Geology Reports⌕ Search

Geology topics

J. W. Schmoker

Publications and source records attributed to J. W. Schmoker.

At least 55 records · Page 3Linked to original sources
USGS1986

CHARACTERIZATION OF SANDSTONE RESERVOIRS FOR ENHANCED OIL RECOVERY: THE PERMIAN UPPER MINNELUSA FORMATION, POWDER RIVER BASIN, WYOMING.

Upper Minnelusa sandstones form a complex group of reservoirs because of variations in regional setting, sedimentology, and diagenetic alteration. Structural lineaments separate the reservoirs into northern and southern zones. Production in the north is from a single pay sand, and in the south from multi-pay sands due to differential erosion on top of the Upper Minnelusa. The intercalation of eolian dune, interdune, and sabkha sandstones with marine sandstones, carbonates, and anhydrites results in significant reservoir heterogeneity. Diagenetic alterations further enhance heterogeneity, because the degree of cementation and dissolution is partly facies-related.

Conference Paper↗
USGS1982

Carbonate porosity versus depth: A predictable relation for south Florida

This study examines the porosity of limestones and dolomites in the South Florida basin. Porosity data are derived from borehole-gravity measurements and from suites of acoustic, neutron, and density logs. Both types of wire-line measurements sample large volumes of rock relative to petrographic methods and can be examined at vertical scales approaching those of aquifers and hydrocarbon reservoirs. Investigation depths range from the surface to about 18,000 ft (5,500 m) and span the transition from high-porosity near-surface carbonate sediments of Pleistocene age to much denser Mesozoic carbonate rocks with porosities of only a few percent. Carbonate porosity in the South Florida basin was affected by a variety of diagenetic processes. However, a number of factors that could complicate porosity-depth relations are of limited importance in southern Florida. The basin contains little clastic material; present depths of burial are about equal to maximum depths of burial; the influences of tectonism, geopressures, and hydrocarbon accumulations are minimal. Curves of porosity versus depth, reflecting large-scale porosity-loss processes in the subsurface, are derived for a composite carbonate section and for carbonate strata of different ages and compositions. The decrease of porosity with depth for a composite carbonate section representing a wide range of depositional environments and subsequent diagenetic histories can be characterized by the exponential function ^phgr = 41.73e -z 8197/ (ft) [^phgr = 41.73e -z 2498/ (m)], where ^phgr is the porosity (%) and z is the depth below ground level (feet or meters). Average porosity is reduced by a factor of two in a depth interval of about 5,700 ft (1,740 m). Carbonate strata of different ages that are buried to equal depths show no systematic porosity differences. This implies that the effect of time on porosity in these rocks is probably subordinate to that of burial depth. The data also show a faster than expected rate of porosity decrease with depth for rocks of Eocene age and younger. If it is assumed that the decrease in the volume of evaporites in these rocks indicates less saline pore fluids, porosity loss in shallow-water carbonates may be inversely related to the magnesium content of pore waters. Dolomite porosity is lower than limestone porosity in the near surface, but does not decrease as rapidly with depth. Below about 5,600 ft (1,700 m), dolomite is more porous than limestone. It is hypothesized that most dolomitization occurred relatively early and either reduced original porosity or selectively favored lower-porosity limestones. With continued burial, dolomite was more resistant than limestone to associated porosity-reducing effects.

Florida↗
USGS1978

Principal facts for borehole gravity stations in test well Ue 19z, exploratory drill hole PM-1, and water well 5a, Nevada Test Site, Nye County, Nevada

During field studies conducted in October 1977 and March 1978, borehole gravity surveys were completed by the U.S. Geological Survey at the Nevada Test Site in test well Ue19z, exploratory drill hole PH-1, and water well 5a. The U.S. Geological Survey-LaCoste and Romberg-1/ borehole gravity meter (McCulloh and others, 1967a; McCulloh and others, 1967b) was used in the logging program. The primary objective of this work was to obtain data for the determination of accurate in situ formation densities utilizing an instrument not significantly affected by casing, borehole rugosity, or other near-borehole conditions. This report provides a brief summary of the geology of the rock formations penetrated by drill holes Ue 19z, PH-1, and water well 5a, and tabulates the subsurface gravity data obtained in these, wells. Reduced sections of the gamma-ray logs run in PM-1 and 5a are also included.

Nevada↗