Geology ReportsSearch

Geology topics

James M. Biedenbach

Publications and source records attributed to James M. Biedenbach.

7 recordsLinked to original sources

Interlaboratory comparison of three sediment bioaccumulation tests

Standard bioaccumulation tests are commonly conducted using Macoma nasuta (clam), and Alitta virens (polychaete) for marine tests, and Lumbriculus variegatus (an oligochaete) for freshwater tests. Because the interlaboratory variability associated with these tests is unknown, four experienced laboratories conducted standard 28-day bioaccumulation tests with the above species using sediments contaminated with polychlorinated biphenyls (PCBs) and polycyclic aromatic hydrocarbons (PAHs). Chemical analysis of tissue samples was performed by a single laboratory. The intralaboratory variance among replicates was relatively low for PCB tissue concentrations, with coefficients of variation (CVs) ranging from 9% to 28% for all laboratories and species, with the exception of one laboratory reporting higher variability for L . variegatus (CV = 51%). Intralaboratory variance for PCB tissue concentrations was higher than interlaboratory variance for A. virens and L . variegatus , and the magnitude of difference (MOD) for laboratory means ranged from 1.4 to 2.0 across species. Intralaboratory variability was also low for lipid content, and lipid normalization of PCB and PAH body residues generally had little impact on variability. In addition to variability across bioassay laboratories, analytical variability was evaluated by different laboratories measuring the concentration of PCBs and total lipids in a subsample of tissue homogenate of sediment-exposed test organisms. Variability associated with tissue analysis was higher than bioassay laboratory variability only in tests with L . variegatus . Statistical differences between samples may be observed due to the low intralaboratory variability; however, the biological significance of these differences may be limited because the MOD is low. Considering the MOD when comparing bioaccumulation across treatments accounts for uncertainty related to inherent variability of the test in the interpretation of statistically significant results.

Massachusetts

Toxicity of sediment pore water in Puget Sound (Washington, USA): a review of spatial status and temporal trends

Data from toxicity tests of the pore water extracted from Puget Sound sediments were compiled from surveys conducted from 1997 to 2009. Tests were performed on 664 samples collected throughout all of the eight monitoring regions in the Sound, an area encompassing 2,294.1 km 2 . Tests were performed with the gametes of the Pacific purple sea urchin, Strongylocentrotus purpuratus, to measure percent fertilization success as an indicator of relative sediment quality. Data were evaluated to determine the incidence, degree of response, geographic patterns, spatial extent, and temporal changes in toxicity. This is the first survey of this kind and magnitude in Puget Sound. In the initial round of surveys of the eight regions, 40 of 381 samples were toxic for an incidence of 10.5 %. Stations classified as toxic represented an estimated total of 107.1 km 2 , equivalent to 4.7 % of the total area. Percent sea urchin fertilization ranged from >100 % of the nontoxic, negative controls to 0 %. Toxicity was most prevalent and pervasive in the industrialized harbors and lowest in the deep basins. Conditions were intermediate in deep-water passages, urban bays, and rural bays. A second round of testing in four regions and three selected urban bays was completed 5–10 years following the first round. The incidence and spatial extent of toxicity decreased in two of the regions and two of the bays and increased in the other two regions and the third bay; however, only the latter change was statistically significant. Both the incidence and spatial extent of toxicity were lower in the Sound than in most other US estuaries and marine bays.

Washington

Sediment toxicity test results for the Urban Waters Study 2010, Bellingham Bay, Washington

The Washington Department of Ecology annually determines the quality of recently deposited sediments in Puget Sound as a part of Ecology's Urban Waters Initiative. The annual sediment quality studies use the Sediment Quality Triad (SQT) approach, thus relying on measures of chemical contamination, toxicity, and benthic in-faunal effects (Chapman, 1990). Since 2002, the studies followed a rotating sampling scheme, each year sampling a different region of the greater Puget Sound Basin. During the annual studies, samples are collected in locations selected with a stratified-random design, patterned after the designs previously used in baseline surveys completed during 1997-1999 (Long and others, 2003; Wilson and Partridge, 2007). Sediment samples were collected by personnel from the Washington Department of Ecology, in June of 2010 and shipped to the U. S. Geological Survey (USGS) laboratory in Corpus Christi, Texas (not shown), where the tests were performed. Sediment pore water was extracted with a pneumatic apparatus and was stored frozen. Just before testing, water-quality measurements were made and salinity adjusted, if necessary. Tests were performed on a dilution series of each sample consisting of 100-, 50-, and 25-percent pore-water concentrations. The specific objectives of this study were to: * Extract sediment pore water from a total of 30 sediment samples from the Bellingham Bay, Washington area within a day of receipt of the samples. * Measure water-quality parameters (salinity, dissolved oxygen, pH, sulfide, and ammonia) of thawed pore-water samples before testing and adjust salinity, temperature and dissolved oxygen, if necessary, to obtain optimal ranges for the test species. * Conduct the fertilization toxicity test with pore water using sea urchin (Stronylocentrotus purpuratus) (S. purpuratus) gametes. * Perform quality control assays with reference pore water, dilution blanks and a positive control dilution series with sodium dodecyl sulfate (SDS) in conjunction with each test. * Determine which samples caused a significant decrease in percent fertilization success relative to the negative control.

Washington

Sediment pore-water toxicity test results and preliminary toxicity identification of post-landfall pore-water samples collected following the Deepwater Horizon oil release, Gulf of Mexico, 2010

Pore water from coastal beach and marsh sediments from the northern Gulf of Mexico, pre- and post-landfall of the Deepwater Horizon oil release, were collected and evaluated for toxicity with the sea urchin fertilization and embryological development assays. There were 17 pre-landfall samples and 49 post-landfall samples tested using both assays. Toxicity was determined in four pre-landfall sites and in seven post-landfall sites in one or both assays as compared to a known reference sediment pore-water sample collected in Aransas Bay, Texas. Further analysis and testing of five of the post-landfall toxic samples utilizing Toxicity Identification Evaluation techniques indicated that ammonia, and to a lesser extent metals, contributed to most, if not all, of the observed toxicity in four of the five samples. Results of one sample (MS-39) indicated evidence that ammonia, metals, and non-ionic organics were contributing to the observed toxicity.

Gulf of Mexico

Coastal circulation and sediment dynamics in Hanalei Bay, Kaua'i, Hawaii. Part III: Studies of sediment toxicity

Toxicity tests are commonly conducted as a measure of the bioavailability of toxic chemicals to biota in an environment. Chemical analyses alone are insufficient to determine whether contaminants pose a threat to biota. Porewater toxicity tests are extremely sensitive to a broad range of contaminants in marine environments and provide ecologically relevant data on sensitive life stages. The inclusion of porewater toxicity testing as an additional indicator of sediment quality provides a more comprehensive picture of contaminant effects in these sensitive habitats. In this study purple-spined sea urchin (Arbacia punctulata) fertilization and embryological development porewater toxicity tests were used to evaluate the sediments collected from the coastal environment around Hanalei Bay, Kaua’i, Hawaii. These tests have been used previously to assess the bioavailability of contaminants associated with sediments in the vicinity of coral reefs.

Hawaii

Impact of storm-water outfalls on sediment quallity in corpus Christi Bay, Texas, USA

To determine the quality of sediments and extent of contaminant impacts, a Sediment Quality Triad (SQT) study was conducted at 36 sites in the Corpus Christi Bay, Texas, USA, system. Fifteen of the 36 sites were located near storm-water outfalls, but 13 other sites (i.e., industrial and domestic outfalls, oil field–produced water discharges, and dredging activity) and eight reference sites were also evaluated. Sediment samples were collected and analyzed for physical–chemical characteristics, contaminant concentrations (metals, polycyclic aromatic hydrocarbons [PAHs], polychlorinated biphenyls [PCBs], and pesticides), toxicity (amphipod and mysid solid phase and sea urchin pore-water fertilization and embryological development tests), and a benthic index of biotic integrity (BIBI) composed of 10 independent metrics calculated for each site. This large data matrix was reduced using multivariate analysis to create new variables for each component representing overall means and containing most of the variance in the larger data set. The new variables were used to conduct the correlation analysis. Toxicity was significantly correlated with both chemistry and ecological responses, whereas no correlations between the benthic metrics and sediment chemistry were observed. Using the combined information from the SQT, four of the five most degraded sites were storm-water outfall sites. Although estuaries are naturally stressful environments because of salinity and temperature fluctuations, this ecosystem appears to have been compromised by anthropogenic influences similar to what has been observed for other heavily urbanized bay systems along the Texas and Gulf coast.

Texas

Sediment quality triad assessment survey of the Galveston Bay, Texas system

To characterize the quality of sediments at key sites in the Galveston Bay Estuary, sediment samples were collected concurrently for chemical and physical analyses, toxicity testing and an assessment of benthic community structure. Significant toxicity, as determined by the sea urchin ( Arbacia punetulata ) pore water embryological development assay, was observed at 12 of the 24 sites investigated in this study. No toxicity was observed at any of the sites with the amphipod ( Grandidierella japonica ) solid-phase test. There were a number of sites with elevated levels of trace metals and petroleum hydrocarbons. The chemistry, toxicity and benthic data were ranked by station and a scaled rank sum was calculated to facilitate comparisons among the stations. Five sites exhibited strong evidence of contaminant-induced degradation, while 15 stations showed no evidence of contaminant-induced degradation. At eight additional sites the sediment quality triad (SQT) data indicated that unmeasured chemicals or conditions were stressing the system. Contaminant impacts could be reduced or eliminated by alternative regulatory and management practices, including the restriction of produced water discharges into coastal estuaries and the use of dredge material disposal practices that minimize the reintroduction of sediment-associated contaminants to the bays.

Texas