Geology topics

Janet R. Schaefer

Publications and source records attributed to Janet R. Schaefer.

5 recordsLinked to original sources

USGS2017

2014 volcanic activity in Alaska: Summary of events and response of the Alaska Volcano Observatory

The Alaska Volcano Observatory (AVO) responded to eruptions, possible eruptions, volcanic unrest or suspected unrest, and seismic events at 18 volcanic centers in Alaska during 2014. The most notable volcanic activity consisted of intermittent ash eruptions from long-active Cleveland and Shishaldin Volcanoes in the Aleutian Islands, and two eruptive episodes at Pavlof Volcano on the Alaska Peninsula. Semisopochnoi and Akutan volcanoes had seismic swarms, both likely the result of magmatic intrusion. The AVO also installed seismometers and infrasound instruments at Mount Cleveland during 2014.

Alaska↗

USGS2016

Water-magma interaction and plume processes in the 2008 Okmok eruption, Alaska

Eruptions of similar explosivity can have divergent effects on the surroundings due to differences in the behavior of the tephra in the eruption column and atmosphere. Okmok volcano, located on Umnak Island in the eastern Aleutian Islands, erupted explosively between 12 July and 19 August 2008. The basaltic andesitic eruption ejected &sim;0.24 km 3 dense rock equivalent (DRE) of tephra, primarily directed to the northeast of the vent area. The first 4 h of the eruption produced dominantly coarse-grained tephra, but the following 5 wk of the eruption deposited almost exclusively ash, much of it very fine and deposited as ash pellets and ashy rain and mist. Meteorological storms combined with abundant plume water to efficiently scrub ash from the eruption column, with a rapid decrease in deposit thickness with distance from the vent. Grain-size analysis shows that the modes (although not their relative proportions) are very constant throughout the deposit, implying that the fragmentation mechanisms did not vary much. Grain-shape features consistent with molten fuel-coolant interaction are common. Surface and groundwater drainage into the vents provided the water for phreatomagmatic fragmentation. The available water (water that could reach the vent area during the eruption) was &sim;2.8 × 10 10 kg, and the erupted magma totaled &sim;7 × 10 11 kg, which yield an overall water:magma mass ratio of &sim;0.04, but much of the water was not interactive. Although magma flux dropped from 1 × 10 7 kg/s during the initial 4 h to 1.8 × 10 5 kg/s for the remainder of the eruption, most of the erupted material was ejected during the lower-mass-flux period due to its much greater length, and this tephra was dominantly deposited within 10 km downwind of the vent. This highlights the importance of ash scrubbing in the evaluation of hazards from explosive eruptions.

Alaska↗

USGS2015

The 2008 phreatomagmatic eruption of Okmok volcano, Aleutian Islands, Alaska: Chronology, deposits, and landform changes

Okmok volcano, Aleutian Islands, Alaska, explosively erupted over a five-week period between July 12 and August 23, 2008. The eruption was predominantly phreatomagmatic, producing fine-grained tephra that covered most of northeastern Umnak Island. The eruption had a maximum Volcanic Explosivity Index (VEI) of 4, with eruption column heights up to 16 km during the opening phase. Several craters and a master tuff cone formed in the caldera as a result of phreatomagmatic explosions and accumulated tephra-fall and surge deposits. Ascending magma continuously interacted with an extensive shallow groundwater table in the caldera, resulting in the phreatomagmatic character of the eruption. Syneruptive explosion and collapse processes enlarged a pre-existing lake, created a second, entirely new lake, and formed new, deep craters. A field of ephemeral collapse pits and collapse escarpments formed where rapid groundwater withdrawal removed material from beneath capping lava flows. This was the first significant phreatomagmatic event in the U.S. since the Ukinrek Maars eruption in 1977.

Alaska↗

USGS2013

Character, mass, distribution, and origin of tephra-fall deposits from the 2009 eruption of Redoubt Volcano, Alaska: highlighting the significance of particle aggregation

The 2009 eruption of Redoubt Volcano included 20 tephra-producing explosions between March 15, 2009 and April 4, 2009 (UTC). Next-Generation radar (NEXRAD) data show that plumes reached heights between 4.6 km and 19 km asl and were distributed downwind along nearly all azimuths of the volcano. Explosions lasted between < 1 and 31 min based on the signal duration at a distal seismic station (86 km). From Moderate Resolution Imaging Spectroradiometer (MODIS) imagery and field data, we estimate that over 80,000 km 2 received at least minor ash fall (> 0.8 mm thick), including communities along the Kenai Peninsula (80–100 km) and the city of Anchorage (170 km). Trace ash (< 0.8 mm) was reported as far as Fairbanks, 550 km NNE of the volcano. We estimate the total mass of tephra-fall deposits at 54.6 × 10 9 kg with a total DRE volume of 20.6 × 106 m 3 . On March 15, a small (4.6 km asl) phreatic explosion containing minor, non-juvenile ash, erupted through the summit ice cap. The first five magmatic explosions (events 1–5) occurred within a 6-hour period on March 23. Plumes rose to heights between 5.5 km and 14.9 km asl during 2- to 20-minute-duration explosions, and were dispersed mainly along a NNE trajectory. Trace ash fall was reported as far as Fairbanks. Owing to a shift in wind direction and heavy snowfall during these events, field discrimination among many of these layers was possible. All deposits comprise a volumetrically significant amount of particle aggregates, yet only event 5 deposits contain coarse clasts including glacier ice. The most voluminous tephra fall was deposited on March 24 (event 6) from a 15 minute explosion that sent a plume to 18.3 km asl, and dispersed tephra to the WNW. Within 10 km of the vent, this deposit contains 1–11 cm pumice clasts in a matrix of 1–2 mm aggregate lapilli. A small dome was presumably emplaced between March 23 and March 26 and was subsequently destroyed during 1–14 minute magmatic explosions of events 7–8 (March 26) that sent plumes between 8.2 km and 19 km asl. Ash fell along a broad swath to the ESE, covering communities along the Kenai Peninsula with up to 1 mm of ash. Proximal deposits are largely composed of aggregate lapilli of 1–2 mm with very little coarse juvenile material. Events 9–18 (March 27) sent plumes between 5.2 km and 15.5 km asl during < 1–11-minute-long explosions. Ash clouds dispersed along trajectories to the NE, ENE and N and event 17 deposited up to 1 mm of ash on upper Kenai Peninsula and Anchorage. A moderate-size dome was emplaced between March 29 and April 4 and was subsequently destroyed during event 19 on April 4 which lasted 31 min and sent ash to 15.2 km asl. The proximal deposit is principally composed of dense dome rock, unlike earlier events, indicating that event 19 was likely caused by dome failure. The cloud dispersed to the SE along a narrow trajectory and up to 1–2 mm of ash fell on the lower Kenai Peninsula. Particle size data showing a preponderance of fine ash, even in the most proximal locations, along with the abundance of aggregate lapilli documented in most samples, confirms that particle aggregation played a significant role in the 2009 eruption and induced premature fallout of fine ash.

Alaska↗

USGS2013

Summit crater lake observations, and the location, chemistry, and pH of water samples near Mount Chiginagak volcano, Alaska: 2004-2012

Mount Chiginagak is a hydrothermally active volcano on the Alaska Peninsula, approximately 170 km south–southwest of King Salmon, Alaska (fig. 1). This small stratovolcano, approximately 8 km in diameter, has erupted through Tertiary to Permian sedimentary and igneous rocks (Detterman and others, 1987). The highest peak is at an elevation of 2,135 m, and the upper ~1,000 m of the volcano are covered with snow and ice. Holocene activity consists of debris avalanches, lahars, and lava flows. Pleistocene pyroclastic flows and block-and-ash flows, interlayered with andesitic lava flows, dominate the edifice rocks on the northern and western flanks. Historical reports of activity are limited and generally describe “steaming” and “smoking” (Coats, 1950; Powers, 1958). Proximal tephra collected during recent fieldwork suggests there may have been limited Holocene explosive activity that resulted in localized ash fall. A cluster of fumaroles on the north flank, at an elevation of ~1,750 m, commonly referred to as the “north flank fumarole” have been emitting gas throughout historical time (location shown in fig. 2). The only other thermal feature at the volcano is the Mother Goose hot springs located at the base of the edifice on the northwestern flank in upper Volcano Creek, at an elevation of ~160 m (fig. 2, near sites H1, H3, and H4). Sometime between November 2004 and May 2005, a ~400-m-wide, 100-m-deep lake developed in the snow- and ice-filled summit crater of the volcano (Schaefer and others, 2008). In early May 2005, an estimated 3 million cubic meters (3×106 m3) of sulfurous, clay-rich debris and acidic water exited the crater through tunnels at the base of a glacier that breaches the south crater rim. More than 27 km downstream, these acidic flood waters reached approximately 1.3 m above normal water levels and inundated a fertile, salmon-spawning drainage, acidifying the entire water column of Mother Goose Lake from its surface waters to its maximum depth of 45 m (resulting pH ~2.9), and preventing the annual salmon run in the King Salmon River. A simultaneous release of gas and acidic aerosols from the crater caused widespread vegetation damage along the flow path. Since 2005, we have been monitoring the crater lake water that continues to flow into Mother Goose Lake by collecting surface water samples for major cation and anion analysis, measuring surface-water pH of affected drainages, and photo-documenting the condition of the summit crater lake. This report describes water sampling locations, provides a table of chemistry and pH measurements, and documents the condition of the summit crater between 2004 and 2011. In September 2013, the report was updated with results of water-chemistry samples collected in 2011 and 2012, which were added as an addendum.

Alaska↗