Geology Reports⌕ Search

Geology topics

James F. Gibbs

Publications and source records attributed to James F. Gibbs.

14 recordsLinked to original sources
USGS2020

Damping values derived from surface-source, downhole-receiver measurements at 22 sites in the San Francisco Bay Area of central California and the San Fernando Valley of southern California

A method discussed in Gibbs, Boore, et al. (1994) was applied to surface‐source, downhole‐receiver recordings at 22 boreholes, in the San Francisco Bay area in central California and the San Fernando Valley of southern California, to determine the average damping ratio of shear waves over depth intervals ranging from about 10 m to as much as 245 m (at one site), with most maximum depths being between 35 and 90 m. The average damping values range from somewhat less than 1% to almost 8%, with little dependence on grain size for sites in sediments. Surprisingly, the average damping values for sites with average velocities greater than about 450    m / s "> 450 m / s 450 m/s ⁠ , including, but not limited to rock sites, are generally larger than for sites with lower average velocities. The combined effect of the higher damping and shorter travel times through the rock columns, however, leads to an effective attenuation that is generally comparable or smaller than for soil sites.

California↗
USGS2002

Borehole velocity measurements at five sites that recorded the Cape Mendocino, California earthquake of 25 April, 1992

The U.S. Geological Survey (USGS), as part of an ongoing program to acquire seismic velocity and geologic data at locations that recorded strong-ground motions during earthquakes, has investigated five sites in the Fortuna, California region (Figure 1). We selected drill sites at strong-motion stations that recorded high accelerations (Table 1) from the Cape Mendocino earthquake (M 7.0) of 25 April 1992 (Oppenheimer et al., 1993). The boreholes were drilled to a nominal depth of 95 meters (310 ft) and cased with schedule 80 pvc-casing grouted in place at each location. S-wave and P-wave data were acquired at each site using a surface source and a borehole three-component geophone. This report contains the velocity models interpreted from the borehole data and gives reference to locations and peak accelerations at the selected strong-motion stations.

California↗
USGS2001

Borehole P- and S-wave velocity at thirteen stations in Southern California

The U.S. Geological Survey (USGS), as part of a program to acquire seismic velocity data at locations of strong-ground motion in earthquakes (e.g., Gibbs et al., 2000), has investigated thirteen additional sites in the Southern California region. Of the thirteen sites, twelve are in the vicinity of Whittier, California, and one is located in San Bernardino, California. Several deployments of temporary seismographs were made after the Whittier Narrows, California earthquake of 1 October 1987 (Mueller et al., 1988). A deployment, between 2 October and 9 November 1987, was the motivation for selection of six of the drill sites. Temporary portable seismographs at Hoover School (HOO), Lincoln School (LIN), Corps of Engineers Station (NAR), Olive Junior High School (OLV), Santa Anita Golf Course (SAG), and Southwestern Academy (SWA) recorded significant aftershock data. These portable sites, with the exception of Santa Anita Golf Course, were co-sited with strong-motion recorders. Stations at HOO, Lincoln School Whittier (WLB), Saint Paul High School (STP), Alisos Adult School (EXC), Cerritos College Gymnasium (CGM), Cerritos College Physical Science Building (CPS), and Cerritos College Police Building (CPB) were part of an array of digital strong-motion stations deployed from "bedrock" in Whittier to near the deepest part of the Los Angeles basin in Norwalk. Although development and siting of this new array (partially installed at the time of this writing) was generally motivated by the Whittier Narrows earthquake, these new sites (with the exception of HOO) were not part of any Whittier Narrows aftershock deployments. A similar new digital strong-motion site was installed at the San Bernardino Fire Station during the same time frame. Velocity data were obtained to depths of about 90 meters at two sites, 30 meters at seven sites, and 18 to 25 meters at four sites. Lithology data from the analysis of cuttings and samples was obtained from the two 90-meter deep holes and from five of the shallower holes to supplement the velocity interpretation. The two 90-meter boreholes (SB1, CPB) have been instrumented with borehole seismometers for continuous monitoring of earthquake activity (Rogers et al., 1998). No drill samples or cuttings were obtained from the other six sites, but driller's logs were scanned for major changes noted there. The velocity models at those sites were interpreted using only the measured data and major changes in the driller's log as noted above. The sites are shown in Figure 1 and listed in Table 1, which gives references to information regarding the strong-motion data. Several hundred strong-motion records of the main-shock were written by this moderate size earthquake (ML = 5.9), making it important from a scientific and engineering prospective (Brady et al., 1988; Shakal et al., 1988).

California↗
USGS1994

The attenuation of seismic shear waves in quaternary alluvium in Santa Clara Valley, California

We used shear waves, generated by an air-powered source at the ground surface and recorded in a borehole, to estimate the shear-wave quality factor at strong-motion station Gilroy no. 2. We find similar values of Q using both the decay of the spectra with depth and the slope of the spectral ratio at two depths; we find no evidence of a frequency dependence of Q . The mean value of Q over the depth range 10 to 115 m is close to 10. The use of this value over the depth of the borehole and the observed travel time of 0.358 sec gives a cumulative attenuation factor t * of 0.036 sec for the upper 180 m of the Quaternary alluvium. This is comparable to the differential decay between Gilroy no. 2 and a rock site 1.9 km away (Gilroy no. 1), as measured from the decay of the high-frequency spectra of accelerograms from large earthquakes, plotted on a log-linear scale: t * = 0.05, 0.04, and 0.03 sec for the 1979 Coyote Lake, 1984 Morgan Hill, and 1989 Loma Prieta earthquakes, respectively. The similarity between the attenuations measured from the low-strain surface source and those from the larger amplitude earthquake sources suggests that increases of damping due to nonlinear wave propagation effects are limited.

California↗
USGS1994

Seismic velocities and geologic logs from boreholes at three downhole arrays in San Francisco, California

The Loma Prieta earthquake of October 17, 1989 (1704 PST), has reinforced observations made by Wood and others (1908) after the 1906 San Francisco earthquake, that poor ground conditions (soft soil) increase the likelihood of shaking damage to structures. Since 1908 many studies (for example Borcherdt, 1970, Borcherdt and Gibbs, 1976, Borcherdt and Glassmoyer, 1992) have shown that soft soils amplify seismic waves at frequencies that can be damaging to structures. Damage in the City of San Francisco from the Loma Prieta earthquake was concentrated in the Marina District, the Embarcadero, and the China Basin areas. Each of these areas, to some degree, is underlain by soft soil deposits. These concentrations of damage raise important questions regarding the amplification effects of such deposits at damaging levels of motion. Unfortunately, no strong-motion recordings were obtained in these areas during the Loma Prieta earthquake and only a limited number (< 10) have been obtained on other soft soil sites in the United States. Consequently, important questions exist regarding the response of such deposits during damaging earthquakes, especially questions regarding the nonlinear soil response. Towards developing a data set to address these important questions, borehole strong-motion arrays have been installed at three locations. These arrays consist of groups of wide-dynamic-range pore-pressure transducers and three-component accelerometers, the outputs of which are recorded digitally. The arrays are designed to provide an integrated set of data on ground shaking, liquifaction-induced ground failure, and structural response. This report describes the detailed geologic, seismic, and material-property determinations derived at each of these sites.

California↗
USGS1980

In-situ measurements of seismic velocity at 27 locations in the Los Angeles, California region

Studies conducted in the San Francisco Bay Region (Gibbs, Fumal and Borcherdt, 1980) have shown that average shear-wave velocity can be readily tied to quantitative estimates of ground motion such as ground amplification and earthquake intensity. Furthermore, when certain physical properties of the geologic materials such as texture, hardness and fracture spacing are observed during geologic mapping, a method can be used to predict shear-wave velocity from the descriptions of geologic units. By measuring shear-wave velocities in key units together with the above data, regional maps depicting the earthquake shaking hazard can be compiled. The goals of the current program are to provide shear-wave data in the Los Angeles area to compare with that in the San Francisco Bay Region where high-strain intensity data are available. Data from twenty-seven locations are summarized in this report as part of a continuing project to seismically zone the Los Angeles area.

California↗
USGS1976

Effects of local geological conditions in the San Francisco Bay region on ground motions and the intensities of the 1906 earthquake

Measurements of ground motion generated by nuclear explosions in Nevada have been completed for 99 locations in the San Francisco Bay region, California. The recordings show marked amplitude variations in the frequency band 0.25 to 3.0 Hz that are consistently related to the local geological conditions of the recording site. The average spectral amplifications observed for vertical and horizontal ground motions are, respectively: (1, 1) for granite, (1.5, 1.6) for the Franciscan Formation, (3.0, 2.7) for the Santa Clara Formation, (3.3, 4.4) for alluvium, and (3.7, 11.3) for bay mud. Spectral amplification curves define predominant ground frequencies in the band 0.25 to 3.0 E for bay mud sites and for some alluvial sites. Amplitude spectra computed from recordings of seismic background noise at 50 sites do not generally define predominant ground frequencies. The intensities ascribed to various sites in the San Francisco Bay region for the California earthquake of April 18, 1906, are strongly dependent on distance from the zone of surface faulting and the geological character of the ground. Considering only those sites (approximately one square city block in size) for which there is good evidence for the degree of ascribed intensity, the intensities for 917 sites on Franciscan rocks generally decrease with the logarithm of distance as Intensity = 2.69 - 1.90 log (Distance in kilometers). (1) For sites on other geological units, intensity increments, derived from this empirical relation, correlate strongly with the Average Horizontal Spectral Amplifications (AHSA) according to the empirical relation Intensity Increment = 0.27 + 2.70 log (AHSA). (2) Average intensity increments predicted for the various geological units are −0.3 for granite, 0.2 for the Franciscan Formation, 0.6 for the Great Valley sequence, 0.8 for the Santa Clara Formation, 1.3 for alluvium, and 2.4 for bay mud. The maximum intensity map predicted on the basis of these data delineates areas in the San Francisco Bay region of potentially high intensity for large earthquakes on either the San Andreas fault or the Hayward fault. The map provides a crude form of seismic zonation for the region and may be useful for certain general types of land-use zonation.

California↗
USGS1974

Effects of local geology on ground motion in the San Francisco Bay region, California: A continued study

Measurements of ground motion generated by nuclear explosions in Nevada have been completed for 99 locations in the San Francisco Bay region, California. The seismograms, Fourier amplitude spectra, spectral amplification curves for the signal, and the Fourier amplitude spectra of the seismic noise are presented for 60 locations. Analog amplifications, based on the maximum signal amplitude, are computed for an additional 39 locations. The recordings of the nuclear explosions show marked amplitude variations which are consistently related to the local geologic conditions of the recording site. The average spectral amplifications observed for vertical and horizontal ground motions are, respectively: (1, 1) for granite, (1.5, 1.6) for the Franciscan Formation, (2.3, 2.3), for other pre-Tertiary and Tertiary rocks, (3.0, 2.7) for the Santa Clara Formation, (3.3, 4.4) for older bay sediments, and (3.7, 11.3) for younger bay mud. Spectral amplification curves define predominant ground frequencies for younger bay mud sites and for some older bay sediment sites. The predominant frequencies for most sites were not clearly defined by the amplitude spectra computed from the seismic background noise. The intensities ascribed to various sites in the San Francisco Bay region for the California earthquake of April 18, 1906, are strongly dependent on distance from the zone of surface faulting and the geological character of the ground. Considering only those sites (approximately one square city block in size) for which there is good evidence for the degree of ascribed intensity, the intensities for 917 sites on Franciscan rocks generally decrease with the logarithm of distance as Intensity = 2.69 - 1.90 log (Distance Km). For sites on other geologic units, intensity increments, derived from this empirical rela.tion, correlate strongly with the Average Horizontal Spectral Amplifications (MISA) according to the empirical relation Intensity Increment= 0.27 + 2.70 log(AHSA). Average intensity increments predicted for various geologic units are -0.3 for granite, 0.2 for Franciscan Formation, 0.6 for other pre-Tertiary, Tertiary bedrock, 0.8 for Santa Clara Formation, 1 .3 for older bay sediments, 2.4 for younger bay mud. These empirical relations, together with detailed geologic maps, delineate areas in the San Francisco Bay region of potentially high intensity from future earthquakes on either the San Andreas fault or the Hayward fault.

California↗
USGS1972

Earthquakes in the oil field at Rangely, Colorado

Seven years of seismic data recorded at the Uinta Basin Observatory were searched for earthquakes originating near an oil field at Rangely, Colorado, located 65 km ESE of the observatory. Changes in the number of earthquakes recorded per year appear to correlate with changes in the quantity of fluid injected per year. Between November 1962 and January 1970, 976 earthquakes were detected near the oil field by the UBO station; 320 earthquakes were larger than magnitude 1. Richter magnitudes are estimated from both S-wave and P-wave measurements and a method based on the duration of the seismic signal is used to estimate the magnitude of the larger shocks. The two largest shocks had magnitudes of 3.4 and 3.3. The total seismic energy released was l0 l7 ergs. During this same period the energy used for water injection, measured at the wellhead, was 10 21 ergs.

Colorado↗