Geology topics

Joann Dixon

Publications and source records attributed to Joann Dixon.

4 recordsLinked to original sources

USGS2012

Evaluation of effects of changes in canal management and precipitation patterns on salinity in Biscayne Bay, Florida, using an integrated surface-water/groundwater model

Biscayne National Park, located in Biscayne Bay in southeast Florida, is one of the largest marine parks in the country and sustains a large natural marine fishery where numerous threatened and endangered species reproduce. In recent years, the bay has experienced hypersaline conditions (salinity greater than 35 practical salinity units) of increasing magnitude and duration. Hypersalinity events were particularly pronounced during April to August 2004 in nearshore areas along the southern and middle parts of the bay. Prolonged hypersaline conditions can cause degradation of water quality and permanent damage to, or loss of, brackish nursery habitats for multiple species of fish and crustaceans as well as damage to certain types of seagrasses that are not tolerant of extreme changes in salinity. To evaluate the factors that contribute to hypersalinity events and to test the effects of possible changes in precipitation patterns and canal flows into Biscayne Bay on salinity in the bay, the U.S. Geological Survey constructed a coupled surface-water/groundwater numerical flow model. The model is designed to account for freshwater flows into Biscayne Bay through the canal system, leakage of salty bay water into the underlying Biscayne aquifer, discharge of fresh and salty groundwater from the Biscayne aquifer into the bay, direct effects of precipitation on bay salinity, indirect effects of precipitation on recharge to the Biscayne aquifer, direct effects of evapotranspiration (ET) on bay salinity, indirect effects of ET on recharge to the Biscayne aquifer, and maintenance of mass balance of both water and solute. The model was constructed using the Flow and Transport in a Linked Overland/Aquifer Density Dependent System (FTLOADDS) simulator, version 3.3, which couples the two-dimensional, surface-water flow and solute-transport simulator SWIFT2D with the density-dependent, groundwater flow an solute-transport simulator SEAWAT. The model was calibrated by a trial-and-error method to fit observed groundwater heads, estimated base flow, and measured bay salinity and temperatures from 1996 to 2004, as well as the location of the freshwater-saltwater interface in the aquifer, by adjusting ET rate limiters, canal vertical hydraulic conductance, leakage rate coefficients (transition-layer thickness and hydraulic conductivity), Manning's n value, and delineation of rainfall zones. Although flow budget calculations indicate that precipitation, ET, and groundwater flux into the bay represent a small portion of the overall budget, these factors may be important in controlling salinity in some parts of the bay, for example the southern parts of the bay where the canal system is not extensively developed or controlled. The balance of precipitation and ET during the wet season generally results in a reduction of bay salinity, whereas the balance of precipitation and ET during the dry season generally results in an increase in bay salinity. During years when wet season precipitation is lower than average, for example less than 70 percent total precipitation for an average year, ET could outweigh precipitation over the bay for essentially the entire year. Hypersaline conditions are prone to occur near the end of the dry season because precipitation rates are generally lower, canal discharge rates (which are strongly correlated to precipitation rates) are also generally lower, and ET rates are higher than during the rest of the year. The hypersalinity event of 2004 followed several years of relatively low precipitation and correspondingly reduced canal structure releases and was unusually extensive, continuing into July. Thus, hypersalinity is ultimately the result of a cumulative deficit of precipitation. The model was used to test the effects of possible changes in canal flux and precipitation. Simulation results showed that by increasing, reducing, or modifying canal discharge rates, the effects on salinity in the bay were more pronounced in the northern part of the bay where there are more canals and canal-control structures. By doubling and halving precipitation, the effects on bay salinity were more pronounced in the southern part of the bay than in the northern part of the bay where there are fewer canals and canal-control structures. The model is designed to quantify factors that contribute to hypersaline conditions in Biscayne Bay and may be less appropriate for addressing other issues or examining conditions substantially different from those described in this report. Model results must be interpreted in light of model limitations, which include representation of the system and conceptual model, uncertainty in physical properties used to describe the system or processes, the scale and discretization of the system, and representation of the boundary conditions.

Florida↗

USGS2005

Impact of anthropogenic development on coastal ground-water hydrology in southeastern Florida, 1900-2000

Southeastern Florida is an area that has been subject to widely conflicting anthropogenic stress to the Everglades and coastal ecosystems. This stress is a direct consequence of the 20th century economic competition for limited land and water resources needed to satisfy agricultural development and its expansion, its displacement by burgeoning urban development, and the accompanying growth of the limestone mining industry. The development of a highly controlled water-management system designed to reclaim land for urban and agricultural development has severely impacted the extent, character, and vitality of the historic Everglades and coastal ecosystems. An extensive conveyance system of canals, levees, impoundments, surface- water control structures, and numerous municipal well fields are used to sustain the present-day Everglades hydrologic system, prevent overland flow from moving eastward and flooding urban and agricultural areas, maintain water levels to prevent saltwater intrusion, and provide an adequate water supply. Extractive mining activities expanded considerably in the latter part of the 20th century, largely in response to urban construction needs. Much of the present-day urban-agricultural corridor of southeastern Florida lies within an area that is no more than 15 feet above NGVD 1929 and formerly characterized by freshwater marsh, upland, and saline coastal wetland ecosystems. Miami- Dade, Broward, and Palm Beach Counties have experienced explosive population growth, increasing from less than 4,000 inhabitants in 1900 to more than 5 million in 2000. Ground-water use, the principal source of municipal supply, has increased from about 65 Mgal/d (million gallons per day) obtained from 3 well fields in 1930 to more than 770 Mgal/d obtained from 65 well fields in 1995. Water use for agricultural supply increased from 505 Mgal/d in 1953 to nearly 1,150 Mgal/d in 1988, but has since declined to 764 Mgal/d in 1995, partly as a result of displacement of the agricultural industry by urban growth. Present-day agricultural supplies are obtained largely from surface-water sources in Palm Beach County and ground-water sources in Miami-Dade County, whereas Broward County agricultural growers have been largely displaced. The construction of a complex canal drainage system and large well fields has substantially altered the surface- and ground-water hydrologic systems. The drainage system constructed between 1910 and 1928 mostly failed to transport flood flows, however, and exacerbated periods of low rainfall and drought by overdraining the surficial aquifer system. Following completion of the 1930s Hoover Dike levee system that was designed to reduce Lake Okeechobee flood flows, the Central and Southern Florida Flood Control Project initiated the restructure of the existing conveyance system in 1948 through canal expansion, construction of protective levees and control structures, and greater management of ground-water levels in the surficial aquifer system. Gated canal control structures discharge excess surface water during the wet season and remain closed during the dry season to induce recharge by canal seepage and well withdrawals. Management of surface water through canal systems has successfully maintained lower ground-water levels inland to curb urban and agricultural flooding, and has been used to increase ground-water levels near the coast to impede saltwater intrusion. Coastal discharge, however, appears to have declined, due in part to water being rerouted to secondary canals, and to induced recharge to the surficial aquifer system by large municipal withdrawals. Southeastern Florida is underlain by Holocene- to Tertiary-age karstic limestone deposits that form (in descending order): a highly prolific surficial aquifer system, a poorly permeable intermediate confining system, and a permeable Floridan aquifer system. Prior to construction of a complex drainage netwo

Florida↗

USGS2001

Approach for delineation of contributing areas and zones of transport to selected public-supply wells using a regional ground-water flow model, Palm Beach County, Florida

Rapid urban development and population growth in Palm Beach County, Florida, have been accompanied with the need for additional freshwater withdrawals from the surficial aquifer system. To maintain water quality, County officials protect capture areas and determine zones of transport of municipal supply wells. A multistep process was used to help automate the delineation of wellhead protection areas. A modular ground-water flow model (MODFLOW) Telescopic Mesh Refinement program (MODTMR) was used to construct an embedded flow model and combined with particle tracking to delineate zones of transport to supply wells; model output was coupled with a geographic information system. An embedded flow MODFLOW model was constructed using input and output file data from a preexisting three-dimensional, calibrated model of the surficial aquifer system. Three graphical user interfaces for use with the geographic information software, ArcView, were developed to enhance the telescopic mesh refinement process. These interfaces include AvMODTMR for use with MODTMR; AvHDRD to build MODFLOW river and drain input files from dynamically segmented linear (canals) data sets; and AvWELL Refiner, an interface designed to examine and convert well coverage spatial data layers to a MODFLOW Well package input file. MODPATH (the U.S. Geological Survey particle-tracking postprocessing program) and MODTOOLS (the set of U.S. Geological Survey computer programs to translate MODFLOW and MODPATH output to a geographic information system) were used to map zones of transport. A steady-state, five-layer model of the Boca Raton area was created using the telescopic mesh refinement process and calibrated to average conditions during January 1989 to June 1990. A sensitivity analysis of various model parameters indicates that the model is most sensitive to changes in recharge rates, hydraulic conductivity for layer 1, and leakance for layers 3 and 4 (Biscayne aquifer). Recharge (58 percent); river (canal) leakance (29 percent); and inflow through the northern, western, and southern prescribed flux model boundaries (10 percent) represent the major inflow components. Principal outflow components in the Boca Raton well field area include well discharge (56 percent), river (canal) leakance (27 percent), and water that discharges along the coast (10 percent). A particle-tracking analysis using MODPATH was conducted to better understand well-field ground-water flow patterns and time of travel. MODTOOLS was used to construct zones-of-transport spatial data for municipal supply wells. Porosity estimates were uniformly increased to study the effect of porosity on zones of transport. Where porosity was increased, the size of the zones of transport were shown to decrease.

Water-Resources Investigations Report↗

USGS1996

Description and field analysis of a coupled ground-water/surface-water flow model (MODFLOW/BRANCH) with modifications for structures and wetlands in southern Dade County, Florida

A coupled surface-water model (BRANCH) and ground-water model (MODFLOW) model were tested to simulate the interacting wetlands/surface-water/ ground-water system of southern Dade County. Several options created for the MODFLOW ground- ground-water model were used in representing this field situation. The primary option is the MODBRANCH interfacing software, which allows leakage to be accounted for between the MODFLOW ground-water model and the BRANCH dynamic model for simulation of flow in an interconnected network of open channels. A modification to an existing software routine, which is referred to as BCF2, allows cells in MODFLOW to rewet when dry--a requirement in representing the seasonal wetlands in Dade County. A companion to BCF2 is the modified evapotranspiration routine EVT2. The EVT2 routine changes the cells where evapotranspiration occurs, depending on which cells are wet. The Streamlink package represents direct connections between the canals and wetlands at locations where canals open directly into overland flow. Within the BRANCH model, the capability to represent the numerous hydraulic structures, gated spillways, gated culverts, and pumps was added. The application of these modifications to model surface-water/ground-water interactions in southern Dade County demonstrated the usefulness of the coupled MODFLOW/BRANCH model. Ground-water and surface-water flows are both simulated with dynamic models. Flow exchange between models, intermittent wetting and drying, evapotranspiration, and hydraulic structure operations are all represented appropriately. Comparison was made with a simulation using the RIV1 package instead of MODBRANCH to represent the canals. RIV1 represents the canals by user-defined stages, and computes leakage to the aquifer. Greater accuracy in reproducing measured ground- water heads was achieved with MODBRANCH, which also computes dynamic flow conditions in the canals, unlike RIV1. The surface-water integrated flow and transport two-dimensional model (SWIFT2D) was also applied to the southeastern coastal wetlands for comparison with the wetlands flow approximation made in MODFLOW. MODFLOW simulates the wetlands as a highly conductive upper layer of the aquifer, whereas SWIFT2D solves the hydrodynamic equations. Comparison in this limited test demonstrated no specific advantage for either method of representation. However, much additional testing on a wider variety of geometric and hydraulic situations, such as in areas with greater tidal or other dynamic forcing effects, is needed to make definite conclusions. A submodel of the existing southern Dade County model schematization was used to examine water-delivery alternatives proposed by the U.S. Army Corps of Engineers. For this application, the coupled MODFLOW/BRANCH model was used as a design tool. A new canal and several pumps to be tested to maintain lower water levels in a residential area (while water levels in the Everglades are raised) were added to the model schematization. The pumps were assumed to have infinite supply capacity in the model so that their maximum pumping rates during the simulation could be used to determine pump sizes.

Water-Resources Investigations Report↗