Karl B. Haase | Geology Reports

USGS2025

Evaluating mass flow meter measurements from chambers for greenhouse gas emissions from orphan wells and other point sources

This study evaluates the performance of a rigid gas flux chamber equipped with a mass flow meter (MFM) for measuring gas emissions from leaking orphan wells and similar pressure-driven gas point sources. We conducted a series of laboratory and field experiments to evaluate the sensitivity, stability, and dynamic range of an MFM chamber system and found an optimal method for sealing the chamber to the ground to isolate the emission source. From these results, we estimate the effects of different soil gas permeabilities on measurements and identify the uncertainty of environmental processes that can impact measurements. Simulations of an MFM chamber are compared to those of a dynamic flux chamber to contrast the data derived with both methodologies and illustrate the potential for measuring high variability leaks with the MFM chamber. Using a low flow resistance MFM and a chamber well-sealed to the ground, it is possible to measure leaks down to 1.08 x 10 -3 cubic meters per hour (m 3 h −1 ) (refenced to 25°/1 atm), corresponding to 0.77 grams per hour (g h −1 ) methane or 2.11 g h −1 carbon dioxide, with a mean uncertainty of 0.89 % relative standard deviation. Environmental processes such as heated gas inside the chamber from solar gain, wind blowing across the chamber vent, and changing humidity in the chamber, can cause variation in MFM measurements. Over 11 d of continuous monitoring under varying weather conditions, the standard deviation of the environmentally sourced signals was found to be 7.40 x 10 -3 m 3 h −1 (equivalent to or 5.27 g h −1 methane or 14.45 g h −1 carbon dioxide). Strategies to obtain the highest quality data from MFM chambers include burying the edges of the chamber below the surface sufficiently deep to seal the chamber edges against gas flow and soaking the dirt with water to lower the chances of escaping gases, while monitoring the gas flow and adjusting the chamber seal to achieve a maximum flow rate.

Atmospheric Measurement Techniques↗

USGS2025

A geospatial analysis of water-quality threats from orphan wells in principal and secondary aquifers of the United States

Throughout the history of oil and gas production in the United States, millions of wells have been drilled for exploration and energy production. Hundreds of thousands of unplugged wells are no longer actively producing and are currently under orphan status, with no responsible party obligated for plugging. Orphan wells can pose threats to water resources by providing pathways for contaminants such as hydrocarbons and brines to migrate into water-supply aquifers. In this study, we investigate the potential threats to groundwater resources posed by orphan wells at the national scale. Water-quality data is extremely sparse in relation to orphan wells nationally and may not be suitable for identifying contamination from oil and gas development. We used geospatial and statistical methods to evaluate which principal and secondary aquifer systems may be most susceptible to contamination from orphan wells. Analysis involved three sets of susceptibility factors including: 1) factors related to the number and density of orphan wells; 2) factors that can threaten well integrity and contribute to transport of contaminants; and 3) factors related to groundwater withdrawal rates and the affected populations/communities in the event of water quality disturbances. From a dataset of 117,672 documented orphan wells, 64,203 fall within a principal aquifer system, while the remainder fall within a secondary aquifer system. By assessing the combination of well integrity and hydrogeologic factors within these aquifer systems, five groupings of principal aquifers were identified, where groups ranged from aquifer systems with high numbers of orphan wells, multiple well integrity threats and high withdrawals, to aquifers with a relatively low number of orphan wells, limited well integrity threats and minimal water use. Three regions of the country emerge containing aquifers with higher susceptibility to contamination from orphan oil and gas wells. These regions include 1) The Appalachian Basin (including the Pennsylvanian Aquifer System), 2) The Gulf Coast Aquifers (including the Coastal Lowlands Aquifer system) and 3) The California Aquifers (including the California Coastal Basin Aquifer system). This work is the first multivariate geospatial investigation of orphan wells and groundwater resources on a national scale, and sheds light on which aquifers are most susceptible to groundwater contamination from orphan wells.

Science of the Total Environment↗