute migration in the study area occurs primarily in thin, permeable beds rather than in oil-shale strata. Because of this behavior, leachate traveled far greater distances than might otherwise have been expected. The detail possible in site-specific models permits more accurate prediction of solute transport than is possible with basin-wide models. A major problem in site-specific studies is identifying model boundaries that permit the accurate estimation of aquifer properties. If the quantity of water flowing through a study area cannot be determined prior to modeling, the hydraulic conductivity and ground-water velocity will be poorly estimated.

Water Supply Paper

A plan for hydrologic investigations of in situ, oil-shale retorting near Rock Springs, Wyoming

The recovery of shale oil by the in-situ retort process may cause hydrologic impacts, the most significant being ground-water contamination and possible transport of contaminants into surrounding areas. Although these impacts are site-specific, many of the techniques used to investigate each retort operation commonly will be the same. The U.S. Geological Survey has begun a study of hydrologic impacts in the area of an in-situ retort near Rock Springs, Wyoming, as a means of refining and demonstrating these techniques. Geological investigations include determining the areal extent and thickness of aquifers. Emphasis will be placed on determining lithologic variations from geophysical logging. Hydrologic investigations include mapping of potentiometric surfaces, determining rates of ground-water discharge, and estimating aquifer properties by analytical techniques. Water-quality investigations include monitoring solute migration from the retort site and evaluating sampling techniques by standard statistical procedures. A ground-water-flow and solute-transport model will be developed to predict future movement of the water plume away from the retort. (USGS)

Open-File Report

A computer program for simulating salinity loads in streams

A FORTRAN IV program that simulates salinity loads in streams is described. Daily values of stream-discharge in cubic feet per second, or stream-discharge and specific conductance in micromhos, are used to estimate daily loads in tons by one of five available methods. The loads are then summarized by computing either total and mean monthly loads or various statistics for each calendar day. Results are output in tabular and, if requested, punch card format. Under selection of appropriate methods for estimating and summarizing daily loads is provided through the coding of program control cards. The program is designed to interface directly with data retrieved from the U.S. Geological Survey WATSTORE Daily Values File. (Woodard-USGS)

Open-File Report