Geology ReportsSearch

Geology topics

K. A. Howard

Publications and source records attributed to K. A. Howard.

At least 37 records · Page 2Linked to original sources

Correlation of the Peach Springs Tuff, a large-volume Miocene ignimbrite sheet in California and Arizona

The Peach Springs Tuff is a distinctive early Miocene ignimbrite deposit that was first recognized in western Arizona. Recent field studies and phenocryst analyses indicate that adjacent outcrops of similar tuff in the central and easten Mojave Desert may be correlative. This proposed correlation implies that outcrops of the tuff are scattered over an area of at least 35 000 km 2 from the western Colorado Plateau to Barstow, California, and that the erupted volume, allowing for posteruption crustal extension, was at least several hundred cubic kilometres. Thus, the Peach Springs Tuff may be a regional stratigraphic marker, useful for determining regional paleogeography and the time and extent of Tertiary crustal extension.

Geology

Progress report on lithium-related geologic investigations in Bolivia

The September 1, 1981, Samoa Islands Region earthquake occurred at the extreme northern end of the Tonga arc in a region where the Pacific plate may be disjointed along a hinge fault. In the last 50 years, magnitude 7 or greater earthquakes have occurred in this region on the average of once every six years, but four 7+ events have now occurred within the last six years. The mainshock was preceded about two hours earlier by a foreshock that was used as a calibration event for the Joint Epicenter Determination relocation of the mainshock and nearby seismicity occurring within a period seven months prior to and one week after the mainshock. The foreshock, better-located events of the prior seismicity, and most aftershocks are concentrated in a group near the mainshock epicenter, but several more distant aftershocks suggest that the aftershock zone may have been as large as 125 km in length and trended about S35?E. Identification of depth phases from a full suite of broadband records gives source depths of 25-3km for the mainshock and 29.5?3 km for the foreshock using a JB earth model. Source parameters were determined for the mainshock utilizing WWSSN analog and GDSN digital data. The preferred fault plane solution based on P-wave first motion data is a south by southwesterly steeply dipping normal fault, remarkably similar to the mechanism reported by Johnson and Molnar (1972) for the nearby earthquake of April 20, 196B. A waveform inversion technique described by Sipkin (1982), when applied to long-period P waveforms, gives an 'average' point source solution for a purely deviatoric moment rate tensor at a preferred source depth of 22 km. Very similar results were obtained from long-period GDSN body-wave and mantle-wave data using a centroid-moment tensor inversion technique described in Dziewonski, and others (1981). Both techniques provide solutions very close to a double couple source with a south by southwesterly shallow-dipping normal fault mechanism. To obtain the scalar mantle wave moment, GDSN vertical and transverse records 20,000 see in length were processed as described by Buland and Taggart (1981). Averaging all the data from Rayleigh and Love waves yields an estimate of 3.8 x 10^27 dyne-cm (as compared to about 1.9 x 10^27 from body-wave moment tensor inversions) or a moment magnitude (Mr) of 7.6. For the portion of the waveform analysed (50-5B sec), the body-wave inversion performed by Sipkin gives a source time function of duration approximately 28 sec with two peaks in activity. Simultaneous analysis of short-period records, and broadband ground displacements and velocities, a method described by Harvey and Choy (1982) and Choy and Boatwright (1981) revealed a complex rupture consisting of two subevents, of about the same moment, separated in time by about 25 sec, and with durations of about 25 sec each. The two peaks in activity resolved by the body-wave moment tensor inversion correspond to the first of these subevents.

Open-File Report

Geologic map of the south side of the Moon

The map of the lunar region below lat 45 ˚ S. is the sixth part of a complete geolog ic recon naissance mapping of the moon at 1:5,000,000 scale. The upper half of the map portrays the geology of the earth-facing or near side, and the lower half shows terrain that was unknown before spacecr aft photography. The near side that was well photographed at resolutions of 0.1 to 0.5 km by Lunar Orbiter IV, but coverage of the far side is uneven quality (fig. 1). The geology of a small area near the south pole that was in shadow during the Orbiter missions can be partly inferred from the nature of adjacent units.

IMAP

Flows of impact melt at lunar crater

Lavalike materials that were emplaced in a fluid state occur in and around lunar impact craters whose diameters range from 3 km to more than 200 km and whose ages span a time interval of at least 3.5 b.y. Evidence of fluid emplacement includes flow lobes and leveed channels, a veneer mantling rough crater topography, level-surfaced pools, and complex contraction fissuring. The distribution of the lavalike deposits conforms to asymmetries of other ejecta from the same craters, and the material is concentrated downrange to distances as great as a crater radius. The character and distribution of the lavalike materials support the idea that they formed by impact melting rather than by volcanism. Returned samples indicate that materials with appropriate physical characteristics are generated by partial melting of feldspathic rocks by impact. The geologic evidence at lunar craters suggests that there is more melt rock in and near the craters than is predicted by experiment and theory.

Journal of Research of the U.S. Geological Survey

Lunar highlands volcanism implications from Luna 20 and Apollo 16

Highlands materials sampled at the Apollo 16 and Luna 20 sites represent units of distinctive morphology that are widespread on the lunar nearside. Samples from the Apollo 16 site represent hilly and furrowed materials of the Descartes highlands and Cayley Formation. Materials were collected by Luna 20 from terrain resembling the Descartes terrain. Most photogeologic interpretations of these units favored volcanic origins, but the samples fail to support this interpretation. Luna 20 soil fragments are mainly glassy microbreccia with lithic inclusions of fine-grained hornfels; less than 3 percent of the fragments have textures of volcanic rocks, and most of these are likely crystalline products of impact melting. Apollo 16 soils formed on ejecta derived from a plutonic anorthosite-norite-troctolite suite. The similarity of Luna 20 soils indicates that these too formed as regolith on ejecta of anorthosite-norite-troctolitc composition. Interpretation of the samples from the two locations now suggests that hilly and furrowed terrains, previously thought to be of volcanic origin, are impact ejecta; in view of the plutonic nature of the source rocks and their extensive fusion and metamorphism, it is likely that the ejecta were derived from multiring basins. At one point, the Apollo 16 site, the Cayley Formation is composed of basin ejecta.

Journal of Research of the U.S. Geological Survey

Avalanche mode of motion: Implications from lunar examples

A large avalanche (21 square kilometers) at the Apollo 17 landing site moved out several kilometers over flat ground beyond its source slope. If not triggered by impacts, then it was as "efficient" as terrestrial avalanches attributed to air-cushion sliding. Evidently lunar avalanches are able to flow despite the lack of lubricating or cushioning fluid.

Science

Preliminary geologic investigation of the Apollo 17 landing site

The Apollo 17 lunar module (LM) landed on the flat floor of a deep valley that embays the mountainous highlands at the eastern rim of the Serenitatis basin. Serenitatis, the site of a pronounced mascon, is one of the major multi-ringed basins on the near side of the Moon. The Taurus-Littrow valley, which is radial to the Serenitatis basis, is interpreted as a deep graben formed by structural adjustment of lunar crustal material to the Serenitatis impact.

Book chapter