Geology ReportsSearch

Geology topics

Juris Meija

Publications and source records attributed to Juris Meija.

8 recordsLinked to original sources

Stable isotope reference materials and scale definitions – Outcomes of the 2024 IAEA experts meeting

The participants of the 12 th International Atomic Energy Agency (IAEA) meeting on stable isotope reference materials reached a consensus, acknowledging the existence and use of two carbon isotope delta scales: the VPDB (Vienna Peedee belemnite) scale and the VPDB-LSVEC (LSVEC - lithium carbonate prepared by H. J. Svec). Conversion models between the two scales can be established and used but introduce uncertainty. A format for isotope delta scale definition was agreed upon and was used to define the two carbon isotope delta scales and the two main oxygen isotope delta scales, VSMOW-SLAP (Vienna Standard Mean Ocean Water–Standard Light Antarctic Precipitation) and VPDB. Confirmation or identification of a second-scale–defining point is still necessary for the nitrogen and sulfur isotope delta scales. Efforts are encouraged to improve consistency among laboratories in the isotopic analysis of “non-exchangeable hydrogen” in bulk organic materials and oxygen in carbonates using the phosphoric acid reaction. Additional topics discussed include (1) need for improvement in reference materials for accurate greenhouse gas isotopic analyses; (2) reference materials under production by the IAEA, the US Geological Survey (USGS), and the US National Institute of Standards and Technology (NIST); (3) methods for value and uncertainty assignment of reference materials; and (4) calculation of carbon-13 isotope delta and oxygen-18 isotope delta of CO 2 measured by dual-inlet isotope ratio mass spectrometry.

Rapid Communications in Mass Spectrometry

Minimum requirements for publishing hydrogen, carbon, nitrogen, oxygen and sulfur stable-isotope delta results (IUPAC Technical Report)

Stable hydrogen, carbon, nitrogen, oxygen and sulfur (HCNOS) isotope compositions expressed as isotope-delta values are typically reported relative to international standards such as Vienna Standard Mean Ocean Water (VSMOW), Vienna Peedee belemnite (VPDB) or Vienna Cañon Diablo Troilite (VCDT). These international standards are chosen by convention and the calibration methods used to realise them in practice undergo occasional changes. To ensure longevity and reusability of published data, a comprehensive description of (1) analytical procedure, (2) traceability, (3) data processing, and (4) uncertainty evaluation is required. Following earlier International Union of Pure and Applied Chemistry documents on terminology and notations, this paper proposes minimum requirements for publishing HCNOS stable-isotope delta results. Each of the requirements are presented with illustrative examples.

Pure and Applied Chemistry

Standard atomic weights of the elements 2021 (IUPAC Technical Report)

Following the reviews of atomic-weight determinations and other cognate data in 2015, 2017, 2019 and 2021, the IUPAC (International Union of Pure and Applied Chemistry) Commission on Isotopic Abundances and Atomic Weights (CIAAW) reports changes of standard atomic weights. The symbol A r °(E) was selected for standard atomic weight of an element to distinguish it from the atomic weight of an element E in a specific substance P, designated A r (E, P). The CIAAW has changed the values of the standard atomic weights of five elements based on recent determinations of terrestrial isotopic abundances: Ar (argon): from 39.948 ± 0.001 to [39.792, 39.963] Hf (hafnium): from 178.49 ± 0.02 to 178.486 ± 0.006 Ir (iridium): from 192.217 ± 0.003 to 192.217 ± 0.002 Pb (lead): from 207.2 ± 0.1 to [206.14, 207.94] Yb (ytterbium): from 173.054 ± 0.005 to 173.045 ± 0.010 The standard atomic weight of argon and lead have changed to an interval to reflect that the natural variation in isotopic composition exceeds the measurement uncertainty of A r (Ar) and A r (Pb) in a specific substance. The standard atomic weights and/or the uncertainties of fourteen elements have been changed based on the Atomic Mass Evaluations 2016 and 2020 accomplished under the auspices of the International Union of Pure and Applied Physics (IUPAP). A r ° of Ho, Tb, Tm and Y were changed in 2017 and again updated in 2021: Al (aluminium), 2017: from 26.981 5385 ± 0.000 0007 to 26.981 5384 ± 0.000 0003 Au (gold), 2017: from 196.966 569 ± 0.000 005 to 196.966 570 ± 0.000 004 Co (cobalt), 2017: from 58.933 194 ± 0.000 004 to 58.933 194 ± 0.000 003 F (fluorine), 2021: from 18.998 403 163 ± 0.000 000 006 to 18.998 403 162 ± 0.000 000 005 (Ho (holmium), 2017: from 164.930 33 ± 0.000 02 to 164.930 328 ± 0.000 007) Ho (holmium), 2021: from 164.930 328 ± 0.000 007 to 164.930 329 ± 0.000 005 Mn (manganese), 2017: from 54.938 044 ± 0.000 003 to 54.938 043 ± 0.000 002 Nb (niobium), 2017: from 92.906 37 ± 0.000 02 to 92.906 37 ± 0.000 01 Pa (protactinium), 2017: from 231.035 88 ± 0.000 02 to 231.035 88 ± 0.000 01 Pr (praseodymium), 2017: from 140.907 66 ± 0.000 02 to 140.907 66 ± 0.000 01 Rh (rhodium), 2017: from 102.905 50 ± 0.000 02 to 102.905 49 ± 0.000 02 Sc (scandium), 2021: from 44.955 908 ± 0.000 005 to 44.955 907 ± 0.000 004 (Tb (terbium), 2017: from 158.925 35 ± 0.000 02 to 158.925 354 ± 0.000 008) Tb (terbium), 2021: from 158.925 354 ± 0.000 008 to 158.925 354 ± 0.000 007 (Tm (thulium), 2017: from 168.934 22 ± 0.000 02 to 168.934 218 ± 0.000 006) Tm (thulium), 2021: from 168.934 218 ± 0.000 006 to 168.934 219 ± 0.000 005 (Y (yttrium), 2017: from 88.905 84 ± 0.000 02 to 88.905 84 ± 0.000 01) Y (yttrium), 2021: from 88.905 84 ± 0.000 01 to 88.905 838 ± 0.000 002

Pure and Applied Chemistry

Final report on pilot study CCQM-P211: Carbon isotope delta measurements of vanillin

This pilot study was conducted in parallel to the key comparison CCQM-K167. Vials containing 0.25 mg of vanillin were prepared at NRC and distributed to four participating institutes. Institutes could choose any suitable reference materials and methodology to perform carbon isotope delta measurements. Participants reported analysis details, and a carbon isotope delta value and associated uncertainty for the vanillin sample. Each of the carbon isotope delta results of vanillin were compared to the KCRV established from CCQM-K167, and metrological compatibility to the KCRV was determined. Three expert laboratories participated in this study, and their reported results serve as a benchmark to compare the performance of all other participants to these world-class institutes.

Metrologia

Atomic weights of the elements 2013 (IUPAC Technical Report)

The biennial review of atomic-weight determinations and other cognate data has resulted in changes for the standard atomic weights of 19 elements. The standard atomic weights of four elements have been revised based on recent determinations of isotopic abundances in natural terrestrial materials: cadmium to 112.414(4) from 112.411(8), molybdenum to 95.95(1) from 95.96(2), selenium to 78.971(8) from 78.96(3), and thorium to 232.0377(4) from 232.038 06(2). The Commission on Isotopic Abundances and Atomic Weights (ciaaw.org) also revised the standard atomic weights of fifteen elements based on the 2012 Atomic Mass Evaluation: aluminium (aluminum) to 26.981 5385(7) from 26.981 5386(8), arsenic to 74.921 595(6) from 74.921 60(2), beryllium to 9.012 1831(5) from 9.012 182(3), caesium (cesium) to 132.905 451 96(6) from 132.905 4519(2), cobalt to 58.933 194(4) from 58.933 195(5), fluorine to 18.998 403 163(6) from 18.998 4032(5), gold to 196.966 569(5) from 196.966 569(4), holmium to 164.930 33(2) from 164.930 32(2), manganese to 54.938 044(3) from 54.938 045(5), niobium to 92.906 37(2) from 92.906 38(2), phosphorus to 30.973 761 998(5) from 30.973 762(2), praseodymium to 140.907 66(2) from 140.907 65(2), scandium to 44.955 908(5) from 44.955 912(6), thulium to 168.934 22(2) from 168.934 21(2), and yttrium to 88.905 84(2) from 88.905 85(2). The Commission also recommends the standard value for the natural terrestrial uranium isotope ratio, N ( 238 U)/ N ( 235 U)=137.8(1).

Pure and Applied Chemistry

Isotopic compositions of the elements 2013 (IUPAC Technical Report)

The Commission on Isotopic Abundances and Atomic Weights (ciaaw.org) of the International Union of Pure and Applied Chemistry (iupac.org) has revised the Table of Isotopic Compositions of the Elements (TICE). The update involved a critical evaluation of the recent published literature. The new TICE 2013 includes evaluated data from the “best measurement” of the isotopic abundances in a single sample, along with a set of representative isotopic abundances and uncertainties that accommodate known variations in normal terrestrial materials.

Pure and Applied Chemistry

Atomic weights of the elements 2011 (IUPAC Technical Report)

The biennial review of atomic-weight determinations and other cognate data has resulted in changes for the standard atomic weights of five elements. The atomic weight of bromine has changed from 79.904(1) to the interval [79.901, 79.907], germanium from 72.63(1) to 72.630(8), indium from 114.818(3) to 114.818(1), magnesium from 24.3050(6) to the interval [24.304, 24.307], and mercury from 200.59(2) to 200.592(3). For bromine and magnesium, assignment of intervals for the new standard atomic weights reflects the common occurrence of variations in the atomic weights of those elements in normal terrestrial materials.

Pure and Applied Chemistry